A three-phase induction motor develops 20 kW when running at 90% efficiency, at a power factor of 0,45 lagging. Calculate the readings on each of the two watt meters connected to read the input power.

Q: (b) Figure Q3. (b) shows a beam antenna consisting of a dipole, a reflector, and a director. Design…

A: Since the user has asked for the solution of the question 3 (b). Hence, we will solve only this…

Q: Using the 8 steps in designing a finite state machine, design a sequence detector circuit that will…

A: To design: A FSM as a sequence detector which gives output "1" when it detects the sequence, "101",…

Q: A B с 2 7432 3 1 7400 In the circuit from above, A=1, B=0, C=0, and the output X=0. X Considering…

A: Given: The logic circuit is, Inputs are A=1, B=0, C=0. Output is X=0.

Q: Determine whether the following systems are time varying or invariant, linear or non-linear systems:…

A:

Q: 3. A strain gauge has a gauge factor of 2.5 and R= 150 2. Calculate the new resistance if the…

A: Given: A strain gauge has, Gauge factor, G=2.5. Resistance, R=150 Ω. Strain, ε=0.0004.

Q: In a sequential logic circuit, the next output is based on the current input and the previous…

A: Sequential circuit A flip-flop is the basic element of the sequential circuit. It is more complex…

Q: In BJT transistor V, BE = 0.7 V and VT = 25 mV and reverse saturation current is 10-13 A. Find the…

A:

Q: c) Calculate the time constant. d) Calculate the damping coefficient.

A: Given: First order process PI controller The transfer function of Plant= GP(s)=15s+1 Kc=10    τi=0.5…

Q: Explain the detection process in the p–n photodiode. Compare this device with the p–i–n photodiode.

A: We have to explain the detection process in the p–n photodiode and we have to compare this device…

Q: Q3 \ Is a function generator DC or AC? Q41 What is the difference between function generator and…

A: Types of commonly used signal from function generator  Sinusoidal signal Triangular signal Sawtooth…

Q: Write Define A,B,C,D

A:

Q: Q31 Is a function generator DC or AC? Q41 What is the difference between function generator and…

A: As per guidelines given to us we can only provide the solution of first question in multiple type of…

Q: Question The single-phase ac voltage controller has a 120-V rms 60-Hz source. The load resistance is…

A: it is asked to find the power factor for given question and also asked to draw single phase and 3…

Q: 3. Calculate the output voltage developed by the circuit of the for opposite figure R=68 k2, 330…

A: Types of op-amp Inverting Op-amp Non-inverting Op-amp  The Ideal operational amplifier is an…

Q: 2. a) Sketch vo for the given network (Your calculations are needed) R₁ = 100 S2, R₂ = 100 kn, V₁ =…

A:

Q: In the circuit from below, switch A is closed, switch B is open and the lamp C is off. Is there any…

A: Given: The circuit is, Switch A is closed, Switch B is open and lamp C is off.

Q: Q1. For the electrical circuit shown in Fig.1, use the superposition principal to calculate the…

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: 1. Consider the phase-shift oscillator shown in the below figure with parameters R = 4k and C =…

A:

Q: What function do you use to output an analog voltage from a digital pin?

A: The Digital pin in particular gives digital output. i.e. either logic high or logic low.  So we…

Q: Find the attenuation constant for the medium whose properties are given below. f = 10(kHz) fly = 7 o…

A:

Q: 16.40 An 8-bit A/D converter has a reference voltage of 10 V. Find (a) the analog input…

A: The analog signal can be converted into digital signal by using the ADC converter. The conversion…

Q: Find the frequency response of the system below G(s) = 9s +15 2s² +98 +9

A:

Q: Select the transfer function gain (M)

A:

Q: Q-3 For a fully developed laminar flow of water (dynamic viscosity 0.003 Pa-sec) through a pipe of…

A: For a fully developed laminar flow of water, Dynamic vescosity μ=0.003 Pa-secPipe radius  R=80…

Q: Consider the voltage drop in a short line (1 indicates the sending end, 2 the receiving end of the…

A: Given: ∆V=V1-V2 Rl - Resistance across the line Xl - Inductance across the line Ptr - Active power…

Q: Q2) For the circuit, find voltages at the nodes Va and Vb. 2A 2 ohm Va 4 ohm 10V 12 ohm Vb 43A 6 ohm…

A:

Q: As shown in the figure below, this is a speed regulation method for DC separately excited notor. 1)…

A: given figure is that a speed regulation method for DC separately excited motor: a)  to explain about…

Q: . In the AC controller circuit, V = 230V, w=120m, L= 0, R = 2.352. Determine: (a) The angle a at…

A: Given: In this question, the given details are, In the AC controller circuit, V=230V , ω=120π , L=0…

Q: Time left 0- atematiksel gösterimi aşağıda verilen düzgün düzlem dalga Elektrik alan vektörünün…

A: We need to find out angle for given electric field with y axis .

