A thermal camera is used to detect heat distribution of an electrical cable which emits radiation with a peak wavelength of 4.6 μm. Which photodetector will you recommend? O Hgo.8Cd0.2Te pn photodiode O SiGe pn photodiode O InSb photodiode O Ge photoconductor O CdTe pn diode

Q: The reference angle of (3\pi )/(2)rad is (\pi )/(2)rad.

A: When the desired angle is in the third quadrant (angles from 180° to 270°), our reference angle is…

Q: 2. Emitter-Bias Configuration $250ke LIS Determine: +2DV ↓Ic 47052 Q₁ 'VCE 2.2kQ ==130 Is, Ic, VC,…

A:

Q: ( NEED ONLY HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE).Given a formula for…

A:

Q: Q13. Convolute the following: x(t) = u(t)- u(t-5), h(t) = u(t)-u(t-2).

A: X(t)=u(t)-u(t-5) h(t)=u(t)-u(t-2) We need to calculate output signal using convolution.( Graphical…

Q: In the circuit of Fig. 11.26, Z₁ = 60/-30° and Z₂ = 40/45° 0. Z, Calculate the total: (a) apparent…

A: It is given that: Z1=60∠30° ΩZ2=40∠45° Ω

Q: Calculate the frequency of the given circuit if a constant 5V source is being used as a supply…

A:

Q: What will be the voltage of a battery if a charge of 4 × 10-4 coulomb resides on the positive…

A:

Q: A function (A, B, C) defined by three boolean variables A, B, and C when expressed as the sum of…

A: Step-1-> we have the boolean expression-: F(A,B,C,D)=¯¯¯¯A.¯¯¯¯B.¯¯¯¯C+¯¯¯¯AB¯¯¯¯C+A.¯¯¯¯B.¯¯¯¯C

Q: For the circuit shown below, determine the total circuit capacitance. C₁ 2μF 2μF 2μF ||2HF 2μF 2μF…

A:

Q: 2. In what region are these bipolar junction transistors working?

A: For the given BJT circuit the region of operation of the transistor needs to be calculated based on…

Q: Q1 (i) For the circuit shown in Figure 1.1, calculate (a) the effective resistance across the source…

A:

Q: 3. Why is the resonant frequency of a resonator discrete?

A: This type of device exhibits resonant behavior. It can naturally oscillate with some greater…

Q: formation e circuit given below, where the turns ratio is 21:1. V₁ V₂ G₁ 470 μF RL 1 ΚΩ 1 le in the…

A:

Q: марл Using Karnaugh Map by step. Dengan menggunakan Peta Karnaugh (K-Map) ringkaskan persamaan di…

A:

Q: 7.17 Consider the circuit of Fig. 7.97. Find vo(t) if i(0) = 6 A and v(t) = 0. пот 20-2 st= (10-2) v…

A: We need to find out the output voltage for given circuit.

Q: Consider the decaying exponential function x (t) illustrated in Figure 10. Find the Fourier…

A:

Q: 4. v(t) = 750 cos (5000 t +30°) V (a) Find the peak value, the phase, the frequency, and the period…

A: V(t)=750cos(5000t+30°) v We need to calculate a) peak value, phase , frequency,time period of v(t)…

Q: 54. A single-turn wire loop 10 cm in diameter carries a 18 A current. It experiences a 0.019 Nm…

A: Diameter of singew wire,D= 10 cm=10×10-2 mRadius,r=5×10-2mArea, A= πr2=3.14×5×10-22=7.852×10-3…

Q: if a zener diode is placed forward bias, what would be expected forward voltage if it was on

A: Asked to explain about Zener diode  forward bias condition

Q: 2. Refer to the DC network below and find the following values: i. voltage across RI, VRI ii.…

A: For the given diode-based circuit the voltage drop across the resistor R1 needs to be calculated and…

Q: (a) (i) Provide two advantages and two disadvantages of FM. (ii) Draw the frequency spectrum of the…

A:

Q: If a 10 µF capacitor is connected to a voltage source with v(t) = 75 sin 2000t V determine the…

A: In this question We need to determine the current through the capacitor C.  We know Current through…

Q: Example 13.1. A 2-wire d.c. distributor cable AB is 2 km long and supplies loads of 100A, 150A,200A…

A: It is given that: AB=2kmI1=100 AI2=150 AI3=200 AI4=50 AL1=500 mL2=1000 mL3=1600 mL4=2000 mVA=300 V

Q: Determine the currents I₁, I2, and I3 for the electrical network shown in the figure. (Assume V₁ =…

A: For the given circuit the value of branch current needs to be calculated and the same can be…

Q: For the following circuit: 1. Find V(infinity) 2. Find an expression for v(t) at t > 0. No need to…

A: The given circuit is shown below. The source voltage is defined as 50u-t=0, t>050, t<0 Volts.

