A vial of blood was placed at a height of 1.2 meters from a needle used to transfer blood to the patient. If the inner diameter of the needle is 0.34 meters and its length is 3 cm, and the time rate of blood flow through the needle is 4.4 cm 3 /minute. Find the viscosity of the blood, given that the density of blood is 1.1×10³ kg/m³?

A vial of blood was placed at a height of 1.2 meters from a needle used to transfer blood to the patient. If the inner diameter of the needle is 0.34 meters and its length is 3 cm, and the time rate of blood flow through the needle is 4.4 cm 3 /minute. Find the viscosity of the blood, given that the density of blood is 1.1×10³ kg/m³?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 107AP: (a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using...

See similar textbooks

Similar questions

What is the mass deep breath of air having a volume of 2.00 L? Discuss this effect taking such a breath has on your body's volume and density.
A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
Prove the sped of an incompressible fluid through a constriction, such as a Venturi tube, increases by a factor equal to the square of the factor by which the diameter decreases. (The converse applies for flow out of a constriction into a larger-diameter region.)
Suppose you have a coffee with a circular cross-section and vertical sides (uniform radius). What is its inside radius if it holds 375 g of coffee filled to a depth of 7.50 cm? Assume coffee has the same density as water.
How would you determine the density of an irregularly shaped rock?
A commonly used turn of mass in the English system Is the pound-mass, abbreviated Ibm, where 1 Ibm = 0.454 kg. What is the density of water in pound-mass per cubic foot?
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
A rectangular gasoline tank bold 30.0 kg of gasoline when full. What is the depth of the tank if is 0.500-m wide by 0.900-m long? (b) Discuss whether gas tank has a reasonable volume for a passenger car.
(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.
Suppose that it takes 15.3 hours to drain a container of 72.7 m3 of water. What is the "mass flow rate," of water from the container?
Suppose that it takes 10 hours (h) to drain the container of 5700 cubic meters of water. What is the "mass flow rate," in kilograms per second, of water from the container?
A cylindrical tank with a large diameter is filled with water to a depth D = 0.30 m. A hole of cross-sectional areaA 6.5 cm2 in the bottom of the tank allows water to drain out. (a)What is the drainage rate in cubic meters per second? (b) At whatdistance below the bottom of the tank is the cross-sectional area ofthe stream equal to one-half the area of the hole?