Determine the capacitive reactance (Xc) of a capacitor of 10 µF when connected to a circuit of frequency (a) 60 Hz (b) 15 kHz (a) Xc = 265.26 Q (a) Xc = 318.3 Q (a) Xc = 177.36 Q (b) Xc = 0.796 ✓(b) Xc = 1.06 (b) Xc = 3.28 2 none from the other choices

Determine the capacitive reactance (Xc) of a capacitor of 10 µF when connected to a circuit of frequency (a) 60 Hz (b) 15 kHz (a) Xc = 265.26 Q (a) Xc = 318.3 Q (a) Xc = 177.36 Q (b) Xc = 0.796 ✓(b) Xc = 1.06 (b) Xc = 3.28 2 none from the other choices

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 1PP: Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow....

See similar textbooks

Related questions

Q: 3) For each of the following waveform pairs, use the convolution integral to find response y(t) of…

Q: 1. Determine i(t) in the given circuit, the switch had been open for a long time and then closed at…

Q: %3D 5. In Figure, after switch S is closed at time t 0, the emf of the source is automatically…

A: It is given that:

Q: 0 3. Express the signals shown below in terms of unit step functions. 1 2 3 x(1) 3 7 2 - 1 0 2 3 4 ¡

Q: 3-phase wye-connected balanced load has 10 resistance in each phase. The load is supplied by a…

Q: Question 1: As Fig.1, U₁= − 3 V, U₂ = 10 V, U₁ = 4 V, Us = − 2 V, R₁ = 2 . Calculate the voltage on…

A: Given: Circuit:

Q: input and output impedance

Q: 1. A 2000/200V, 20kVA transformer has 66 turns in the secondary. Calculate: (a) Primary turns (b)…

A: Given a 2000/200V , 20kVA transformer has 66 turns in the secondary .Here we have to find the…

Q: The sequence x[n] = cos was obtained by sampling a continuous time signal x(f) = cos(f), -- < 1<a at…

Q: The circuit shown below is at dc steady state before the switch opens at t = 0. Find the voltage…

Q: For over modulation, the value of modulation index m is

A: The correct option along with the explanation is provided in the following section.

Q: -fund the current

Q: Q5) For the pairs of sequences x(n) -2, 1, for n = 0, 1, 2 for n = 3,4 0 elsewhere, and h(n) = :{…

A: Given:- xn=-2, for n=0,1,21, for n=3,40, elsewherehn=2, for n=0-1,…

Q: For over modulation, the value of modulation index m is a. m 1 d. Not predetermined

A: Modulation index gives the ratio of peak amplitudes of modulating signal and carier signal…

Q: Laplace transform of following signal: find out the the 1 ↑y (t) 0 0.0 to & >t

Q: PRACTICE PROBLEM 11.13 V 20 92 ww 30 92 -j10 92 j20 92 60 92 Figure 11.25 For Practice Prob. 11.13.…

Q: You have a wire of length L = 2.3 m for making a square coil of a dc motor. The current in the coil…

Q: A resistance of 20 ohm and a coil of inductance 31.8 mH and negligible resistance are connected in…

A: A) The inductive reactance of the circuit is, XL=jωLXL=j×2π×50×31.8×10-3 ΩXL=j10 Ω The impedance of…

Q: Six resistors are connected to a battery (see the figure below). It is known that R1 = 50, R2 = 252,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Find it through i4 in the given circuit. Assume / = 20 A. 60 Ω 40 Ω ww The value of i₁ is The value…

A: Given,

Q: What is the primary difference between PAM and PWM.

A: In this question we will write PAM and PWM...

Q: 5G base station used for wireless communications operates at 30 GHz. We will consider the down-link…

Q: Standard intermediate frequency used for AM receiver is a. 455 MHz b. 455 KHz c. 455 Hz d. None of…

A: The correct option along with the explanation is provided in the following section.

Q: Let us discuss the Eigenfunction property of LTI systems. Discuss when the eigenfunction property is…

A: In response to the given problem, we have to give - description about eigenfunction property of…

Q: A 4-pole DC generator runs at 650 rpm and generates an EMF of 200 V. The armature is wave wound and…

A: Given data, Number of poles P = 4 Speed of motor N = 650 rpm EMF E = 200 V Wave winding A =2 Number…

Q: d and e

Q: (a) Illustrate the Thevenin equivalent circuit of Figure 1 (b) Sketch the Norton equivalent circuit…

Q: I have submit my tution work please help me i will give likes

Q: Find the Thévenins equivalent circuit for the network external to the 7N capacitive reactance in the…

A: The given circuit is shown below. Find the Thevenin’s equivalent circuit across XC=7 Ω.

Q: The values of low cut-off frequency and high cut-off frequency of a band-pass filter are 32 kHz and…

A: Given: For a band pass filter, Lower cutoff frequency, fL=32 kHz Upper cutoff frequency, fH=60 kHz

Q: a successive approximation a/d converter has a resolution of 20 volts . what is it's digital output…

A: Given: Resolution=20 volts Analog input=2.17 volt

Q: Function of RF mixer is

A: The correct option along with the explanation is provided in the following section.

