A two-story hospital is shown in the figure and must withstand an estimated wind speed of 145km/h and is located in an urban area surrounded by buildings. Determine the design wind pressure on all four sides of the hospital. Assume that the main entrance is the windward region. The building has a period of vibration of 0.4s. The dimensions of the structure are in feet, transform to meters. Subject : Structural Analysis 8888888 8 11 100% pindfinde 8 8 8 001 15' 15'

A two-story hospital is shown in the figure and must withstand an estimated wind speed of 145km/h and is located in an urban area surrounded by buildings. Determine the design wind pressure on all four sides of the hospital. Assume that the main entrance is the windward region. The building has a period of vibration of 0.4s. The dimensions of the structure are in feet, transform to meters. Subject : Structural Analysis 8888888 8 11 100% pindfinde 8 8 8 001 15' 15'

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

how to solve if the wind is blowing in front of the building? Wind blows in FRONT of the fully enclosed agriculture building located on open flat terrain in Oklahoma. Determine the external pressure acting over the windward wall, the leeward wall, and the side walls. Also, what is the internal pressure in the building which acts on the walls? Use linear interpolation to determine qh.
A rectangular boat with additional load at thecenter of 1200 kgis submerged in water by 1.8 m. The boat is 8 mlong and 6 mwide and 2.4 m high. Find the total draft after the1200kg is placed at the edge of the boatwithout causing it to sink. Assume water is freshwith density equal to1000 kg/cu.m.Determine the initial metacentric height.Determine the final metacentric height.Determine the shifting of the center of buoyancy.
The roof of rigid gabled frames 5 meters on centers has a slope of 30 degrees. If the wind velocity pressure in the area is 2.8KPa , Gust Effect Factor, Gt=0.85 and external pressure coefficient of 0.25 (pressure) and 0.35 (suction). Calculate the total amount of wind load in KPa on the leeward side of the roof. Express your answer in 2 decimal places.
The roof of rigid gabled frames 5 meters on centers has a slope of 30 degrees. If the wind velocity pressure in the area is 2.7KPa , Gust Effect Factor, Gt=0.85 and external pressure coefficient of 0.38 (pressure) and 0.41 (suction). Calculate the total amount of wind load in KPa on the windward side of the roof. Express your answer in 2 decimal places.
Consider a 7-story buildings with a total plan area BxL. In which B=125ft and L=60ft . The average weight of each floor and roof are 95 Ib/ft and 75 lb/ft?, respectively. The 84 ft-tall building is located in a seismic region with SDs =1.6 g and SD1 =0.5g for a building supported on rock, where g is the gravitational acceleration. The structure of the building consists of steel moment frames (all joints are rigid) that have an R value of 8. The importance factor I=1.0 Determine the total design seismic force (kips) acting at the base of the building ( seismic base shear in kips). ***the answer was between 339.5 and 342.5*** but I don’t understand how . Handwritten work is preferred
The flat roof of the steel-frame building shown in the photo is intended to support a total load of 2 kN/m2 over its surface. Determine the roof load within region ABCD that is transmitted to beams BC and DC. The dimensions are shown.
Determine the drag on a paddle with an area of 0.06 sq.m. moving horizontally at 0.8 m/s. CD = 0.45.
Determine the external wind pressure on the roof of the rigid-gabled frame of a building for an essential disaster operation center shown in figure. The building is located in Kansas City, Missouri, where the terrain is representative of exposure C. The wind direction is normal to the ridge, as shown in the figure.
Wind blows on the side of a fully enclosed hospital located on open flat terrain where V = 120 mi/h. Windward wall has a height of 30 ft. The roof is flat. Use the table below to determine Kz for the formula for the design wind pressure according to the ASCE 7-10 Standard. Velocity Pressure Exposure Coefficient for Terrain with Low-Lying Obstructions z(ft) z(m) Kz 0-15 0-4.6 0.85 20 6.1 0.90 25 7.6 0.94 30 9.1 0.98 40 12.2 1.04 50 15.2 1.09 A) Determine the design wind pressure acting on the windward wall of the building at the height of 25 ft above the ground for a positive internal building pressure using the ASCE 7-10 Specifications. p25= ______ psf B) Determine the design wind pressure acting on the windward wall of the building at the height of 30 ft above the ground for a positive internal building pressure using the ASCE 7-10 Specifications. p30= ______ psf C) Determine the design wind pressure acting on the windward wall of the building at…
Please solve without using simplified wind pressure, and please use diagrams. Thank you . A two-story hospital is being designed in New Jersey.A)With a basic wind speed of 115 mph and wind exposure C, theimportance factor I is 1.15 and Kzt=1.0,G=Gust factor= 0.85 for rigid structures. Determine the design wind load, baseshear, applied at each floor, and building overturning moment.B)Determine the seismic base shear andoverturning moment. The hospital has an average weight of 95 lb/ft² for all floors (floors and roof), and the seismic designparameters are SDS=0.35 g and SD1=0.15 g, with reinforced concrete frames and a response modification coefficient R of8. The importance factor for seismic design is 1.5.
Verticle load is 258 kN as opposed to 25*8kN - Apologies
A thin flat plate 55 by 110 cm is immersed in a 5.6-m/s stream of SAE 10 oil at 20°C. Compute the total friction drag if the stream is parallel to: a. the long side. b. the short side.