A uniform water stream, U∞ = 20 m/s and ρ = 998 kg/m3,combines with a source at the origin to form a half-body. At(x, y) = (0, 1.2 m), the pressure is 12.5 kPa less than p∞. (a) Isthis point outside the body? Estimate (b) the appropriatesource strength m and (c) the pressure at the nose of the body.

A uniform water stream, U∞ = 20 m/s and ρ = 998 kg/m3,combines with a source at the origin to form a half-body. At(x, y) = (0, 1.2 m), the pressure is 12.5 kPa less than p∞. (a) Isthis point outside the body? Estimate (b) the appropriatesource strength m and (c) the pressure at the nose of the body.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.29P: Air at 20C flows at 1 m/s between two parallel flat plates spaced 5 cm apart. Estimate the distance...

See similar textbooks

Similar questions

Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23 kg/m3 (0.002377 slug/ft3) and 1.01 × 105 N/m2 (2116 lb/ft2), respectively. Consider a venturi with a small hole drilled in the side of the throat. Thishole is connected via a tube to a closed reservoir. The purpose of theventuri is to create a vacuum in the reservoir when the venturi is placed inan airstream. (The vacuum is defined as the pressure difference below theoutside ambient pressure.) The venturi has a throat-to-inlet area ratio of0.85. Calculate the maximum vacuum obtainable in the reservoir when theventuri is placed in an airstream of 90 m/s at standard sea level conditions.
For the system below, let the pump exhaust gasoline at 65 gallons per minute to the atmosphere through a 3-cm-dimater opening. When x = 3 m, y = 2.5 m and z = 2 m, the pipe friction head loss along the entire length of the pipe has been shown to be hf = 3.7 V 2 /(2g) empirically, where V is the velocity in the pipe. Estimate the horsepower to be delivered by the pump.
Estimate the power of the Complexe Desjardins fountain: the jet rises to about 20m and the pipe has a diameter of about 10cm... consider the water jet as a succession of cylindrical balls and the density of the water is 1000 kg/m^3
pls replyy Gasoline (SG-0.7) flows down an inclined pipe whose upper and lower sections are 90 mm (section 1) and 60 mm (section 2) in diameter respectively. The pressure and velocity in section 1 are 280 kPa and 2.3 m/s respectively. If the difference in elevation between the 2 sections is 2.5m, find the pressure at point 2.
A 250mm diameter horizontal jet discharging at 491 L/s impinges on a vertical flat plate. Which of the following most nearly gives the force exerted by the jet on the plate if the plate moves at 2m/s in the same direction as the jet?
The open stream of water seen in the following picture emerges from a nozzle into the atmosphere at sea level, where it then collides with a stagnation tube. If we exclude losses and assume that the pressure at the centerline of section 1 is 110 kPa, we can estimate that the (a) the mass flow measured in kilograms per second (kg/s), and (b) the height, measured in meters, of the fluid in the stagnation tube.
A soda straw is 20 cm long and 2 mm in diameter. It deliverscold cola, approximated as water at 10°C, at a rate of 3 cm3/s.(a) What is the head loss through the straw? What is the axialpressure gradient ∂ p/∂ x if the flow is (b) vertically up or(c) horizontal? Can the human lung deliver this much flow?
A 3-in diameter horizontal water jet having a velocity of 140 ft/s strikes a curved plate, which deflects the water 180 degrees at the same speed. Ignoring the frictional effects, determine the force required to hold the plate against the water stream. Please no conversion need it, only the 3in into .25feet, please. for me, I got 3.71KN on the x-axis.
Once it has been started by sufficient suction, the siphon in the Fig. will run continuously as long as reservoir fluid available. Using Bernoulli's equation with no losses, show (a) that the exit velocity V2 depends only on gravity and the distance H and (b) that the lowest vacuum pressure occurs at point 3 and depends on the distance L+H
Water at 20 ° C flows down through a vertical, 6-cm diametertube at 300 gal/min, as in Fig. P3.74. The flowthen turns horizontally and exits through a 90 ° radial ductsegment 1 cm thick, as shown. If the radial outflow is uniformand steady, estimate the forces ( F x , F y , F z ) required tosupport this system against fluid momentum changes.
Consider inviscid flow along the streamline approachingthe front stagnation point of a sphere, as in Fig. Find(a) the maximum fluid deceleration along this streamlineand (b) its position.
Water at 20 ° C fl ows steadily through the tank in Fig.P3.101. Known conditions are D 1 = 8 cm, V 1 = 6 m/s, andD 2 = 4 cm. A rightward force F = 70 N is required to keepthe tank fi xed. ( a ) What is the velocity leaving section 2?( b ) If the tank cross section is 1.2 m 2 , how fast is the watersurface h ( t ) rising or falling?