A user opens three browsers on the same PC to access www.cisco.com to search for certification course information. The Cisco web server sends a datagram as a reply to the request from one of the web browsers. Which information is used by the TCP/IP protocol stack in the PC to identify which of the three web browsers should receive the reply? Group of answer choices The destination port number The destination IP address The source IP address The source port numb

Q: You are sending a request to retrieve a web page from the Liverpool FC website (Liverpoolfc.com ~ IP…

A: Given IP address of Liverpool is 13.32.45.40 IP address of personal pc is 10.0.0.4 Both are present…

Q: The Bridge is used to Connect Two Different LANS or Two Segments of the Same LAN depending on IP…

A: The solution to the given problem is below.   ***Note: According to Bartleby policy we are not…

Q: lo por

A: Given: In a Linux System sudo tcpdump -vX -I lo port 514 echo “hello” | nc -4u -q1 127.0.0.1 514…

Q: Q. A router has the following IP address on Ethernet0: 172.16.2.1/23. What can be valid host IDs on…

A: INTRODUCTION: The internet protocol address (IP address) is a unique number that is connected with…

Q: Which of the following port scans attempts to initiate a communication channel via every available…

A: TCP FIN scan is used to determine if ports are closed on the target machine. This type of scanning…

Q: hich of the following are the identification fields for a UDP socket? destination IP, destination…

A: A socket is a unique identifier for a process on a system. A system can have connections with more…

Q: When you run a scan on your computer, you see a session with a host at the IP address What protocol…

A: Given IP address is  208.85.40.44:443  Port 80 indicates this is an HTTP session.   Port 80/HTTP is…

Q: I ran the ipconfig command on my computer and it reports an IP address 169.254.75.10 on the ethernet…

A:

Q: 9. You are the Network Engineer of a firm that needs to subnet a Class C IP address range of…

A: Below I have provided the handwritten solution of the given question:

Q: The below DHCP Server is configured to server the connected Clients accordingly. DHCP Server IP…

A: Solution:  IP address conflict :The conflict of IP addresses  happens when two or many devices in…

Q: The SEU has deployed Routing Information Protocol (RIP) as their routing protocol. Recently, a User…

A: Given information : Routing Information Protocol (RIP) has been deployed in the setup. User reports…

Q: Which of the below statements is not true about Exterior Gateway Protocol? An Exterior Gateway…

A: let us see the answer:- Introduction:- The correct option is d)  i.e. Exterior Gateway Protocols…

Q: The Network Administrator wasn't able to perform ping to the domain controller after setting all the…

A: The Network Administrator wasn't able to perform ping to the domain controller after setting all the…

Q: Match the given description to the correct switching domain. If the links are configured as full-…

A: Collision domain: Broadcast Domain: In collision domain the traffic flow is from backward and…

Q: Before data can be sent using TCP, a connection must be established first. This connection…

A: TCP is connection oriented.This means that a connection is needed to established between the sender…

Q: To test DNS configuration by resolving a host name to an IP address, which commandor commands can…

A: To test DNS configuration by resolving a hostname to an IP address, the following command can be…

Q: A network administrator configures the interface Gi7 on R1 with the command ip address 178.18.28.234…

A:

Q: In case of Network Address Translation (NAT), the host at private IP address 192.168.100.3 is…

A: This is network related question.

Q: D. ip route 0.0.0.0 0.0.0.0 19 5. Which of the following types of addresses are automatically added…

A: Types of addresses are automatically added to the routing table

Q: You are at a command prompt and you use the ping program to verify if the computer named…

A: Below i have answered:

Q: When a host on network A sends a message to a host on network B, which address does the router look…

A: We are going to understand which address is used by router when sending packets from host on network…

Q: How many packets must be sent between a client and server for both sides to establish a TCP…

A: There are 3 Packets must be sent between client and server for TCP connection they are (SYN, SYN +…

Q: When a fresh IP configuration is required, DHCP clients issue a DHCPREQUEST packet. Is this true or…

A: DHCP  Dynamic Host Configuration Protocol is a network management protocol. It is used on Internet…

Q: Your corporation hosts a website at the static public IP address 92.110.30.123. A router directs…

