A welding operation is time-studied during which an operator was pace-rated as 120%. The operator took, on an average, 8 minutes for producing the weld-joint. If a total of 10% allowances are allowed for this operation. What is the expected standard production rate of the weld-joint in units per 8 hour day

A welding operation is time-studied during which an operator was pace-rated as 120%. The operator took, on an average, 8 minutes for producing the weld-joint. If a total of 10% allowances are allowed for this operation. What is the expected standard production rate of the weld-joint in units per 8 hour day

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter14: Gas Metal Arc And Flux Cored Arc Welding Of Pipe

Section: Chapter Questions

Problem 17R: Why would it be a good idea to increase the welding travel speed as a filler weld is being ended?

See similar textbooks

Similar questions

Does it matter if one of the tack welds breaks during welding? Why?
Why is cost a consideration in joint design?
Why would it be a good idea to increase the welding travel speed as a filler weld is being ended?
What arc problems can occur in deep or narrow weld joints?
As stricter standards are applied to the welding process, what happens to the cost of the weldment?
Discuss the arc welding quality and type of defects involved? What are the inspection and testing methods available to check the quality of the weld joint?
Select an appropriate weld technique and joint design for welding 150mm of thick material.
Assume that two 1.5-mm thick steel sheets are being spot welded at a current of 4000 A and current-flow time is 0.3 s. Using electrodes 5 mm in diameter, estimate the amount of heat generated and the amount of heat required to melt the weld nugget. Use an effective resistance of 350 un. Take u= 9,7 Joule/mm Which one of the following are correct? O a. If the electrodes were 7 mm diameter, the amount of heat generated would decrease b. The amount of heat generated by the equipment is between 1600 to 1700 Joules c. The equipment has enough power to weld the steel sheets. d. The equipment does not have enough power to weld the steel sheets e. The amount of heat required is between 700 and 750 Joules
Give detail classification of all welding processes and their practical applications
Calculate the heat input during the arc welding process, if the voltage is 33 volts, current is 115 amperes, the length of the weld is 88mm and the time to complete the weld 34 secs.
Enumerate the types of joint in welding.
What do you understand by the term ‘efficiency of a riveted joint’?