A vacuum-propelled capsule for a high-speed tube transportation system of the future is being designed for operation between two stations A and B, which are 11.5 km apart. If the acceleration and deceleration are to have a limiting magnitude of 0.53g and if velocities are to be limited to 435 km/h, determine the minimum time t for the capsule to make the 11.5-km trip. 11.5 km B Answer: t = min

A vacuum-propelled capsule for a high-speed tube transportation system of the future is being designed for operation between two stations A and B, which are 11.5 km apart. If the acceleration and deceleration are to have a limiting magnitude of 0.53g and if velocities are to be limited to 435 km/h, determine the minimum time t for the capsule to make the 11.5-km trip. 11.5 km B Answer: t = min

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A steel ball was released from rest into a cylinder full of water. the downward acceleration up the ball is defined by the equation a=0.9g-CV. whose g is accelerating due to gravity. C=3.02/s. Det. the velocity in m/s after 0.25mins. a) Det. the dept of the ball from the water surface after 0.25 mins. b.) when of the following most nearly gives the acceleration of the ball when it reaches the bottom if the total height of the cylinder is 50 ft?
A sphere is fired downward into a medium with an initial speed of 37 m/s. If it experiences a deceleration of a=(−6t)m/s^2, where t is in seconds, determine the distance traveled before it stops. Express your answer to three significant figures and include the appropriate units.
The radius of a highway curve is 120m, and has an angle of 9.31 from the horizontal. The center of gravity of the car is located 0.80m above the roadway and the distance between the two front wheels is 1.2m. if the car has a total weight of 15KN, a. Determine the normal acceleration (m/s2) and the velocity (in kph) of the car before overturning? Assume that friction is great enough to prevent sliding. b. Find the maximum velocity of the car could move in the curve so that there will be no pressure between the tires and the roadway, kph. c. What is the velocity of the car to prevent sliding up if the coefficient of kinetic friction is 0.60?
Steep safety ramps are built beside mountain highways to enable vehicles with defective brakes to stop. A 10-ton truck enters a 15° ramp at a high speed v0 = 108 ft/s and travels for 6 s before its speed is reduced to 36 ft/s. Assuming constant deceleration, determine (a) the magnitude of the braking force, (b) the additional time required for the truck to stop. Neglect air resistance and rolling resistance.
An experimental rocket sled weighs 5000 lb and is propelled by six rocket motors each with an impulse rating of 8250 lb-sec. The rockets are fired one after the other at 1.5-sec intervals, and the duration of each rocket firing is 2.0 sec. If the velocity of the sled 11.7 sec from the start is 189 mi/hr, determine the time average R of the total aerodynamic and mechanical resistance to motion. Neglect the loss of mass due to exhausted fuel compared with the mass of the sle
a driver is traveling in a curved section of a roadway with a diameter of 1mi the driver is traveling at a velocity of 100 ft/s and suddenly applied brakes causing the car to slow down at a constant rate. if after 0.25mins the speed reduced to 25 mph. a) determine the car's tangential acceleration.b) Determine the car's normal acceleration.c) what was the car's acceleration after applying brakes?
A motorboat and its load weigh 2150 N. Assume that the propeller force is constant and equal to 110N, and the water resistance is numerically equal to 6.7V, where V is the speed at any instant time in m/sec. If the boat starts from rest, determine its distance at the end of 10 seconds.
A motorboat and its load weigh 2150 N. Assume that the propeller force is constant and equal to 110N, and the water resistance is numerically equal to 6.7V, where V is the speed at any instant time in m/sec. If the boat starts from rest, determine its speed at the end of 10 seconds.
Problem No. 1 Traveling with an initial speed of 70 km/h, a car accelerates at 6000 km/h2 along a straight road. How long will it take to reach a speed of 120 km/h? Also, through what distance does the car travel during this time? Problem No. 2 The acceleration of a particle along a straight line is defined by a = (2t - 9) m/s2, where t is in seconds. At t = 0, s = 1 m and v = 10 m/s. When t = 9s, determine (a) the particle’s position, (b) the total distance traveled, and (c) the velocity
Collar A has a mass of 3 kg and is attached to a spring of constant 1200 N/m and of undeformed length equal to 0.5 m. The system is set in motion with r = 0.3 m, v0 = 2 m/s, and vr = 0. Neglecting the mass of the rod and the effect of friction, determine (a) the maximum distance between the origin and the collar, (b) the corresponding speed. (Hint: Solve the equation obtained for rby trial and error.)
A carnival ride is designed to allow the general public to experience high acceleration motion. The ride rotates about Point O in a horizontal circle such that the rider has a speed v0. The rider reclines on a platform A. The platform and the riders (80 kg total) can move up and down the inclined wall as the speed of the ride increases. The coefficient of static friction between the wall and the platform is 0.29.Determine the range of values of the constant speed v0 for which the platform will remain in the position shown.
During braking, a truck has a steady deceleration of 7.0 m/s². A box sits on the platform of this truck. The box begins to slide when the braking begins and, after sliding a distance of 2.0 m (relative to the truck), it hits the front of the truck. With what speed (relative to the truck) does the box hit? The coefficient of kinetic friction for the box is μk=0.50.