You are at a command prompt and you use the ping program to verify if the computer named server1.mycompany.local is responding. You are capturing the packets created by the ping program and notice some packets that are not using the ICMP protocol. One of the packets contains the IP address of server1.mycompany.local. What protocol was used to get the server's IP address? a. DNS b. ARP c. MAC d. TCP

You are at a command prompt and you use the ping program to verify if the computer named server1.mycompany.local is responding. You are capturing the packets created by the ping program and notice some packets that are not using the ICMP protocol. One of the packets contains the IP address of server1.mycompany.local. What protocol was used to get the server's IP address? a. DNS b. ARP c. MAC d. TCP

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter7: Setting Up A Local Network

Section: Chapter Questions

Problem 5TC

See similar textbooks

Similar questions

Your network contains a device that has an Ethernet NIC and is set up with a static IPv4 configuration. Which two of the IPv4 parameters that are stated below will be included in the IPv4 setup of the personal computer? Traceroute server's Internet Protocol address DHCP Server address IP address that is private to the PC DNS server address
In packet tracer application, which of the following is used to view the last command applied in CLI? Up Arrow Right Arrow Ctrl-C Left Arrow What is the IEEE specification for Spanning Tree Protocol? 803.1 803.ud 802.1d 802.9
From your laptop, you need to remote into a switch to make some configuration changes.Which Transport layer protocol and TCP/IP port should you open in Windows Firewall tomake this work using Telnet?a. UDP, port 23b. TCP, port 23c. UDP, port 22d. TCP, port 22e. UDP, port 21
q27- When a host on network A sends a message to a host on network B, which address does the router look at? a. Port b. Logical (IP address ) c. Non of the mentioned d. Physical (MAC address) Clear my choice
In a Linux System sudo tcpdump -vX -I lo port 514 echo “hello” | nc -4u -q1 127.0.0.1 514 Complete the following: (ix) In Wireshark what was the sender and destination IP? (x) What is the hash of the packet? (xi) What is the hash of the content (xii) Did the destination reply?
You work at a help desk and have just received a call from an employee who says she can’t access network resources. You want the employee to view her IP address configuration. Write an e- mail to the employee, explaining what command-line program to use and how she can use it to find the information you need. After following your instructions, the employee tells you that her IP address is 169.254.14.11 with the subnet mask 255.255.0.0. What conclusion can you make from this information?
Your network has a static IPv4-configured Ethernet NIC device. Which two IPv4 parameters below will be included in the PC's IPv4 setup? Traceroute server's IP. PC-private DHCP server address DNS server address
You suspect the DHCP server's settings are to blame for the issue you're debugging. Clients are assigned IP numbers and can ping local and remote hosts, but they are unable to load web sites. What may have caused the DHCP server's settings to be incorrect? a) Inaccurate ntp server b) Using the wrong DNS server c) Incorrect entry point Subnet mask error (d)
Which of the following statements best describe middlebox devices?a. Middlebox device act as network hubs that forward data to multiple devices.b.Middlebox devices operate only in the network layer.c.Middlebox devices are routers that process, modify, and forward IP packetsd.A firewall is a type of middlebox device.
A.You are working as a network engineer at Shell Info. The organization uses Cisco's IOS on all of its workstations. The network administrator has asked you to use the route utility to delete some static routes used by the router. Which of the following commands will you use in this scenario? 1.route 2.show ip route 3.route print 4.show running-config
Question4 Write a script using ping and fping that does the following: asks for your first and last names, does six pings with ping, then one ping with fping simply to say a system is alive, then I want the software to say Hello your name> The system ip address> is alive (or) not alive. Please provide the screenshots.
A system administrator at a SOHO remote site would like to modify the range of automatically-assigned IP addresses. Which of the following should be modified on the SOHO wireless router?WPA2 security modePrimary and secondary DNSDMZ interfaceMAC filteringDHCP ending address