A very thin rod carrying linear charge density A lies in the ay plane making angle 1/4 with the x axis as shown in the figure. The x coordinates of the left and the right ends of the rod are a and b, respectively. Find the electric potential at the origin (point O), sin(7/4) = cos(T/4) = (k is the Coulomb's constant.). y T/4 x=a x=b Select one: kA In(1+ v2ª + b, a +b, |kA In(1+ª+°,

A very thin rod carrying linear charge density A lies in the ay plane making angle 1/4 with the x axis as shown in the figure. The x coordinates of the left and the right ends of the rod are a and b, respectively. Find the electric potential at the origin (point O), sin(7/4) = cos(T/4) = (k is the Coulomb's constant.). y T/4 x=a x=b Select one: kA In(1+ v2ª + b, a +b, |kA In(1+ª+°,

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter5: Electric Charges And Fields

Section: Chapter Questions

Problem 123AP: Calculate the electric field due to a uniformly charged rod of length L, aligned with the x-axis...

See similar textbooks

Similar questions

Calculate the angular velocity of an electron orbiting a proton in the hydrogen atom, given the radius of the orbit is 0.5301010 m. You may assume that the proton is stationary and the centripetal force is supplied by Coulomb attraction.
Which of the following is least likely to always hold valid aboutequipotential surface(s) and/or line(s)?
Compute for the work done, in millijoules, in moving a 8-nC charge from A(0, 0, 1) m to B(0, 0, 7) m against the electric field due to a ring charge of radius 9 m on the plane z = 0 centered at the origin. The ring has a total charge of 8 mC.
Describe schematically the equipotential surfaces corresponding to(a) a constant electric field in the z-direction,(b) a field that uniformly increases in magnitude but remains in a constant (say, z) direction,(c) a single positive charge at the origin, and(d) a uniform grid consisting of long equally spaced parallel charged wires in a plane.
This is a theoretical problem: Imagine a disk of uniformly distributed charge Q with radius R in the plane Z-Y, with its center in the coordinate origin. There's a point P at a distance X (on the X axis).Now imagine a ring of uniformly distributed charge Q with radius R in the plane Z-Y, with its center in the coordinate origin. There's a point P at a distance X (on the X axis). Q, R, and P (thus X) are equal in both cases. Which of these is true for he electrical field on the point P: E(disk) < E(ring) E(disk) > E(ring) E(disk) = E(ring) E(disk) = E(ring)/2 The given information is not enough to make a comparison. Justify your answer for each possibility.
Protons are projected with an initial speed υi = 9.55 km/s from a field-free region through a plane and into a region where a uniform electric field E→ = 2720ĵ ⁄ NyC is present above the plane as shown. The initial velocity vector of the protons makes an angle θ with the plane. The protons are to hit a target that lies at a horizontal distance of R = 1.27 mm from the point where the protons cross the plane and enter the electric field. We wish to find the angle θ at which the protons must pass through the plane to strike the target. (a) What analysis model describes the horizontal motion of the protons above the plane? (b) What analysis model describes the vertical motion of the protons above the plane? (c) Argue that Equation 4.20 would be applicable to the protons in this situation. (d) Use Equation 4.20 to write an expression for R in terms of υi , E, the charge and mass of the proton, and the angle θ. (e) Find the two possible values of the angle θ. (f) Find the time interval…
In concntric spherical shells w/c is equipotential surface, what is the work done in moving a charged particle q = 1C at a distance of 0.5m at the same potential -10V after t=0.0002 sec
I drew eqipotential lines that are perpendicular to the elctric filed lines in the paralell plates but I drew them straight with one aroow in the middle of the lines. Should that be fine?
Prove that a perfect metal surface is an equipotential.
Given that point p is a proton
Use the dipole approximation to find what the potential (magnitude and sign) would be at point A and point B
A proton, mass 1.67 x 10-27 kg, is projected horizontally midway between two parallel plates thatare separated by 0.10 cm, with an electrical field with magnitude 470,000 N/C between the plates.If the plates are 2.90 cm long, find minimum speed of the proton that just misses the lower plate asit emerges from the field.