A trapezoidal dam with vertical upstream face is 6m high, 0.6m at the top and 3m wide of the bottom. Unit weight of concrete is 23.5 kN/m^3 Using the computed depth of water, compute the hydrostatic uplift force (pound-force) if the uplift varies from full hydrostatic pressure at the heel to zero at the toe using yards instead of meters

A trapezoidal dam with vertical upstream face is 6m high, 0.6m at the top and 3m wide of the bottom. Unit weight of concrete is 23.5 kN/m^3 Using the computed depth of water, compute the hydrostatic uplift force (pound-force) if the uplift varies from full hydrostatic pressure at the heel to zero at the toe using yards instead of meters

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter14: Lateral Earth Pressure: Curved Failure Surface

Section: Chapter Questions

Problem 14.15P: The cross section of a braced cut supporting a sheet pile installation in a clay soil is shown in...

See similar textbooks

Similar questions

A concrete dam is triangular in cross section and (30+0.314)m high from the horizontal base. If water reaches a depth of (27+0.314)m on the vertical face, what is the minimum length of the base of the dam such that the resultant will intersect the base within the middle third? What minimum coefficient of friction is required to prevent sliding ? Determine the pressure distribution along the base. If the uplift pressure varies from half full hydrostatic at the heel to zero at the toe.
A trapezoidal dam having a top width of 0.60m and a bottom width of 1.2m is 1.8m high. The depth of water on the vertical side of the dam is 2.4m. Unit wt. of concrete is 23.5 kN/m3. Neglecting hydrostatic uplift. Determine the total horizontal hydrostatic force acting on the dam, the factor of safety against overturning and the factor of safety against sliding if coefficient of friction between the dam and the soil is 0.80.
A dam is triangular in cross section with the upstream face vertical. Water is flush with the top. The dam is 8 m high, 6 m wide at the base and weighs 23.5 kN/m3 . The coefficient of friction between the base and the foundation is 0.80. There is hydrostatic uplift that varies from full hydrostatic pressure at the heel to zero at the base. b.) Determine the factor against overturning.
In the figure shown, the concrete dam is 16m high and 13m wide at the base. If the specific weight of the concrete is 23.544KN/m^3 and height of water in the upstream side is 15m, find the factor of safety against sliding, factor of safety against overturning, and the unit pressure on the foundation. Assume there is a hydrostatic uplift that varies uniformly from full hydrostatic head at the heel of the dam to zero at the toe and that the coefficient of friction between the dam and the foundation is 0.50.
A dam is triangular in cross section with the upstream vertical. Water is flushed at the top. The dam is 8 m high and 6 m wide at the bottom and weighs 23.5 KN per cu.m. The coefficient of friction between the base and the foundation is 0.80. Hydrostatic uplift varies from full at the heel to zero at the toe. Determine the factor of safety against overturning and sliding.
A triangular dam has a vertical upstream face 30 m high from the horizontal base. The depth of water is 27 m on the vertical face. If concrete weighs 23.5 KN/m3. Determine the minimum width of the base such that the resultant force falls within the middle thirds, neglecting hydrostatic uplift. What is the minimum coefficient of friction to prevent sliding? What is the shearing stress at the depth of 10 m above the horizontal?
A concrete gravity dam with a trapezoidal section is holding water as shown in the figure. A distance of 15 meters from the toe, a drain is located. The drain has a pressure due to uplift of zero and increasing uniformly to full hydrostatic at the heel. Upstream face 1H:5V, while downstream face is inclined 1H:2V. Which of the ff nearly gives the maximum foundation pressure on the base of the dam in kilopascal ? Assume 23.54 kN/m3 for the unit weight of concrete. a. 3114 b. 1095 c. 4115 d. 964 e. 680
A damn having a triangular section has a vertical face 24 m high and base 12 m wide. Use sg=2.4 a. determine the height of water that could rise on the vertical side of the dam so that the maximum intensity of pressure at the toe is twice the average pressure at the base. Neglect hydrostatic uplift. b. What is the shearing stress at the base?
5. What is the factor of safety against overturning for the triangular dam? Determine the pressure distribution at the base of the dam. Neglect hydrostatic uplift. Use unit weight of concrete 24kN/m³.
An 18-m concrete dam with 1.5 m on the upper base and an unknown bottom base has water impounded standing at 16 m. Hydrostatic uplift varies from full at the heel to zero at the toe. If the factor of safety against overturning is 1.60, determine the bottom width in meters. coefficient of friction between the base and foundation is 0.75, compute the factor of safety againts sliding. compute the maximum foundation pressure that the dam will experience.
pls replyy asap!! Given the dimension of a gravity dam with top base = 2m, bottom base =6m, height = 8m and depth of water at the upstream side is 6m (acting on vertical side of the dam). Neglect hydrostatic uplift and use unit weight of concrete equal to 20 kN/m?. The coefficient of friction between the base of the dam and the foundation is 0.6. Determine the Factor of safety against sliding.
A masonry dam of trapezoidal cross section, with one face vertical has thickness of 60cm at the top, 3.70m at the base, and has a height of 7.40m. What is the depth of water on the vertical face if the resultant intersects the base at the downstream edge of the middle third? Assume that the uplift pressure varies uniformly from full hydrostatic at the heel to zero at the toe