A truck with a ball free to roll around in the back takes a a sharp turn to the right. Which of the following forces cause the ball to move to the left side of the truck? (A centripetal force. B gravity. No answer D normal force.

A truck with a ball free to roll around in the back takes a a sharp turn to the right. Which of the following forces cause the ball to move to the left side of the truck? (A centripetal force. B gravity. No answer D normal force.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter6: Motion In Two Dimensions

Section: Chapter Questions

Problem 80A

See similar textbooks

Related questions

Q: A 55pF capacitor is charged to a potential difference of 500V. Its terminals are then connected to t...

A: Given: The potential difference across 55 pF is 500 V. The other uncharged capacitance is 15 pF.

Q: There are two 9.1kg identical balls of electrons which are 5m apart. What is the charge of each ball...

A: Given data: Here, m1 and m2 are the masses of balls and d is the distance between them.

Q: The potential difference from the cathode to the screen of a television set is +22,000 V. If an elec...

A: Given: Mass of an electron =m= 9.11×10-³¹ Kg V= 22000 V q= 1.6 ×10-¹⁹ C

Q: A container with 50 g of a certain liquid (c = 4186 J/kg · °C, Lv=2265 kJ/kg) at 22 °C is heated up ...

Q: A jet engine releases 5000J of energy per cycle and performs 800 J of work A. How much heat is abs...

Q: In Wheatstone bridge experiment, the balance point is obtained when: Select one: a. The potential di...

A: The wheatstone bridge is used in calculating the unknown resistance by balancing two legs of the bri...

Q: Set the charges to be q1 = 5 µC and q2 = 5 µC What is the magnitude of the force on q1 by q2 ? (N) W...

Q: A rutber ball and a clay hall have equal mass and are dropped ono a digital scale. The nbber hall bo...

A: Given: A rubber ball and clay ball with same velocity hits the weighing scale. Rubber ball bounces...

Q: 3. A thin insulating rod is bent into a semicircular arc of radius a, and a total electric charge Q ...

Q: Consider the circuit as shown in the diagram. Using the current directions set in the diagram, what ...

A: We have a loop of voltages V1=24 V and V2=10 V with three resistors R1=8 ohm, R2=6 ohm and R3= 4 ohm...

Q: A 38.9 A current flows in a long, straight wire. Find the strength of the resulting magnetic field a...

A: Given: Current flow through the wire, I=38.9 A. Distance from the wire, r=64.7 cm=0.647 m We know, ...

Q: A 2.28 kg mass is sliding across a horizontal surface while being pushed on by an applied force of 1...

Q: In Exercise 12.4 of your book, University Physics 15th edition (see End of the Chapter 12 section), ...

Q: In a hydraulic system, the radius of the large piston in a hydraulic Jack is 2.23 inches. The radius...

Q: The two identical square plates of a parallel plate capacitor in vacuum have a separation distance o...

A: capacitance for parallel plate capacitor is given by ...

Q: Write the magnitude for each force (acting on each side 1 thru 4) using the symbols (K, L, I, W)

A: magnetic force F→=IL→×K→

Q: when a certain force is applied to an object with a mass of 2kg, its acceleration is 10.0 m/s^2. Whe...

A: Mass of object A = 2 kg Acceleration of object A = 10.0 m/s2 Acceleration of object B = 4.0 m/s2 ...

Q: A small ball of mass 1.5 kg is attached to one end of a 0.990-m-long massless rod, and the other end...

A: Torque = force × perpendicular distance

Q: In the Potentiometer Experiment What is &, when the galvanometer (G) reads Zero? E= 20 V a) 2.5 b) 3...

Q: A horizontal platform in the shape of a circular disk rotates on a frictionless bearing about a vert...

Q: What is the mass of an electron? Also, mention the mass of a proton.

A: Required: The mass of an electron and a proton

Q: In the circuit shown, to measure the current through R2 Ji J3 R1 R3 E 6V J2 3V- Sh R2 12 0 Ji is rem...

A: Given To measure the current through R2 Change should be ____

Q: 3. A dentist's mirror is placed 1.0 cm from a tooth. The enlarged image is located 7.5 cm behind the...

Q: Two long wires are connected across the same voltage. Calculate the ratio of the power used in wire ...

A: Considering the wires as wire A and wire B. Given data: The voltage across the wires is same i.e., V...

Q: An airplane flies in a horizontal circle of radius 500 m at a speed of 150 m/s. If the plane were to...

Q: Two resistors with resistances of 22 Ω and 17 Ω are connected in series. The series combination is t...

Q: 1. How far should a 6 inches object be located from the light source to create a 2 feet shadow on th...

A: we use the relation length of shadow/distance of screen = length of object/distance of object

Q: You illuminate a slit with a width of 74.9 µm with a light of wavelength 737 nm and observe the resu...

Q: Kirchhoff's loop rule is a statement of conservation of: Select one: a. charge b. momentum

A: Kirchoff’s loop rule is a statement of conservation of Energy. As it stats that the sum of all volta...

Q: A 500 g block w/ an a horizontal tabletop a. How far will it b. What is the c tabletop?

A: mass = m = 500 g = 0.5 kg initial speed = Vi= 90 cm/s = 0.9 m/s frictional force = f =0.8 N

Q: in the Potentiometer experiment, which of the tollowing must bo true cbout the wire on themeter stic...

A: in the potentiometer experiment the wire used must have uniform cross sectional area. Option A is co...

Q: Two simple pendulums of 60.5 cm and 50 cm respectively. A 60.5 cm pendulum vibrates with a frequency...

A: length of first pendulum = L1= 60.5 cm length of second pendulum = L2= 50 cm frequency = f1= 1 hertz...

