50)A voltage wave is represented byv=200 sin 314 t.Find ((c) Averagevalue (d) Frequency (e) Time period (f) Instantaneousvalue after 0.05 sec.

Answered: A voltage wave is represented by v=200…

A voltage wave is represented by v=200 sin 314 t. Find C (c) Average value (d) Frequency (e) Time period (f) Instantaneous value after 0.05 sec.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10MCQ: The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero

See similar textbooks

Related questions

Q: Problem 12. A current of 5 A flows in the winding of an electric motor, the resistance of the…

A: Given: Current flowing in winding, I=5 A. Resistance of the winding, R=100 Ω.

Q: Describe the operation of a see-through latch and its potential applications.

A: Answer: to describe the operation of see- through latch

Q: 3 Part 3 of 3 ! Required information NOTE: This is a multi-part question. Once an answer is…

Q: circuit in the figure? 200 rad/s tiniz 552 ww 0.1mF L

Q: 15. In measurement of impulse voltage by using a resistance divider, its low voltage side is…

A: Given, Input impedance, Zin = 1 MΩ, and, Characteristic impedance, Zo=75Ω

Q: Draw schematics for the following circuits. Please provide an extra sheet of paper for your…

Q: maximum demand 15 oad Find (a) plant capacity factor, (b) load factor, (c) utilization factor, (d)…

A: It is given that: maximum Load(Pmax)=500 MWminimum LoadPmin=400 MWcapacity of plant=750 MW

Q: Q1: What is the value of the unknown resistor R in figure shown, if the voltage drop across the 500…

Q: Calculate the total capacitance for the given CIRCUIT, the charge Q For each capacitor, and the…

Q: Find the unknown quantities for the circuit below using the information provided. E + RT 2 A 6Ω 12…

Q: An antenna with power P= 2.2 x 10^3 W is radiating spherical electromagnetic waves. Consider a place…

A: We need to find out maximum value of electric field .

Q: Q1. A discrete-circuit BJT CE amplifier is given below with ß = 100, VBB = 4 V, Rc = 3 kn, RBB = 50…

Q: In a series L-C circuit, the inductance and capacitance are 5 H and 2 HF respectively. of the…

A: Given data, Capacitance is given as C=2 μF. Inductance is given as L=5 H.

Q: A tuned circuit of the oscillator in a simple AM transmitter employs a 50 µH coil and a 1 nE…

A: Given: L and C values of an oscillator to produce carrier signal for AM, L=50μH, C= 1nF, Frequency…

Q: Question 2 A supply voltage V (t) = 24 sin(4000mt) [V] is applied across a R-L-C circuit shown…

Q: For this assignment you will be designing a power supply circuit for windshield heating element and…

A: According to the question, we need to design a power supply circuit for windshield heating element…

Q: Consider the circuit shown in Figure 6. Assume that R₁, R2 and C₁ are known and that the input…

Q: Q1) Given the signaly(t) as below, If y(t)=x(2t-1) i) Find and draw the odd component of y(t)…

A: Given: A signal y(t) as, To find and draw: a) Odd component of y(t). b) x(t), where y(t)=x(2t-1),…

Q: Problem1. Find i(t) and V(t), if i(0) = 10A. 5 www 2H i(t) 1 Solve using differential equations!!! +…

Q: Find the periodic time for the following wave forms, (a) 60Hz ( b) 1000Hz

Q: Design an ammeter and voltmeter that work in one switch, the current is one milliamp, the internal…

A: In this question We need to design an multimeter for measure the different different voltage. We…

Q: A resistor and capacitor are connected in parallel to a 277-V, 60-Hz power source. The resistor has…

Q: A system is described by the state equation 21 21 = [²₁][²²] + [²] ₁ = u. The state transition…

A: We need to find out state transition Matrix for given system .

Q: Q2 Determine the current Iy in figure shown by using Nodal analysis method. 20 30 w 40 10 SA 20

Q: 7. 1 ΚΩ Given the following circuit, find Io. Must use Norton's Theorem. 5V (+ 1.5ΚΩ www 1mA (1) 1.5…

Q: At inversion, the surface pf an NMOS transistor is ??

Q: 5. A 3-phase 60 MVA, 13.8 kV, 3600 rpm, 60 Hz grid connected generator with a synchronous reactance…

A: Given information a three phase synchronous machine which is operated as a generator is, Rated…

Q: 7.48 What is the output voltage for the below circuit?

A: It is given that:

Q: PROBLEM 5 What is the pitch factor of a 14 pole alternator that has an armature with 378 slots. The…

A: In this question We need to pitch factor of the alternator. Given number of poles P= 14 Slots =…

Q: -30 S O 1 6 μF Figure 6.63 For Prob. 6.31. 2 I 3 4 5 LO 4 μF = +21 V t

A: Answer : given that initial capacitor voltage V(0) = 0 to find the current and voltage across the…

Q: Q 4) Perform a mesh analysis on the following circuit. 3 Ω I -j3 Ω 1+j2 Ω 8/30° A I, 15 Ω I, 2Ω +…

A: Given a circuit To perform mesh analysis on the given circuit.

Q: P4: In the following transmitter/Receiver (Transceiver) system shown below find: H(w) m(t) =…

A: We need to find out unknown values for DSB modulation and de modulation .

Q: D

Q: 2. Determine the inverse Fourier transform of: a. X (ω) = 2πδ(ω) + πδ(ω – 4π) + πδ(ω + 4π) b. X₂(w)…

A: We need to find out the inverse Fourier transform of given signal.