Q: 7. Find the average and r.m.s. values of the voltage wave shown. 0 n 3 2

Q: A series RLC circuit has a hypothetical current that is described by the expression, I(t) = 6e-t sin…

Q: For the circuit, take VTN=0.8V, the conduction parameter Kn-1 mA/V2 and X-0. Calculate the…

Q: 5) The voltage gain of an amplifier is described by the following expression: R1 gm (RLII R1 + 1/sC1…

Q: Whether Surge resistor 10 Ohms should include in calculation?

A: Surge resistor: It is a resistor which is inserted between the rectifier circuit and filter circuit…

Q: A garage is illuminated by a single incandescent light bulb dangling from a wire. The bulb radiates…

A: (a) The average intensity at a distance r is given by the expression as shown below: Iav=P4πr2…

Q: Q50. A 100 Q resistor is connected across the terminals of a 2.5V battery. What is the power…

A: Given data, Resistance R=100 Ω Battery voltage V=2.5 V

Q: In pulse amplitude modulation,

A: The correct option along with the explanation is provided in the following section.

Q: Question 23 When calculating the voltage of an FFT peak of a sinusoidal signal, would it match the…

A: Frequency response represents how the output gain or phase responds for a single frequency over a…

Q: The process of transferring a mobile station from one base station to another is

A: The process of transferring a mobile station from one base station to another base station is a very…

Q: 3. The sequence component of phase a currents are: Iao = 0 A; Ia1 = 10 + j5 A; Ia2 = 8 -j5 A.…

Q: A series RLC circuit has a hypothetical current that is described by the expression, I(t) = 6e-t sin…

Q: the most common failure with item with a three-phase induction motor system is the

Q: Problem 3 Find the load impedance ZL that would absorb the maximum power. −|2 492 Z₂ 85 12 H 2 cos A

Q: Can you explain the difference between these two forms? Like where the current is going, and how it…

A: In the first figure, the solar cell is in operating condition when the sun light strikes on it. So,…

Q: A 90 W lightbulb operates on a potential difference of 95 V. Part A Find the current in the bulb.…

A: Given, Power of light bulb, P=90 W Potential difference, V=95 volt

Q: A factory that is fed by a three-phase generator connected in Δ shape with Vac equals to 240 V with…

Q: An analog video signal has maximum frequency of 6 MHz. We want to send this analog video signal in…

A: Given an analog video signal has, Maximum frequency, fm=6 MHz Required data rate, Rb=216 Mbps

Concept explainers

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.

Question

#8 pls choose the correct answer

Determine the capacitive reactance (Xc) of a capacitor of 10 µF when connected to a
circuit of frequency (a) 60 Hz (b) 15 kHz
(a) Xc = 265.26 Q
(a) Xc = 318.3 Q
(a) Xc = 177.36 Q
(b) Xc = 0.796
(b) Xc = 1.06 Q
(b) Xc = 3.28 Q
none from the other choices

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
Calculate the total capacitance of two capacitive reactance XC1 = 5 ohms and XC2 = 11 ohms connected in series. Round 2 decimal point)
Compute the capacitive reactance if C = 467 μFf = 60 Hz
Given that vC(0) = 2 cos(155°) V, what is the instantaneous voltage across a 2- μF capacitor when the current through it is i = 12 sin(106t + 25°) A? Please report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 180 degrees. The instantaneous voltage across the given capacitor is v(t) = ____ sin(106t – ___°) V.
Compute the inductive reactance if L = 60 mHf = 112 Hz
The capacitive reactance of a circuit is 120 ohms when it is supplied with 50 Hz supply. What will be the value of the capacitive reactance of the same circuit, if it is supplied with a 60 Hz supply?
Find the equivalent inductive reactance if the frequency is 65 Hz.
13. When a capacitor is connected to an AC supply, the current A. Leads the voltage by pi/2 rad B. Leads the voltage by 180 degrees C. In phase with the voltage D. Lags the voltage by 90 degrees
1) Resistance in a circuit will cause the delay in the time for charging a capacitor. (True or false) 2) With increase in the frequency of the supply, Inductive reactance of an inductor will _______ (decrease or increase) 3) In an ac circuit, the voltage ______ a) leads the current b) is in phase with the current c) lags the current d) any of the above, depending on the circumstances 4) When the supply frequency increases, then the Capacitive Reactance (Xc ) in a circuit will a) Remain Same b) increase c) decrease 5) In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will have ___ phase shift a) 180 deg b) 0 deg c) 45 deg d) 90 deg
An inductor has an inductive reactance of 250 V when connected to a 60 Hz line.What will ba the inductive reactance If the inductor is connected to a 400 Hz line?
An RG58 coaxial cable has a capacitance of 30 pF per foot and a characteristic impedance of 50 ohms. What is the inductance of the cable per foot.
a) Calculate the current IL b) Calculate the complex power of V1 c) How much average power is being absorbed by the inductor?