A thin uniform film of refractive index 1.750 is placed on a sheet of glass of refractive index 1.50. At room temperature (20.0°C), this film is just thick enough for light with wavelength 582.4 nm reflected off the top of the film to be cancelled by light reflected from the top of the glass. After the glass is placed in an oven and slowly heated to 170°C, you find that the film cancels reflected light with wavelength 588.5 nm. What is the coefficient of linear expansion of the film? (Ignore any changes in the refractive index of the film due to the temperature change.)

A thin uniform film of refractive index 1.750 is placed on a sheet of glass of refractive index 1.50. At room temperature (20.0°C), this film is just thick enough for light with wavelength 582.4 nm reflected off the top of the film to be cancelled by light reflected from the top of the glass. After the glass is placed in an oven and slowly heated to 170°C, you find that the film cancels reflected light with wavelength 588.5 nm. What is the coefficient of linear expansion of the film? (Ignore any changes in the refractive index of the film due to the temperature change.)

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Wave Optics

Section: Chapter Questions

Problem 63P: Both sides of a uniform film that has index of refraction n and thickness d are in contact with air....

See similar textbooks

Similar questions

Both sides of a uniform film that has index of refraction n and thickness d are in contact with air. For normal incidence of light, an intensity minimum is observed in the reflected light at λ2 and an intensity maximum is observed at λ1, where λ1 > λ2. (a) Assuming no intensity minima are observed between λ1 and λ2, find an expression for the integer m in Equations 27.13 and 27.14 in terms of the wavelengths λ1 and λ2. (b) Assuming n = 1.40, λ1 = 500 nm, and λ2 = 370 nm, determine the best estimate for the thickness of the film.
A Fraunhofer diffraction pattern is produced on a screen located 1.00 m from a single slit. If a light source of wavelength 5.00 107 m is used and the distance from the center of the central bright fringe to the first dark fringe is 5.00 103 m, what is the slit width? (a) 0.010 0 mm (b) 0.100 mm (c) 0.200 mm (d) 1.00 mm (e) 0.005 00 mm
A 750 nm red light is not reflected in air by a thin film deposited on glass. If the thickness of the film is 150 nm and glass has a refractive index of 1.44, what is a possible value of the index of refraction of the thin film? 1.15 1.25 1.40 1.20
White light is sent downward onto a horizontal thin film that is sandwiched between two materials. The indexes of refraction are 1.80 for the top material, 1.70 for the thin film, and 1.50 for the bottom material. The film thickness is 5.00* 10-7 m. Of the visible wavelengths (400 to 700 nm) that result in fully constructive interference at an observer above the film, which is the (a) longer and (b) shorter wavelength? The materials and film are then heated so that the film thickness increases. (c) Does the light resulting in fully constructive interference shift toward longer or shorter wavelengths?
The light from a mercury lamp is incident on a water film of refractive index 1.33 and thickness t = 150nm which is suspended in ambient environment. At what wavelength the light reflected by film falls in a region of infrared
Plastic coatings are put in a car's glass window (n = 1.52) in order to keep the interior of cars cooler. What should be the index of refraction of the plastic film with minimum thickness of 107.5nm if you want the reflected light from both sides of the film to have no relative phase shift and to interfere destructively? The wavelength of the light in air is 600nm. I. 2.791 II. 1.395 III. 1.861IV. 1.321
Two flat plates of glass with parallel faces are on a table, one plate on the other. Each plate is 11.0 cm long and has a refractive index of 1.55. A very thin sheet of metal foil is inserted under the end of the upper plate to raise it slightly at that end. When you view the glass plates from above with reflected white light, you observe that, at 1.15 mm from the line where the sheets are in contact, the violet light of wavelength 400.0 nm is enhanced in this reflected light, but no visible light is enhanced closer to the line of contact. (a) How far from the line of contact will green light (of wavelength 550.0 nm) and orange light (of wavelength 600.0 nm) first be enhanced? (b) How far from the line of contact will the violet, green, and orange light again be enhanced in the reflected light? (c) How thick is the metal foil holding the ends of the plates apart?
assume that two waves of light in air, of wavelength 400 nm, are initially in phase. One travels through a glass layer of index of refraction n1 = 1.60 and thickness L. The other travels through an equally thick plastic layer of index of refraction n2 = 1.50. (a) What is the smallest value L should have if the waves are to end up with a phase difference of 5.65 rad? (b) If the waves arrive at some common point with the same amplitude, is their interference fully constructive, fully destructive, intermediate but closer to fully constructive, or intermediate but closer to fully destructive?
If the wavelength of a monochromatic source is 316 nm in vacuum, what is the wavelength from the same source when it passes through a liquid where the speed of light is 1.86 × 108 m/s? (c = 3.00 × 108 m/s)
White light is incident normally on a glass lens (n=1.52) that is coated with a film of MgF2 (n=1.38). For what minimum thickness of the film will the reflections at the two interfaces result in total destructive interference of yellow light of wavelength 580 nm (in air)?
A thin uniform film of refractive index 1.750 is placed on a sheet of glass with refractive index 1.50. At room temp. (21.8 C) this film is just enough for light with a wavelength 538.9 nm reflected off of the top of the film to be cancelled by light reflected by the top of the glass. After the glass is placed in an oven and slowly heated to 160 C, you find that the film cancels reflected light with a wavelength 588.9 nm. What is the coefficient of linear expansion of the film? (Ignore any changes in the refractive index of the film due to the temperature change)
Laser light of wavelength 460 nmnm is traveling in air and shines at normal incidence onto the flat end of a transparent plastic rod that has nn = 1.30. The end of the rod has a thin coating of a transparent material that has refractive index 1.75. a)What is the minimum (nonzero) thickness of the coating for which there is maximum transmission of the light into the rod? b)What is the minimum (nonzero) thickness of the coating for which transmission into the rod is minimized?