Q: Consider the triangular periodic signal f(t) illustrated in Figure 9 -A 2 (a) Figure 9 a) Determine…

A: Given: A periodic triangular wave,  To find: a) Fourier series coefficients a0, an and bn.  b)…

Q: Determine the input impedance of the circuit in Fig. 1 at w=10 rad/s.

A: In this question We need to determine the input impedance Zeq   Inductive Reactance XL = wL…

Q: 2- Given the following two-degrees of freedom translational mechanical system, use the "by…

A: The transfer function of the given mechanical translational system needs to be calculated by using…

Q: A 3500-Hz audio tone amplitude modulates a 200-kHz carrier resulting in a modulated signal having a…

A: Given Data: A modulation scheme with, Signal frequency fs=3500 Hz Carrier frequency fc=200 kHz…

Q: The bridge circuit, as shown in Fig. 1 is balanced when R₁ : 14022, R₂ = 2109, and R₂ = 29022. The…

A:

Q: + c {=} = √√, find c {√₁}. 9. Given that C (B) √ (C)/√(D) (E)

A: Given data ℒ1t=πs To find out We have to determine the ℒt.

Q: Vcc = 20 V RB = 430 kOhm RC = 1 kOhm RE = 1 kOhm VBE(ON) = 0.7 V beta = 50 VIO Find Vc. * ㅔ C1 O…

A: We need to find out the voltage at collector terminal of the given circuit.

Q: 90 V +1 10 Ω Μ t = 0 + let ν 1 F 4Η

A:

Q: Determine the mode of the flip-flop. (Answer with: Set, Clear, Hold, Prohibited or Toggle). PS Vcc…

A:

Q: Multiply out to obtain a sum of products: (a) (K' + M' + N)(K' + M)(L + M' + N')(K' + L + M)(M + N)…

A:

Q: (b) A sinusoidal information signal of frequency 800Hz is used to frequency modulate a carrier…

A:

Q: An FM transmitter has a 220 MHz carrier frequency. Its modulation index is 3 with a 5 kHz modulating…

A:

Q: - Factor to obtain a product of sums: (a) K'L'M + KM'N + KLM + LM'N' (b) KL + K'L' + L'M'N' + LMN'…

A:

Q: Problem 2. Determine Voi and Vo2 for the networks of Fig. 2. +12 Vo Si (a) 4.7 ΚΩ GaAs -10 Vo Ge Si…

A:

Q: 1. EC9Q1 Non-identical Light bulbs A and B are connected in series to a 46-Volt energy source. The…

A: In a series circuit, when multiple components are connected one after the other, the total voltage…

Q: ? By using Current Divider Rule (CDR) find i1 & i2 + 11 12

A: The circuit is given that:

Q: (1) Find the input output relation between x(t) and y(t). (ii) Prove that the system is time…

A: From the given system the relationship between the input and the output needs to be calculated and…

Q: In reference to the circuit shown below (there are no initial current or charges): (a) Set-up the…

A:

Q: A 08 4092 20 Q 7 60 52 100) V 120 (2

A: here we have to find voltage (V) from the given circuit when voltage sources are acting.

Q: 1. Fixed Bias Configuration 15V ITC 160ko 1.2k₂ Is Determine: Vor B=100 IB, IC, VCE

A: it is asked to find IB,IC, VCE for given circuit

Q: Discuss briefly the following Boolean Algebra terms and give at least five ( 5 ) examples each : a.…

A: Here asked to explain briefly about Boolean algebra and mention atleast 5 examples of a)SOP b)POS

Q: Calculate the value of V1 and V2? R VI B R + V2 C

A: Circuit diagram is given as,

Q: 20 cos(10t + 1009) (+1 0.5 Η m www 10 Ω 0 F νο |

A:

Q: The voltage across a load is v(t) = 60 cos(at 10°) V and the current through the element in the…

A: It is given that: V(t)=60cos(wt-10°) VI(t)=1.5cos(wt+50°) A

Q: a) What is the major difference between a CG FET ac amplifier and the other two FET ac amplifier…

A: Step-1-> CG FET, CS FET, and CD FET are different types of field-effect transistors (FETs) that…