QUESTION 15: The following circuit shows a PMOS version of a 2-transistor MOS current source.The transistor parameters are V₁p = - 0.8 V, k'p = 100 µA/V ², and λ = 0. The transistor width-to-length ratios are (W/L)₁ = 24, (W/L)₂ = 12, and (W/L)3 = 5Determine IREF, IO, VSG₁, and VSG3.What is the largest value of R such that M₂ remains biased in the saturation region?IREF (UA)Format : 537.0006Io (μA)Format: 834.5005VSG1 = VSG2 (V)Format: 3.643VSG3 (V)Format: 2.888Largest value of R required (k)Format: 27.736V+ = 3 VIREFM₁M3M₂

Electronic, transistor operating system is very simple: it has three main wires, and currently…

QUESTION 15: The following circuit shows a PMOS version of a 2-transistor MOS current source. The transistor parameters are Vrp=-0.8 V, k'p = 100 μA/V 2, and λ = 0. The transistor width-to-length ratios are (W/L)₁ = 24, (W/L)₂ = 12, and (W/L) 3 = 5 Determine IREF, IO, VSG1, and VSG3. What is the largest value of R such that M₂ remains biased i the saturation region? IREF (UA) Format: 537.0006 Io (μA) Format: 834.5005 VSG1 = VSG2 (V) Format 3.643 VSG3 (V) Format: 2.888 Largest value of R required (k) Format: 27.736 V+ = 3 V IREF M₁ M3 M₂ R

QUESTION 15: The following circuit shows a PMOS version of a 2-transistor MOS current source. The transistor parameters are Vrp=-0.8 V, k'p = 100 μA/V 2, and λ = 0. The transistor width-to-length ratios are (W/L)₁ = 24, (W/L)₂ = 12, and (W/L) 3 = 5 Determine IREF, IO, VSG1, and VSG3. What is the largest value of R such that M₂ remains biased i the saturation region? IREF (UA) Format: 537.0006 Io (μA) Format: 834.5005 VSG1 = VSG2 (V) Format 3.643 VSG3 (V) Format: 2.888 Largest value of R required (k) Format: 27.736 V+ = 3 V IREF M₁ M3 M₂ R

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The Governate of Dhofar is densely populated that are evenly distributed over an area of 1200 km2. It is given that a percent of the populace is subscribed to a cellular system. Assuming that the cellular system is an Erlang B system with a traffic Intensity per cell of 37 Erlangs, a total band of 40 MHz and full duplex channel bandwidth of 60 kHz. The system covers the city using hexagonal cells with a diameter of 8 km and a cluster size of 7 cells. Determine the total number of cells in the system, the number of channels per cell, the total number of channels in the system and the total clusters.
a system whose closed-loop transfer function is given by G(s)=K/s(s^2+s+1)(s+2)+K derive a Routh-Hurwitz array to determine the stability of the system.
A shield that contains 10 identical apertures in a linear array is required to have30 dB of shielding effectiveness at 100 MHz. Determine the maximum lineardimension of one aperture.
Multiple Choice directions: Circle the letter of the answers 7. This is a special microwave coaxial cable used in the lower microwave bands L, S, and C. a. Flexible coaxial b. All of the above c. Hard line cable d. Braided coaxial 8. The practical microwave region is in the vicinity of a. 1-10 GHz b. 1-20 GHz c. 1-300 GHz d. 1-30 GHz 9. In a hybrid ring, if the signal is applied at port 1, which port has no output? a. 3 b. 2 c. 1 d. 4 Note: Explanation is not needed just provide the correct answers for each number.
Step 2.2 Plot the following equations: m(t) = 6cos(2π*1000Hz*t)c(t) = 3cos(2π*9kHz*t)Kvco=1000, Kp = pi/7 Question: What is your observation?a. The PM modulated signal remains unchanged since kp does not influence the PM index.b. kp only effects FM modulated signals, therefore our PM modulated signal remainsunchanged.c. kp changes and therefore the PM Index also changes. This will impact the quality of thephase modulated signal. AM and FM modulated signals do not change.d. All statements are incorrect.
A) The effective aperture of a 144.0cm-diameter parabolic reflector antenna is 6m of the physical aperture area. Compute the gain in dB at 10GHz. b) Vodafone decides to use a digital TDMA scheme that can tolerate a Signal-to-Interference Ratio of 17dB in the worst case. Find the optimal value of the path lost exponent for an omnidirectional antenna; assuming i=3 and j=2. Assume that there are six co-channel cells in the first tier, and all of them are at same distance from the mobile. Use suitable approximations. c) Draw the table of frequency assignments and system layouts for a seven-cell repeat pattern and three-sectored antenna per cell site, using E-GSM 900MHz in which the total number of channels needs to be divided, assuming that the full spectrum is available from the operator of the system is used. In the sixth (6th) cluster, list all the possible channels that will be assigned to the cells in sector B?
An Access Point in one room needs to reach a wireless station which is two rooms away. The signal must pass through 2 walls as shown in the diagram. The transmit power at the AP is 15 dBm. The distance from the AP to the wireless station is 12 meters and operation is in the 5 GHz band. The wall attenuation for each wall is 5 dB. What is the received power level at the wireless station in dBm. Enter a value without units. Truncate your answer to 1 decimal place (i.e. 5.6).
2) A current of 250mA flows through a perfect inductor, when it is connected to a 5V, 1kHz supply. Determine the inductance value? 3) A coil of inductance 400µH, and of negligible resistance, is connected to a 5kHz supply. If the current flow is 15mA, determine the supply voltage? 4) A 0.47µF capacitor is connected to a variable frequency signal generator, which provides an output voltage of 25V. Calculate the current flowing when the frequency is set to (a) 200Hz, and (b) 4kHz? 5) At what frequency will the reactance of a 22 pF capacitor be 500 Ω?
A superheterodyne receiver is to tune the range 88.1MHz to 107.1MHz. The RF circuit inductance is 1μH. Low-side injection is used.a. Calculate the minimum capacitance of the variable capacitor in the RF circuitb. Calculate the RF circuit capacitance tuning ratio c. If the receiver has a single converter stage and IF of 800kHz, calculate the capacitance tuning ratio of the local oscillator d. If the maximum capacitance of the variable capacitor of the local oscillator is 0.2pF, calculate the minimum capacitance e. If the receiver has a single converter stage and IF of 800kHz, calculate the image frequency of 103.7MHzf. Calculate the IFRR (in dB) of (e) if Q of the preselector is 50 g. To increase the IFRR of (e) to 40dB, double conversion is used. What must be the frequency of the 1st IF?
An extremely fast photodiode can be designed to achieve bandwidth of 158 GHz. Assuming that the bandwidth is limited by carrier transit time, calculate the required depletion region if the electron and hole saturation velocities = 0.85 x10^5ms-1. Express your answer in the unit of μm.
textbook: Magnetic resonance imaging, physical principles and sequence design. Problem 3.4 eq 3.33 : μx′(t) = μx′(0)μy′(t) = μy′(0) cos φ1(t) + μz′(0) sin φ1(t)μz′(t) = −μy′(0) sin φ1(t) + μz′(0) cos φ1(t) eq 2.24: d~μ/dt= γ~μ × ~B
Measure the diameters of the two wires. Given the density of steel is = 7.8×103 kg/m3, theoretically estimate fundamental frequencies of the two wires, and calculate the ratio of their frequenciesr unit length? diameters = 0.254mm and 0.432 mm