Q: In ander for an object to rull smoothly (with constant angular acceleration) down a ramp, i must hav...

A: Given information: The mass of the object = M The radius of the object = R The height of the incline...

Q: In 1939 or 1940, Emanuel Zacchini took his human-cannonball act to an extreme: After belng shot from...

A: Given Initial velocity u= 26 m/s Angle of projection= 580 MMotion of projectile can be divided into...

Q: 4. Given that the system is in equilibrium, find the tension in the ropes as shown. 65° 65- Ts T: 50...

A: The free-body diagram of point A is shown below.

Q: The National High Magnetic Field Laboratory once held the world record for creating the strongest ma...

A: Givenmagnetic field ,B=45 TMass of Na ion ,m=3.8×10-26 Kgvelocity ,v=45 cm/s=0.45 m/s

Q: pe a noaAu un2 no on on 12.4 • (a) What is the average density of the sun? (b) What is the av- erage...

Q: Two parallel wires are separated by a distance of 0.05 m. Wire 1 carries a current of 12 A. Wire 2 c...

Q: A doubly ionized molecule (i.e., a molecule lacking two electrons) moving in a magnetic field experi...

A: charge = q = 2e = 2 x 1.6 x 10-19 = 3.2 x 10-19 c magnetic force = F = 6.41 X 10-16 N speed = V = 22...

Q: As an optometry student, you are interning at an Optical Centre. A patient requested to be prescribe...

A: a. 1. Retinoscope 2. Jackson's cross cylinder b. 1. near point is about 25 cm 2. far point is 25 cm ...

Q: Constant Part A At a rock concert, a dB meter registered 128 dB when placed 2.2 m in front of a loud...

Q: Which of the following statements are true? 1. in-phase waves result to destructive interference ...

A: As per Bartleby guidelines i am solving first three Which of the following statements are true?1. in...

Q: The focal length of a concave spherical mirror is 35.0 cm. If there is an object is placed 93.7 cm f...

Q: Q4. When a tensile load (F) is applied to a solid homogeneous rod, the rod undergoes a change in len...

A: Write the basic expressions related to stress and strain. Here, σ represents the stress, A represen...

Q: A horizontal force of 12 N pushes a 0.50-kg book against a vertical wall. The book is initially at r...

Q: A race car moves such that its position fits the relationship x = (5.0 m/s)t + (0.75 m/s³) where x i...

Q: You are driving 52 mi/h and take your eyes off the road for "just a second" (exactly one second). Wh...

A: Given Speed = v = 52 mi/h Time taken to travel = t = 1 sec We have to calculate distance (in feet) t...

Q: A young girl (m = 30 kg) rides a skateboard (m = 3.2 kg) at a speed of 4.2 m/s. (a) How much work do...

A: Given Mass of young girl = m = 30 kg Mass of skateboard = 3.2 kg speed of young girl on skateboard =...

Q: JA position-time graph for a particle moving along ´the x axis is shown in Figure [ 3 ] (a) Find the...

A: Given:

Q: Two long, parallel wires are separated by 9.67 cm and carry currents of 2.99 A and 4.49 A, respectiv...

Concept explainers

Centripetal Force

A particle, body, object or certain mass while travelling in a rotational path or semicircular path, experiences an inertia force. If that inertia force pulls the towards the inward of the imaginary circle in the rotation, it is termed as centripetal force.

Question

A truck with a ball free to roll around in the back takes a a sharp turn to the right. Which of the following forces cause the ball to
move to the left side of the truck?
(A) centripetal force.
(B) gravity.
No answer
normal force.
E the absence of a force.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Why does banking a curve on a highway allow a vehicle to successfully negotiate the turn at a higher speed?
Railroad tracks follow a circular curve of radius 500.0 m and are banked at an angle of 5.0 . For trains of what speed are these tracks designed?
A space station, in the form of a wheel 120 m in diameter, rotates to provide an artificial gravity of 3.00 m/s2 for persons who walk around on the inner wall of the outer rim. Find the rate of the wheels rotation in revolutions per minute that will produce this effect.
What is the ideal speed to take a 100.0-m-radius curve banked at a 20.0angle?
Do you feel yourself thro to either side when you negotiate a curve that is ideally banked for your car’s speed? What is the direction of the force exerted on you by the car seat?
If centripetal force is directed toward the center, why do you feel that you are ‘thrown’ away from the center as a car goes around a curve? Explain.
An office door is given a sharp push and swings open against a pneumatic device that slows the door down and then reverses its motion. At the moment the door is open the widest, (a) does the doorknob have a centripetal acceleration? (b) Does it have a tangential acceleration?
An astronaut tosses a rock on the Moon. What force(s) act(s) on the rock during its curved path?
Friction is needed for a car rounding a curve. But, if the road is banked, friction may not be required at all. What, then, supplies the needed centripetal force? (Hint: Consider vector components of the normal force on the car.)
While driving fast around a sharp right turn, you findyourself pressing against the car door. What is happening?(a) Centrifugal force is pushing you into the door.(b) The door is exerting a rightward force on you.(c) Both of the above.(d) Neither of the above.
If a roadway is banked at the proper angle, a car can round a corner without any assistance from friction between thetires and the road. Find the appropriate banking angle for a 900-kg car traveling at 20.5 m>s in a turn of radius 85.0 m.
What is the maximum speed with which a 1300 kg car can round a turn of radius 100.0 m if the coefficient of static friction between the tires and the road is 0.70? Does the result depend onthe mass of the car? What is the centripetal acceleration of the car at the maximum speed it can go around the turn? What is the corresponding centripetal force on the car?