A trough is filled with liquid of weight density 60 N/m³ and with cross section in the shape of a semicircle with radius 4 meters. a] Find the force acting on one end due to liquid pressure. (Note: Place the top along the x-axis.) b] Set up the integral for the force against one end if the the trough is filled with the liquid to a depth of 3 m.

A trough is filled with liquid of weight density 60 N/m³ and with cross section in the shape of a semicircle with radius 4 meters. a] Find the force acting on one end due to liquid pressure. (Note: Place the top along the x-axis.) b] Set up the integral for the force against one end if the the trough is filled with the liquid to a depth of 3 m.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter13: State Of Matter

Section: Chapter Questions

Problem 76A

See similar textbooks

Similar questions

How would you determine the density of an irregularly shaped rock?
Logs sometimes float vertically a lake because one end has become water-logged and denser than the other. What is the average density of a uniform-diameter log that floats with 20.0% of its length above water?
What is density of a woman floats in fresh water with 4.00% of her volume above the surface? (This could be measured by placing her in a Wii marks on the side to measure how much water she displaces when floating and when held under water.) (b) What percent of her volume is above surface when she floats in seawater?
Check Your Understanding Would a hydraulic press still operate properly if a gas is used instead of a liquid?
Calculate Reynolds numbers for flow of trough (a) a nozzle a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when be nozzle is attached to hose. The flow rate through hose and nozzle is 0.500 L/s. Can flow in either possibly be laminar?
Assuming bicycle tires are perfectly flexible and support the weight of bicycle and rider by pressure alone, calculate the total area of the tires in contact with be ground if a bicycle and rider have a total mass of 80.0 kg, and gauge pressure in the tires is 3.50105 Pa.
Why is a force exerted by a static fluid on a surface always perpendicular to the surface?
A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
Verify that flow of oil is laminar for an oil gusher that shoots crude oil 25.0 m into the air through a pipe with a 0.100-m diameter. The vertical pipe is 50 m long. Take the density of the oil to be 900 kg/m3 and its viscosity to be 1.00(N/m2)s (or 1.00Pas ).
What fraction of ice is submerged when it floats in freshwater, given the density of water 0°C is very close to 1000 kg/m3?
A spherical particle falling at a terminal speed in a liquid must have the gravitational force balanced by the drag force the buoyant force. The buoyant force is equal to the weight of the displaced fluid, while drag force assumed to be given by Stokes Law, Fs=6rv . Show that the terminal speed is given by v=2R2g9(s1) , where R is be radius of sphere, s is its ad 1 is of be fluid, and the coefficient of viscosity.
An oil gusher shoots crude 25.0 m the through a pipe with a 0.100-m diameter. Neglecting resistance but not resistance of the pipe, and assuming laminar flow, calculate pressure at be entrance of be 50.0-m-Iong vertical pipe. Take of the oil to be 900 kg/m3 and its viscosity to be 100(N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to 50.0-m column of oil in pipe.