Q: F(A,B,C,D,E) = Σm (0,3,7,12,17,19,22) + d(1,2,6,9,13,15,16,18,23,24,25,26,27,31), find the…

Q: Find and sketch the digital convolution of two discrete-time signals shown in Fig. 2.1. 25 1.5 0.5 1…

A: Given: Two signals x(n) and h(n) as, To find: Convolution of x(n) and h(n).

Q: 5. For the circuit shown below, assume ideal Op-Amp and Vin = IV. Find the value of the current ix:…

A: We need to find out unknown current for given circuit.

Q: Consider the circuit below. For t 4 s. 2. Va + 8 A↑ 10 Va 1Ω 202 www. 14 202 2 mH T Given Answe…

Q: (2) Derive the Laplace transform for the following time functions: (a) tu(t) (b) t'u(t) (c) e…

A: Given, a) tu(t) b) t3u(t) c) e-atcosωtut

Q: For the circuit shown below in Figure 1, derive the Norton equivalent circuit at the load resistor,…

A: The given circuit diagram is shown below,

Q: If the forward voltage drop on a diode is 774 mV, what is the current passing through it? Assume I s…

Q: F(J, K,L,M) = = IIM (0,1,4,5,8,10,12,14), find the simplified POS.

A: We need to find out simplified form of given Max term function .

Q: 4. Determine the node voltages, V₁ and V₂, using nodal analysis. IDA GA 102 W 482 242 18A

A: Given data, Circuit is given as:

Q: 4. Given the following circuit, solve for the energy stored by the Capacitor and Inductor. 4 ΚΩ 2Η…

A: We need to find out energy stored by inductor and capacitor Whenever Dc sources are applied,…

Q: In the common-gate amplifier circuit of Fig. 6, Q1 has k-2 mA/V2, VA-20 V. Q2 and Q3 are identical.…

Q: Use mesh/loop analysis Given a = 2, b = 4, c = 2, d = 1, e = 2, f = 3, g = 6, h = 5, x = 0, y = 0…

Q: Vi 1 k 10 k O 10V 10 k 3 k Vo Find the lower trigger point (LTP) and upper trigger point (UTP), and…

Q: h Calculate the current through the zener diode for the given values of input (source) voltage in…

Q: Find the total transfer function using Matlab.

A: Given: A negative feedback closed loop control system as, where, G=1s2-3s+1, H=1, To find:…

Q: a) The input and impulse response of an LTI system is depicted in Figure 3.a. Solve and sketch the…

A: it is asked to solve and sketch the output of the system for given input and impulse response

Question

50)
A voltage wave is represented by
v=200 sin 314 t.
Find (
(c) Average
value (d) Frequency (e) Time period (f) Instantaneous
value after 0.05 sec.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Different Types of System and Its Property

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A sinusoidal wave is given by v(t)=10*cos(177*t+1.5)[V]. Determine: a) The peak amplitude b) the peak-to-peak value c) the angular frequency w0 in [rad/s]
54. Practical average value of a sinusoidal wave is taken only at three cycles. True False 55. In a sinusoidal waveform, effective value is equal to (1/1.4142) of its peak to peak value. True False 63. For a practical inductor, the voltage leads the current by an angle of more than 90 degrees. True False
If V = 60V at α = 30° and t = 1.5 ms, determine the mathematical expression for the sinusodial voltage
4.2 A wave of sinusoidal nature has an angular velocity of 314.16 rad/s and has a particle displacement of 22.825 m after 6 ms.4.2.1 Draw the wave on the graphing paper below. Clearly show the calculations and indicate/highlight the amplitude, period of one of the cycles and the point of displacement described above.
An alternating voltage is given by v = 20 sin (100πt – π/2) volts. Find (a) the amplitude, (b) thepeak-to-peak value, (c) the r.m.s. value, (d) the periodic time, (e) the frequency, and (f) type ofcircuit if voltage is 200 sin 100πt.
The voltage between lines in a transmission line is the maximum value of the sine waveform. Select one: O True O False
A sinusoidal voltage trace displayed by an oscilloscope is shown, if the 'time/div' or Hs, switch is set to 0.2 us/div and the 'volts/div' Vs, switch is set to 50 mV/div, from the waveform, the frequency and the maximum voltage of the sinusoid is
A triangular voltage wave has the following values over one half-cycle, both halves being symmetrical about the zero axis: Time (ms) 0 10 20 30 40 50 60 70 80 90 100Voltage (V)0 2 4 6 8 10 8 6 4 2 0 Plot one half-cycle of the waveform and determine: (i) The average value (ii) the r.m.s. value(iii) the form factor. (with proper steps and graph and diagram)
A wire is carrying a direct current of 20 A and a sinusoidal alternating current of peak value 20 A. Find the rms value of the resultant current in the wire.
15. If a non-electrolytic capacitor with a maximum voltage rating of 100v is connected to an AC signal, what is the largest RMS voltage that can be used?
1. An alternating voltage is given by v = 20 sin (100πt – π/2) volts. Find (a) the amplitude, (b) the peak-to-peak value, (c) the r.m.s. value, (d) the periodic time, (e) the frequency, (f) type of circuit if voltage is 200 sin 100πt
44. The equation for 60 cycles current sine wave having RMS value 30 amperes, will be __ A. 42.4 sin120pi t Amp B. 30 sin 120t AmpC. 30 sin60t AmpD. 42.4 sin 60pi t Amp