Q: 9. In a circuit with a 12 volt supply and 4 2 resistance, the power consumed is 10. What is the unit…

A: 9. Given data, Supply voltage V = 12 V. Resistance R=4 Ω. Power consumed by resistor is given by,…

Q: * Define the state variables as in the block diagram: R(s) X₂(s) 1 X₂(s) 10 X,(s) Y(s) (s+1) (s+3)

A:

Q: Find Vo using nodal analysis. 6V(+ 2 ΚΩ + 4 ΚΩ 4 ΚΩ ww Vo • 8 ΚΩ 8 ΚΩ 2 mA

A:

Q: gain (M). G₁=2; G₂=4; G3=3; G4=5; G5=1; G6=2; G7=4; G8=7; H₁=0.1; H₂=0.4; H3=0.2; H4=0.3; !!! Not:…

A:

Q: Write a brief report on the electrical power 1- The method used to choose the cross-sectional area…

A: Electrical Transmission:- Electrical transmission is the process of transferring generated power to…

Q: Is 7 ΚΩ M 3 ΚΩ + VoΣ 2KΩ 1 ΚΩ If VO= 6V in the circuit in the figure, what would the is value be? 32…

A: Given: In this question, the given circuit is, The given value of the V0 is 6 Volt. To determine…

Q: 12 Q www. 24 www 36 V + R 36 Ω www N 1

A: Given : I4=1A

Q: 2. A single phase full wave ac voltage controller supplies an RL load. The input supply voltage is…

A: Given: A single phase full wave ac voltage controller supplies an RL load. The given input supply…

Q: Question 2 The resistance of semiconductor thermistor is given by: R(T)=Ro.exp B [+] T The…

A: Note: Thermistors are temperature sensors that are used to measure the temperature of the device…

Q: 1) (a) amplitude, (b) wavelength, and (c) frequency, given that its phase velocity is 6m/s? to…

A: Given: Waveform,

Q: Determine the voltage gain of the OTA in Figure 14-56. Assume K = 16 μS/μA for the graph in Figure…

A:

Q: Consider the second-order system: dx₁ dt = -ax₁, dx₂ dt 1 1 V₁(x) == x² + x², = = -bx₁-CX₂ where a,…

A: Control System: A system may be a tool that generates the required response by dominant the output.…

Q: data sheet of the following

A: The names of different electrical and electronics elements are given. We need to show the datasheet…

Q: 2: Draw the following signal. S(t) = 4 sin (277t+3m/2)

A: 2) Given S(t) = 4 sin[2π7t+(3π/2)].........(1) We need to draw the signal S(t)

Q: 9) What is the amplitude in the equation v35 sin(5000t)? A) 5000/TT V B) 35 V C) 5000 V D) 357 V

A: Given Data:-v=35sin(5000t)Find:-Amplitude=?

Q: Three loads are connected in parallel across a 1400 V rms, 60 Hz single phase supply as shown in…

A:

Q: find The m and Draw The output signal of AmpsB Vc (t) = 8 cos2πxist Ac pm(t)

A: Given: vct=8cos2π×105t  and Ac=8 Volts.

Q: G₁-2; G₂-7; G₂-6; G₁−3; G₂=2; G=3; Gy=6; Gg=5; H,−0.7; H₂−0.1; H₂=0.3; H₂=0.5; !!! Not: Her bir…

A:

Q: For the circuit shown to the right, after the switch is closed, the transient current i (in A) is…

A: Given data, Current it=21+e-0.4t Given circuit,

Q: (b) The input voltage, Vin(t) = 15 sin(400mt) V is connected to four silicon zener diodes as shown…

A:

Q: 5. For the Hartley oscillator shown in the below figure, assume r →∞ and gm = 20 mA/V. Design the…

A:

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.