A triangle loop moves into the area with a constant magnetic field shown in the picture below. The field has a strength of B = 0.2 T and is perpendicular to the plane of the loop. Find the emf induced in the loop as a function of time (in sec) if the angle a = 35, the loops moves with a constant speed of v= 5 m/s and at t=0 the loop was just entering the field area (the tip of the triangle was touching the B-field). Do not submit the units.

A triangle loop moves into the area with a constant magnetic field shown in the picture below. The field has a strength of B = 0.2 T and is perpendicular to the plane of the loop. Find the emf induced in the loop as a function of time (in sec) if the angle a = 35, the loops moves with a constant speed of v= 5 m/s and at t=0 the loop was just entering the field area (the tip of the triangle was touching the B-field). Do not submit the units.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter32: Faraday’s Law Of Induction

Section: Chapter Questions

Problem 62PQ

See similar textbooks

Similar questions

A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially uniform magnetic field. During a 0.10-s time interval, the magnitude of the field Increases uniformly from 200 to 300 mT. (a) Determine the emf Induced in the ioop. (b) If the magnetic field is directed out of the page, what is the direction of the cun-ent induced in the loop?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
Shown in the following figure is a long, straight wire and a single-turn rectangular loop, both of which he in the plane of the page. The wire is parallel to the long sides of the loop and is 0.50 m away from the closer side. At an instant when the emf induced in the loop is 2.0 V, what is the time rate of change of the current in the wire?
The current in the long, straight wire shown in the accompanying figure is given by, where I=I0sint I0=15Aand=120rad/s. What is she current induced in the rectangular loop at (a) t = 0 and (b) t=2.1103s The resistance of loop is 2.0 .
Suppose the magnetic field of the preceding problem oscillates with time according to B=B0sint . What then isthe emf Induced in the loop when its trailing side Is a distance d from the right edge of the magnetic field region?
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
An eight-turn coil is tightly wrapped around the outside of the long solenoid as shown below. The radius of the solenoid is 2.0 cm and it has 10 turns per centimeter. The current through the soleNOID increases according to I=I0(1eat) where I0=4.0A and a=2.0102s1 . What is the emf induced in the coil when (a) t=0, (b) t=1.0102s and (c) t ?
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
Design a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .
Check Your Understanding (a) What is the magnetic flux through one turn of a solenoid of self- inductance 8.0 × 10-5 H when a current of 3.0 A flows through it? Assume that the solenoid has 1000 turns and is wound from wire of diameter 1.0 mm. (b) What is the cross-sectional area of the solenoid?
The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?