A: I would answer only for first question. If you want answer for other questions, then post them…

Q: During the process of redistributing a route into EIGRP, which parameter has to be specified? Exit…

A: Introduction: Redistribution is the use of a routing system to promote routes that have been learnt…

Q: The differences between Static Routing and Dynamic Routing that is the Static routing is used in…

A: The correct answer options are provided with explanation for question 1,2 and 3   in below steps

Q: Q1) Refer to the exhibit. NAT is configured on Remote and Main. The PC is sending a request to the…

A: the packet is send from main to remote web server .therefor it will use a global IP address.and the…

Q: A system administrator at a SOHO remote site would like to modify the range of…

A: The DHCP configuration of a SOHO router can be configured with the beginning and ending DHCP address…

Q: • Host A and Host B are connected to a network. Packets sent from Host A to Host B transit through…

A: The answer is

Q: V4 packet is 1000. How many b

A: The binary value of HLEN in an IPV4 packet is 1000. How many bytes of data are transported by this…

Q: You are given the IP address 199.10.10.0/24, and are required to connect 22 departments (LANs)…

A: given IP is, 199.10.10.0/24 means the first 24 bits are reserved, ie. the first 3 blocks. then there…

Q: Which of the following method is not used to tackle IPV4 address space limitations? Choose one a.…

A: I have answered both the parts and have provided necessary explanation with it.

Q: which of the following is the valid host range for the subnet on which the ip address…

A: The answer for the given question is as follows.

Q: Complete the frames (x & y) given below with appropriate port, IP and MAC addresses. The sender Host…

A: NOTE: IP has been assumed as shown in the question. For actual IPs. We can make 3 subnets, each with…

Q: Which of the following statements is NOT true about TCP SYN/ACK host scanning attacks?   Question…

A: Option a) is true as Attacker sends a TCP SYN/ACK segment to a target host repeatedly to all ports…

Q: The Domain Name System (DNS) translates domain names, significant bits of text, to IP addresses…

A: other protocols are prone to amplification

Q: EtherNet/IP communications that are used for real-time l/O data transfers that must occur at very…

A: Before stating the correct answer first let's know about the Ethernet/IP technology. Ethernet/IP has…

Q: Question 2 You need to create 8 subnets in the 192.168.1.0/24 network. What is the new network mask…

A: Hi, since there are multiple questions in this post, as per our policy, I'll answer the first…

Q: Router R6 is running OSPF. On R6, I set LoopbackO interface IP address to 6.6.6.6/32 and in R6 OSPF…

A:

Q: Which type of IPV6 address is used to send a single IPV6 packet to multiple destinations? a.…

A: Question from basics of IPv6, we have different types of addresses in Ipv6 like Multicast, Unicast…

Q: Which of the following is the valid host range for the subnet on which the IP address…

A: If we perform logical  AND between IP address   192.168.168.188 with subnet mask 255.255.255.192.…

Q: The ___________ command is used to display the full TCP/IP configuration for all adapters for a…

A: Command for displaying full TCP/IP configuration Ipconfig/all is the command used for renewing a…

Q: Q6) The administrator assigns an IP address to an interface and activate it. Which route should…

A: Answer: b. C 192.168.0.0/24 is directly connected, FastEthernet 0/0

Q: sume a device with IP address 120.240.57.161/24 wants to send an IP packet te vice, and it only…

A: The source IP address is 120.240.57.161/24 Here the destination IP address is 120.241.57.40 Now the…

Q: A technician is troubleshooting a home network connectivity issue with a user's desktop configured…

A: Given questions are both true or false and multiple choice questions so we provide both true and…

Q: In case of Network Address Translation (NAT), the host at private IP address 192.168.100.3 is…

A: 1) Source IP: 192.168.100.3 Source Port: 3855 Destination IP: 209.131.36.15 Destination Port: 80 2)…

Q: What is the maximum number of IP addresses that can be assigned to hosts on a local subnet that uses…

A: Given: What is the maximum number of IP addresses that can be assigned to hosts on a local subnet…

Network Protocols

A network protocol is a set of rules that govern how data is exchanged between the devices in a network. Network protocols enable communication between devices that are located in different parts of the world. Consequently, they are critical in today's digital communications.