A) the current of the second winding to establish a flux of % millivber with the direction shown in the air gap? Suppose the nucleus is in the linear region and its magnetic diffusion coefficient H = H Ho = 0.002 in the international system of units is ( SI). B) Calculate the energy stored in the core magnetic field for the information in paragraph A. c) Determine the self-induction and cross-induction coefficients of the windings D) If the coil is 400 Connect the circuit to the single-phase voltage of city vi(t)=220v2 sin314t, specify the voltage of the second winding in the open circuit mode. Cross section - 25 cm2 5 cm 2A 400 1 mm 15 cm far 5 cm to 20 cm 20 cm 5 cm 5 cm

A) the current of the second winding to establish a flux of % millivber with the direction shown in the air gap? Suppose the nucleus is in the linear region and its magnetic diffusion coefficient H = H Ho = 0.002 in the international system of units is ( SI). B) Calculate the energy stored in the core magnetic field for the information in paragraph A. c) Determine the self-induction and cross-induction coefficients of the windings D) If the coil is 400 Connect the circuit to the single-phase voltage of city vi(t)=220v2 sin314t, specify the voltage of the second winding in the open circuit mode. Cross section - 25 cm2 5 cm 2A 400 1 mm 15 cm far 5 cm to 20 cm 20 cm 5 cm 5 cm

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter30: Magnetic Fields And Forces

Section: Chapter Questions

Problem 75PQ

See similar textbooks

Similar questions

The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
If electric and magnetic field strengths vary sinusoidally in time at frequency 1.00 GHz, being zero at t=0, then E=E0sin2ft. (a) When are the field strengths next equal to zero? (b) 4Jhen do they reach their most negative value? (c) How much time is needed for them to complete one cycle?
A strip of copper is placed in a uniform magnetic field of magnitude 2.5 T. The Hall electric field is measured to be 1.5103V/m (a) What is the drift speed of the conduction electrons? (b) Assuming that n =8.01028 elections per cubic meter and that the cross-sectional area of the strip is 5.0106m2 , calculate the current in the ship, (c) What is the Hall coefficient 1/nq?
A wire element has dI,IdI=JAdl=Jdv , where A and dv are the cross-sectional area and volume of the element, respectively. Use this, the Biot-Savart law, and J=nev to show that the magnetic field of a moving point charge q is given by: B=04qvrr2
Check your Understanding Themagneticfield shown below Is confined to the cylindrical region shown and is changing withtime. Identity those paths for which =EdI0 .
Consider the axial magnetic field Bv=0IR2/2(y2+R2)3/2 of the circular current loop shown below. (a) Evaluate aaBydy Also show that limaaaBydy=0I (b) Can you deduce this limit without evaluating the integral? (Hint: See the accompanying figure.)
Is B constant in magnitude for points that lie on a magnetic field line?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) Describe the three basic interactions between electricity and magnetism.
An alternator is an AC generator, so from there, we are given a car alternator which produces about 14 V peak output to charge the car's 12-V battery. If an alternator coil is 17 cm in diameter is spinning at 1200 revolutions per minute in a 0.19T magnetic field, how many turns must it have to produced a 14V peak output? I am unfamiliar with the derivations, so need someoone who can help me with understandig symbology to the values better.
A Hall effect flow probe is placed on an artery, applying a 0.100-T magnetic field across it, in a setup similar to as shown. What is the Hall emf, given the vessel’s inside diameter is 4.00 mm and the average blood velocity is 20.0 cm/s?
Directions: Answer the following problem, write the given and the solution. Calculate the Hall effect when a probe is placed on an artery, applying a 0.800-T magnetic fieldacross it, in a setup. What is the Hall emf, given the vessel’s inside diameter is 4.80 mm and theaverage blood velocity is 26.0 cm/s?
WHY does larmor frequency depend on the external magnetic field strength? I want an explanation of why.