Answered: A three phase star connected load has…

A three phase star connected load has an impedance of 12 + j18 Ω per phase. A voltage of 440 V 3 phase voltage supplied to the load. So find apparent power, active power and reactive power

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.19P: Consider a single-phase load with an applied voltage v(t)=150cos(t+10)volts and load current...

See similar textbooks

Related questions

Q: Question 3 (a) Analysing the working principles of induction motors, explain why the rotor of…

Q: Q1. A core with three legs is shown in Figure. Its depth is 5 cm, and there are 100 turns on the…

A: Given:

Q: Consider a circuit consisting of a 12 V battery, a 50 Ω resistor, and a 100 µF capacitor connected…

Q: The following circuit is: VI RB 2₁ 4 k 1.6 k 3kQ2 AOI logic gate O Emitter follower O Multi-emitter…

A: Logic gate:- It is an electronics device that is used for building blocks for digital circuits. AND,…

Q: Determine the capacitive reactance (Xc) of a capacitor of 10 µF when connected to a circuit of…

Q: If the voltage scale is 5 volt/div, what is the RMS value for the below signal т Select one: a.…

A: Given voltage waveform, The voltage scale is 5 volt/div So, the peak voltage, Vm=2 div×5…

Q: For a sine wave, the frequency is represented by the cycles per

A: The correct option along with the explanation is provided in the following section.

Q: Question 1 What is the transfer function of the following arrangement: C(s) R(S) 3-2 O 65-2 Al Σ…

A: Given,

Q: What is the current through the zener diode? V₁ 13 V Select one: a. 0 mA b. 7 mA c. 13 mA d. 8.3 mA…

A: Given circuit:

Q: Vin If the two-stage amplifier is driven by a 7502, 50mV source and the 18k, determine the following…

Q: VBB 5 V RB Μ 12 ΚΩ Rc • 120 Ω H11 lg Vcc 12 V

A: We need to select correct option for region of operation

Q: A 250 V DC series motor takes 40 A and runs at 1000 RPM. Find the speed at which it runs if its…

A: The back emf of the given DC series motor is, Eb1=V-Ia1Rf+RaV=250 VoltsRf=0.25 ΩRa=0.25 ΩIa1=40…

Q: If the capacitor in an RC ci find the CORRECT stateme Select one: a. The time constant b. The time…

A: Time constant of RC circuit is given by, τ=RC........eqn 1 Now, capacitor is replaced by two…

Q: Non-reactive loads of 10 kW, 6 kW and 4 kW are connected between lines a, b, c and the neutral of a…

Q: The characteristic impedance Zo of a lossless transmission line is 50 ohms; the inductance L = 1…

A: Given, Characteristics impedance of lossless transmission line, Zo=50 Ω Inductance, L=1 μHm…

Q: 1. Determine if the following assumptions are correct and briefly support your answer based on the…

A: The given circuit is as shown below,

Q: D. Design a sequential circuit with eight (8) states and the state transitions are defined in the…

Q: Q52. How much energy is stored by a 100 m H inductance with a current of 1 A? A. 100 J B. 1 J C.…

Q: The current through a resistor is 1.5A but measurement yields a value of 1.46A. Compute the: a)…

A: Given: Actual current through resistor, Ia=1.5 A Measured current through resistor, Im=1.46 A

Q: 3. The sequence component of phase a currents are: Iao = 0 A; Ia1 = 10 + j5 A; Ia2 = 8 -j5 A.…

Q: .18. Find Vout in the following circuit: 10 ΚΩ www + 5 V 15 V 40 ΚΩ Vout

Q: In pulse amplitude modulation, a. Amplitude of the pulse train is varied b. Width of the pulse train…

A: The correct option along with the explanation is provided in the following section.

Q: -5 A → - 25 V ΕΩ 10 V4 Ω Van = ? 4 Ω ΖΩ + I 5V

Q: Types of analog modulation are: a. Phase modulation b. Frequency modulation C. Amplitude modulation…

A: The solution is provided in the following section.

Q: 3. For the AC network shown in Figure 3, the source voltage is 120V (RMS). 4Q2 j6Q ww a) 120/10° V…

A: Given:

Q: 4. A series RLC circuit has a hypothetical current that is described by the expression, I(t) = 6e-t…

Q: Calculate the average power absorbed by each of the five elements in the circuit of Fig. 11.6. 40/0°…

A: Given: Circuit diagram:

Q: A coil of resistance 20 and inductance 150 mH in series with a 100 µF capacitor is connected to a…

Q: The 2G GSM technology uses a carrier separation of

A: The correct option along with the explanation is provided in the following section.

Q: A 4-pole generator having wave wound armature winding has 50 slots, each slots containing 20…

Q: Design a non-inverting amplifier that has a gain of 12. Assume value for Rf then find Ri.

A: The required resistor value for the non inverting amplifier can be obtained by using the expression…

Q: QUESTION THREE A 200 kW, 400 V, six pole, separately-excited DC machine has a rated speed of 500…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Problem 2 Determine the steady-state current i flowing in R and the power absorbed by it. 392 M H 00…

Q: 1 Consider a periodic pressure-time record as shown in the figure below. Determine its frequency…

Q: A certain electronic power supply requires 25 W of input power. It can produce an output power of 20…

A: Input power Pi = 25 W Output power Po = 20 W Efficiency = ? Power loss = ?

