(a) The reverse saturation current of an npn-transistor, Is = 5.0 × 10-12 mA and the commonemitter current gain B = 125. The transistor is biased at VRE = 0.615 V . Calculate IR, Icand Ig.(b) The BJT circuit is shown in Fig. 1 (b). Plot the output load line by assuming that ß = 85and VBE (on) = 0.7 V.Vcc = 15 VRc = 0.5 k2RB = 28 kQVBR = 5 V o- WVBERe = 420 2Fig. 1(b)

Answered: Image /qna-images/answer/88cf20de-012a-4b41-9af8-d119966ff035.jpg

(a) The reverse saturation current of an npn-transistor, Is = 5.0 x 10-12 mA and the common emitter current gain ß = 125. The transistor is biased at VBE = 0.615 V . Calculate Ig, Ic and Ig- (b) The BJT circuit is shown in Fig. 1 (b). Plot the output load line by assuming that ß = 85 and VRE (on) = 0.7 V. Vcc = 15 V Rc = 0.5 k2 RB = 28 kN %3D VBB =5 V o- VBE RE = 420 2 Fig. 1(b)

(a) The reverse saturation current of an npn-transistor, Is = 5.0 x 10-12 mA and the common emitter current gain ß = 125. The transistor is biased at VBE = 0.615 V . Calculate Ig, Ic and Ig- (b) The BJT circuit is shown in Fig. 1 (b). Plot the output load line by assuming that ß = 85 and VRE (on) = 0.7 V. Vcc = 15 V Rc = 0.5 k2 RB = 28 kN %3D VBB =5 V o- VBE RE = 420 2 Fig. 1(b)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

the emitter-biased small signal amplifier circuit seen.VCC= +20V, RB= 430kΩ, RC= 2kΩ, RE= 1kΩ, RL= 2.2kΩ, C1=C2= 10μF and β= 50.a. Draw the ac equivalent network circuit with re model.b. Find re using Kirchhoff’s current and voltage laws.c. Assume ro=∞ Ω and find Zi, Zo and Av.Assume that a voltage source Vs with an internal resistance Rs of 1kΩ is connected to Vi. Regarding to low frequency response,d. Find the cut-off frequency f1 due to the capacitor C1.e. Find the cut-off frequency f2 due to the capacitor C2 (assume ro=∞ Ω)
In a self-biased FET amplifier given as: VDD= 20 V , Rs=1 kW, VGSQ= -2.6 V, IDQ= 2.6 mA. transistor specifically IDSS=8 mA, Vp= -6 V, gos=25 μs. has values. When 12 mV AC voltage is applied to the transistor input, which of the following should be the Rd resistance value for the output voltage to be -24.85 mV?
4) By drawing the small signal model of the circuit given below, we can determine the total voltage and current gain values of the circuit, without the bypass capacitor on and without the bypass capacitor. Calculate separately for the two cases as it will be in the circuit (connected to the emitter end of the transistor). (β = 100, rS = 600 Ω, R1 = 27 KΩ, R2 = 4.7 KΩ, RC = 3.3 KΩ, RE = 680 Ω, RL= 15 KΩ, VCC = 10 V)
[16:36, 16.06.2021] Mücahit Sezgin: The common-emitter amplifier given in the figurein the circuit, Vcc=9V, R1=27kΩ, R2=15kΩ,RE=1.2kΩ and RC=2.2kΩ. Transistor β=100has value.[16:36, 16.06.2021] Mücahit Sezgin: a-) If it has values of Rsig=10kΩ and RL=2kΩCalculate the IE of the amplifier. b-) For small signal analysis of transistorFind the value of Rin by deriving the π-model c-) Calculate vo/vsig and io/ii.
A common emitter amplifier is given in the circuit in the figure. The current gain β of the transistor in the circuit is 50 a.For Rb = 100 kΩ and Ib = 60mA, find the currents Ic , IE and the voltage falling on the load resistor Rc. b.For Rb = 50 kΩ and Ib = 120mA, find the currents Ic,IE and the voltage falling on the load resistor Rc. c.Find the α (alpha) and γ (gamma) current gains of the transistor
Which of the following network theorems is best in analyzing the AC and DC parameters in a BJT Amplifier circuit? a.Thevenin’s Theorem b.Nodal Analysis c.Superposition Theorem d.Voltage Divider Theorem
In the circuit given in the figure, what is the voltage gain (Av) of the circuit when = 100, r0 = 40 kΩ, RB = 360 kΩ, RC = 3.3 kΩ, RE = 220 Ω, Rs = 15 kΩ and RL = 166 kΩ?NOTE-1: The output impedance r0 of the transistor will be taken into the calculations.NOTE-2: Capacitors are negligible at mid-band frequency.
The transistor is specified to have Bf in the range of 7 to 35. The load resistance is Rc = 9 ohms. The dc supply voltage is Vcc = 180V and the input voltage to the base circuit is VB = 8V. If VCE (Sat) = 1,1 V and VBE (sat) = 1,6, determine: The value of RB that results in an ODF of 4 A. 0,7514 ohm B 0,5634 ohm C. 0,5081ohm D. 1 ohm The Power loss in the Transistor A. 35,07 W B. 44,30 W c. 40,04 W D. 23,65 W
Given: Voltage Divider Bias Circuit Supply: 10Vdc to 24Vdc Load: 1000 ohms Voltage Gain: 80 to 400 Lower Cutt off Frequency: 100Hz Sinusoidal source (zero internal resistance): 50mVp-p Transistor: Si, beta=75 Base-Collector Capacitance= 8pF Base-Emitter Capacitance= 25pF Design a Single-stage Common Emitter Class A Amplifier and compute the following: a) dc load line b) hie c) midband gain d) Miller equivalent Capacitances e) upper cut off frequency
What is the voltage gain (Av) of the circuit when = 100, r0 = 40 kΩ, RB = 360 kΩ, RC = 3.3 kΩ, RE = 220 Ω, Rs = 15 kΩ and RL = 379 kΩ? NOTE-1: The output impedance r0 of the transistor will be taken into account in the calculations. NOTE-2: Capacitors are negligible at mid-band frequency.
1. Discuss the common source characteristics of the n-channel FET used. 2. From the characteristics, obtain the following parameters, Ipss, gn and V. 54 Exp.No. (8): Field Effect Transistor Characteristics 3. Check equation (1) for Vgs = (-0.4), (-0.8) V. 4. Deduce equation (2) from the definition of g,, and using equation (1). 5. Obtain the value of g, of the point Vgs = - 0.8V from the transfer characteristics, then check equations (2) and (3).
4--In the given circuit, n MOSFETs are used.Q1, Q2,….. Parameters of Qn MOS transistors Vt=1V, γ=0, λ=0,μnCox=200μA/V2 and (W/L)1=(W/L)2=….=(W/L)n=20a) VGS=?, ID=?, gm=?b) Find the input and output impedance.c) Find the voltage gain.