À U-tube differential manometer connects two pressure pipes A and B. Pipe A contains can tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/cm? and pipe B contains ol o sp. gr. 0.8 under a pressure of 11.772 N/em". The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. [Ans. 31.36 cm of mercuryl

À U-tube differential manometer connects two pressure pipes A and B. Pipe A contains can tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/cm? and pipe B contains ol o sp. gr. 0.8 under a pressure of 11.772 N/em". The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. [Ans. 31.36 cm of mercuryl

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The pressure gauges are inserted at A and B in a vertical pipe converging water. The diameters at A and B are 150mm and 75mm respectively. The point B is 2.3m below point A. When rate of flow down the pipe is 0.021m³/s. The pressure at B is 117.72 KN/m² greater than at A. The losses in pipe between A and B are expressed as(KVa²/2g) where Va is velocity of A. Find the value of K. If the pressure gauges at A and B are replaced by tubes filled with water and connectef to a u-tube containing Hg(SHg=13.6) calculate the value of the reading manometer.
A pipe carrying oil of sp gr 0 877 changes in A pipe carrying oil of sp gr 0.877 changes in size from 150mm at section E to 450mm at section R Section E is 3 66m lower than R section R. Section E is 3.66m lower than R and the pressures are 91.0kPa and 60.3kPa, respectively. If the discharge is 0.146m3 respectively. If the discharge is 0.146m /s, determine the lost head and the direction of flow.
An open tank contains water upto a depth of 1.5 m and above it an oil of sp. gr. 0.8 for a depth of 2 m. Find the the pressure intensity in kPa at the bottom of the tank. a. 30.41 b. 13.7 c. 34.34 d. 27.47
A cylindrical tank contains water at a height of 55mm, as sbown. Inside is a small open cylindrical tank containing cleaning fluid (s.g.=0.8) at a height h. The pressure Pb=13.4 kPa gage and Pc=13.42 kPa gage. Assume the cleaning fluid is prevented from moving to the top of the tank. Use unit weight of water=9.79 kN/m^3. a) determine the pressure Pa in kPa, b) the value of h in mm, and c) the value of y in mm.
Q3) A differential manometer is connected at two points A and B of two pipes. The pressure at A and B are 1 bar and 2 bar respectively. Find the difference in mercury level in the diffrential manometer. (12
Orifice meter with orifis cross-section 0.00785 m2 is inserted in a pipe of cross-section 0.0314 m2. The pressure gauge fitted upstream and downstream of orifice give reading of 19.62 N/cm2 and 9.81 N/cm2 respectively. Determine the value of dischareg using Cd=0.6.
An 83-mm-diameter siphon is drawing oil (SG = 0.85) from an oil reservoir, as shown in the figure. If the velocity of flow in the pipe is 'v', the head loss from point 1 to point 2 is 6v2/2g, and the head loss from point 2 to point 3 is 2v2/2g. Find the absolute pressure (in kPa) at point 2. Use atmospheric pressure, Patm = 102 kPa. Use y1 = 5 m., and y2 = 7 m.
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 30 cm above the pipe B. The height of oil in right limb is 50 cm. Also, the mercury level difference is found in right limb as 90 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. The difference of pressure between two pipes (PA-PB) (Unit is in kPa) ? Equivalent to Water head in mm ?
A venturi meter with a throat diameter of 100 mm is fitted in a vertical pipeline of 200 mm diameter with oil of specific gravity 0.88 flowing upwards. Two pressure gauges are fitted at tapping points, one at the throat and the other in the inlet pipe 320 mm below the throat. The difference between the 2 gage pressure readings is 28 kPa. (a) Determine the flow in m^3/s neglecting head losses (b) Working from Bernoulli's equation, determine the difference in levels (in mm) between the two limbs of a mercury manometer if it is connected to the tapping points and the connecting pipes are filled with the same oil Draw illustrations Use 3 decimals
Oil with sp. gr. 0.95 flows at 200 lit/sec through a 500 m of 200 mm diameter pipe (? = 0.0225). Determine (a) the head loss (m) and (b) the pressure drop (kPa) if the pipe slopes down at 10⁰ in the direction of flow.
With the chamber-pipe system in the figure, the ideal fluid (water) taken from the infinitely sized chamber A is poured into the atmosphere with a 40 cm fixed diameter BCDEF pipe. Since zB=29, zC=10, zD=28.5, zE=5 and zF=28 meters according to the comparison plane;a) Calculate the flow of the system.b) Draw the relative load (energy) and piezometer lines of the system.c) Determine where the greatest pressure will be observed throughout the system and calculate its relative value.
The inverted U-tube manometer contains oil (0.90) and water as shown. If the pressure differential between pipes A and B, is (-5) kPa. Determine the differential reading, h in centimeters.