Q: Vo 7) Consider the multi-stage amplifier shown below with its corresponding small signal model.…

A: The given problem is from BJT small signal model. The expression for voltage gain Av is given in the…

Q: QUESTION 7 In the circuit shown below, the total impedance (ZT) is: I 192 + V₁ - 10/90°V ZT…

A: Given:

Q: Two coils, A and B having 1200 and 800 turns respectively are placed near to each other.60 % of flux…

A: Given data: Number of turns in coil A=NA=1200 Turns Number of turns in coil B=NB=800 Turns…

Q: A coil takes a current of 1.5 A from a 9 V DC supply. When connected to a 230V, 60Hz supply the…

Q: 3. A 12020⁰ Vrms is to supply power to a welder, heater and an induction motor. A welder is a coil…

A: Current through the element Z =voltage across element / Z. Total active power from source =sum of…

Q: 1. The collector-base voltage of a Si transistor is a. None of these b. zero c. 0.7 volts d. 0.3…

Q: Use the nodal analysis to find voltages Va, Vb, Vc, Vd. 20 Ω Vb im ww 10 2 502 ww . + Vc * İz 10 A…

A: A circuit diagram is shown below. Find Va, Vb, Vc, and Vd by using nodal analysis.

Q: 4) Consider the amplifier shown below with its corresponding small signal model. Using the provided…

Q: Identify the sensor connections as PNP (sourcing) and NPN (sinking). +DC LOAD +DC LOAD SENSOR -DC…

A: Observation: The First(LHS) schematic illustrates the following, Pure DC supply The given sensor…

Q: A 3-phase, 150 hp, 460 V, 60 Hz, 6-pole induction motor was subjected to certain performance tests.…

Q: Create an essay of not less than 5 sentences interrelating each terms in the content notes.…

A: LTI system is a system that produces an output signal from any input signal subject to the concept…

Q: The open-loop gain of a system is 0.6 when the phase angle is -180⁰. What is the gain margin of the…

Q: 1. A parallel-plate capacitor has a plate area of 0.2m² and a plate separation of 0.1 mm. If the…

Q: The 2G GSM technology uses a carrier separation of

A: The solution is provided in the following section.

Q: The process of transferring a mobile station from one base station to another is a. MSC b. Roamer c.…

A: What is the process of transferring a mobile station form one base to another

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

A three phase star connected load has an impedance of 12 + j18 Ω per phase. A voltage of 440 V 3 phase voltage supplied to the load. So find apparent power, active power and reactive power

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider a single-phase load with an applied voltage v(t)=150cos(t+10)volts and load current i(t)=5cos(t+50)A. (a) Determine the power triangle. (b) Find the power factor and specify whether it is lagging or leading. (c) Calculate the reactive power supplied by capacitors in parallel with the load that correct the power factor to 0.9 lagging.
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω connected in parallel. if we apply average value of 198 V sinusoidal AC voltage to the system . Find the line current, impedance and phase angle of the circuit. (Take Frequency in 60 Hz)
A parallel pair circuit of two impedances Z(1)= 11 + j 23 and Z(2)= 6 - j 13 is supplied with an AC supply of 230 V, 50 Hz. So find the current and power factor of the entire circuit
Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω are connected in parallel. If the average value of 198 V sinusoidal AC voltage is applied to this system, find the line current, impedance and phase angle of the circuit. (Take the frequency as 60 Hz.)
Find the total 3 phase complex power, average power, reactive power, apparent power and power factor If the 22Ω resistor is replaced with ZL = 100Ω + -j100Ω
3. Two impedance Z1= 12+j 16 ohms and Z2= 4- j4 ohms are connected in parallel across 240 volts , 60 hertz AC supply, Find the total power factor and total current in rectangular form.
The instantaneous values ofthe voltage across a two element series circum and the current flowing through it are given by V = 100 sin (314t – π/4)V, i = 20sin (314t – 900)A. Find the frequency and the circuit elements
A single-phase, 60-Hz source has a voltage of V = 170∠0° V (rms) and a current of I = 20∠60° A (rms). a) Plot v(t) and i(t). b) Find the Impedance of the load that this current is being delivered to. c) Determine the apparent power of the source and draw the power triangle.
A 200 V single phase circuit has an apparent power of 5 kVA and a reactive power of 4 kVAr. Then find (i) power factor (ii) impedance (lil) resistance (iv) reactance
A three-phase system having an rms line voltage of 141.4V is connected to a delta balanced load with impedance Z=15 angle30^. a) Obtain the reactive, active, apparent power and the power factor b. Solve part (a) but with a star-connected load with the same impedance value.
circuits Three impedances each (10 + j5) Ω are connected in delta on a balance 3-phase source. If the equation of the phase voltage is ?an = 120 sin ??, find the equation of the current through the impedance connected across phase a and b.