Solve fast and correctly please by hand solution ?? You are spot welding two pieces of metal together with one weld. They are 6 mmthick each. The total time it takes to load and unload the metal from the weldingmachine is 2 seconds, which excludes welding time. The maximum current for yourwelder is 3,500 amps. The electrode diameter is 12 mm.Determine the maximum number of complete welds that can be completed in oneminute.

Welding is a manufacturing technique that is done on the metal surfaces. In this operation, the…

Answered: You are spot welding two pieces of…

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter29: Welding Automation And Robotics

Section: Chapter Questions

Problem 16R: Why is it important to make small welds more accurately than large ones?

See similar textbooks

Similar questions

Can a tee weld be strong if the welds on both sides do not have deep penetration? Why or why not?
List the five joint types used in welding.
What are the different classifications of welds that a symbol can indicate?
Calculate the heat input during the arc welding process, if the voltage is 33 volts, current is 115 amperes, the length of the weld is 88mm and the time to complete the weld 34 secs.
What is the cross-sectional area of a V-groove weld that is 6mm wide and 8 mm deep on a 10-mm thick plate having a 2-mm root opening?
During arc welding, the heat input per unit length reduces, with increase of
Explain the process of thermite welding with neat sketch. Write its applications.
assignment#1 Explain the Importance of Welding Process? What are the different types of welding processes and its applications.
A GTAW operation is performed on low carbon steel, whose unit melting energy is 10.3 J/mm3. The welding voltage is 22 volts and the current is 135 amps. The heat transfer factor is 0.7 and the melting factor is 0.65. If filler metal wire of 3.5 mm diameter is added to the operation, the final weld bead is composed of 60% volume of filler and 40% volume base metal. If the travel speed in the operation is 5 mm/sec, determine (a) cross-sectional area of the weld bead, and (b) the feed rate (mm/sec) at which the filler wire must be supplied.
A welding operation is time-studied during which an operator was pace-rated as 120%. The operator took, on an average, 8 minutes for producing the weld-joint. If a total of 10% allowances are allowed for this operation. What is the expected standard production rate of the weld-joint in units per 8 hour day?
It has been reported that gas–tungsten arc welds of aluminum made in the overhead position (assumed lap weld joint) tend to have a significantly higher porosity level than those made in the flat position: a. Explain why b. Sketch the general view of the overhead position c. Indicate where the (most probable) location of the porosity
An RSW operation is used to join two pieces of sheet steel having a unit melting energy of 8369.85 J/cm3. The sheet steel has a thickness of 0.3125 cm. The weld duration will be set at 0.25 sec with a current of 11,000 amp. Based on the electrode diameter, the weld nugget will have a diameter of 0.75 cm. Experience has shown that 40% of the supplied heat melts the nugget and the rest is dissipated by the metal. If the electrical resistance between the surfaces is 130 micro-ohms, what is the thickness of the weld nugget assuming it has a uniform thickness?

SEE MORE QUESTIONS

Recommended textbooks for you

Welding: Principles and Applications (MindTap Cou…

Mechanical Engineering

ISBN:

9781305494695

Author:

Larry Jeffus

Publisher:

Cengage Learning