A Three-phase 440-volt motor operates with a power factor of 0.4. Two Wattmeter's are connected to measure the input power, and the total power from the mains is 30KW Find the readings of each Wattmeter Lecture and Refer-1.9 and Discussion]

A Three-phase 440-volt motor operates with a power factor of 0.4. Two Wattmeter's are connected to measure the input power, and the total power from the mains is 30KW Find the readings of each Wattmeter Lecture and Refer-1.9 and Discussion]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 3-phase, 2 HP, 220-volt induction motor has an efficiency of 0.85% and operates at 0.805% lagging power factor. It is in parallel with the three-phase resistance furnace consisting of three 32-ohm resistance connected in delta. Two wattmeters placed on lines A and B to measure the total power. If the phase sequence of the three-wire 3-phase system is A-B-C, find the reading of the wattmeter connected in line A.
A 3-phase, 50 Hz,2000 kVA, 2300 volt alternator gives a short circuit current of 600 A for a certain field excitation. For the same excitation, the open circuit voltage was 900 volts. The resistance between pair of terminals was 0.12 ohm. A)Ifthe generator is wye connected, -Determine the full load regulation at 0.80 lagging pf. -Determine the full load regulation at unity pf
Electric Machine - check image , all question there. Consider the above equivalent circuit of IM. A six pole, 230 volt(line to line), 60Hz, Y connected , three phase IM has the following on a per phase basis: R1=0.5Ω , R2=0.25 Ω, X1=0.75 Ω, X2=0.5 Ω, Xm=100 Ω, Rc=500 Ω The friction and windage loss is 150 W. Determine the following at its rated slip of 2.5% a)Total Impedance(Zt) b)Rotor Copper Loss c)Core loss(Pm) d)Shaft Power(P0) e)Efficiency
Electric Machine-check image, all question there. Consider the above equivalent circuit of IM, A six pole, 250 volt(line to line), 60Hz, Y connected , three phase IM has the following parameters on a per phase basis: R1=0.125Ω , R2=0.45 Ω, X1=0.5 Ω, X2=0.75 Ω, Xm=50 Ω, Rc=225 Ω The friction and windage loss is 115 W. Determine the following at its rated slip of 1.5% a)Excitation Circuit b)Power developed by motor(Pd) c)Shaft Power(Pshaft) d)Shaft Torque(Tshaft) e)Efficiency
Electric Machine - Check image, all question there. Consider the above equivalent circuit of IM, A six pole, 250 volt(line to line), 60Hz, Y connected , three phase IM has the following parameters on a per phase basis: R1=0.125Ω , R2=0.45 Ω, X1=0.5 Ω, X2=0.75 Ω, Xm=50 Ω, Rc=225 Ω The friction and windage loss is 115 W. Determine the following at its rated slip of 1.5% a)Excitation Circuit b)Power developed by motor c)Shaft Power(Pshaft) d)Shaft Torque(Tshaft) e)Efficiency
Question 2The electrical power supply system of a particular country is made of the following. Draw a single line diagram of the electrical power supply system of the country based on the information below using any computer-aided software. Power supply from an infinite bus bar S connected to bus bar A, through a circuit breaker connected between isolators and a three-phase delta/star solidly earthed transformer T1.Power supply source from a generator G1 connected to bus bar B through a circuit breaker connected between isolators, and a three- phase delta/star solidly earthed transformer T2. power supply sources from two generators G2 and G3. Each of the generators are connected to a reactor. Furthermore, each of the generators connected to a common bus bar C through a circuit breaker connected between isolators and a three-phase star/star solidly earthed transformer T3 and T4 respectively. bus bar F to bus bar A by means of two isolators, one at each end of transmission line L6; bus…
Two wattmeter are used for measurement of power in load test of three phase induction motor rating 5 kW, 415V star connected , 50 Hz, 1480 rpm, 0.8 pf. Draw circuit diagram and write range of wattmeters.
A three phase, 3.73 KW, 220-volt induction motor (balanced load) has an efficiency of 86% and operates at 86.6% lagging power factor. An industrial heater is connected in delta consisting of three 36-ohm resistances. Find the kVA _________________ demanded by the combination, the power factor and the line currents,Ia=___________∠_____________,Ib=___________∠_____________,Ic=___________∠_____________. Phase sequence: ABC (please answer in 3 decimal points and clear solution!)
The electrical power supply system of a particular country is made of the following. Draw asingle line diagram of the electrical power supply system of the country based on the informationbelow using any computer-aided software.Power supply from an infinite bus bar S connected to bus bar A, through a circuit breakerconnected between isolators and a three-phase delta/star solidly earthed transformer T1.Powersupply source from a generator G1 connected to bus bar B through a circuit breaker connectedbetween isolators, and a three- phase delta/star solidly earthed transformer T2. power supplysources from two generators G2 and G3. Each of the generators are connected to a reactor.Furthermore, each of the generators connected to a common bus bar C through a circuit breakerconnected between isolators and a three-phase star/star solidly earthed transformer T3 and T4respectively. bus bar F to bus bar A by means of two isolators, one at each end of transmissionline L6; bus bar A to bus bar E by…
(i) The output of the 3-phase, 435V induction motor is 13 kW and operates at power factor of 0.9 lagging with an efficiency of 81%. Calculate the reading on each of the two wattmeter connected to measure the input. The value of P1 is = Answer and unit for part 1 The value of P2 is = Answer and unit for part 2 C2 (ii) A 3-phase balanced star connected inductive coil load, each of reactance 22 ohms are connected to a 3 phase 210V, 50 Hz supply. Calculate the inductance of each coil, which when connected in delta to the same supply will take the same line current. Reactance Xc is = Answer and unit for part 3 The Inductance L = Answer and unit for part 4
A star connected three phase, 10 MVA, 6.6 kV, alternator is protected by Merz-price circulating current principle using 1000/5 amperes current transformers. The star point of the alternator is earthed through a resistance of 7.5Ω. If the min. operating current for the relay is 0.5A. Calculate the percentage of unprotected stator winding when machine is operating at normal voltage.
The loads on a 230-volt three-phase generator consist of (a) three groupsi of incandescent lamps, each group containing twenty 100 watts lamps and (b) a 9 hp motor operating at 82 percent P.Ower . factor and 87 percent efficiency. Find the total load current in amperes. Right answer is 37 pls explain soln