(a) What will the output voltage become, as 0 -> 0? (b) As @ –> 0? (c) What will be Vout, if = 2000 rad/sec? You may give your answers as maximum voltages or rms voltages, but be sure you specify which. V out 3Ω ɛ = 100sin(t) 2 mH 00000

(a) What will the output voltage become, as 0 -> 0? (b) As @ –> 0? (c) What will be Vout, if = 2000 rad/sec? You may give your answers as maximum voltages or rms voltages, but be sure you specify which. V out 3Ω ɛ = 100sin(t) 2 mH 00000

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 4CQ: For what value of the phase angle between the voltage output of an ac source and the current is the...

See similar textbooks

Related questions

Q: Calculate average and RMS value of the voltage waveform given in Figure. 4V t(ms) ·

A: Given:- A graph is given V vs t as shown below Find:- The rms and the average value of the…

Q: Can the instantaneous power output of an ac source ever be negative? Can the average power output be…

Q: In a technological or engineering application, you have a voltage signal that is given by the…

Q: What will happen to the current in this purely capacitive circuit as frequency increases? 5 V RMS…

A: We know that, in a purely capacitive circuit if frequency increases the current also increases.…

Q: | An alternating voltage is given by the equation v(t) = 50sin(20nt + 20°) Calculate the peak…

A: We have been provided by alternating voltage so we will break it into parts and then find the…

Q: What is the expression for the voltage in an AC circuit if it has a rms voltage of 120 V and a…

Q: The dynamic power of a processor was reduced ONLY by reducing the voltage and not the frequency of…

A: The dynamic power of a processor was reduced ONLY by reducing the voltage and not the frequency of…

Q: • A 4.40@mF and an 8.80@mF capacitor are connected in parallel to a60.0-Hz generator operating with…

A: Given The capacitance of the first capacitor is C1 = 4.40 mF = 4.40 x 10-3 F. The capacitance of the…

Q: When a 4uF capacitor is connected to a generator whose rms output is 30 V, the current in the…

Q: A 24.0 - kΩ resistor connected to an AC voltage source dissipatesan average power of 0.600 W. (a)…

Q: In Europe the standard voltage is 230 V rms at 50.0 Hz. Suppose you take your 6.00-W electric razor…

A: Since you have asked multi-part questions, we will solve the first three parts for you. In case you…

Q: •• Find the average power consumed by an RC circuit connected toa 60.0-Hz generator with an rms…

Q: Calculate the RMS value of the voltage waveform below

Q: A place has electrical outlets which supply alternating currents with V rms = 114V and I rms = 11A.…

A: The electrical power can be of two types, alternating or direct current. As the name suggests, the…

Q: What is the rms current Irms in the circuit when Vrms = 45 V, L = 2.7 mH, and f = 1.5 kHz? 7 0000 To…

A: Inductive reactance is given by XL=ωL=2πfL RMS current is given by VrmsZ

Q: om the An AC voltage source has an amplitude of 96. V and frequency 400. Hz. The voltage was zero…

Q: An AC voltmeter reads 250 V. What is its peak and instantaneous values after 1/400 seconds, if the…

Q: The peak value of an alternating current in a 1900-WW device is 4.2 AA . What is the rms voltage…

Q: Can you measure power in an ac circuit by using an ammeter and voltmeter? If No, why? If yes, how?…

A: D.C voltmeter and ammeter are based on the magnetic effect of current . It reads the average value…

Q: In an AC circuit, the emf (e) and the current n atany instant are given respectively, by e = E, sin…

Q: Determine the frequency and the phase angle between the two voltages v¡(t) = 12 sin (1000t + 60°) V…

Q: ver time, the average voltage of an AC voltage is zero. Yet, an alternating current can do e heating…

A: VMrs = V0 /(2)1/2

Q: Calculate the rms currents for an ac source given by v(t) = Vo sin(wt), where Vo = 160 V and w 340T…

Q: QI-A) A sinusoidal vohage v,(t) = 20 sin wtis passed through half wavarectifier. Find 1) The period…

Q: In many European homes the rms voltageavailable from a wall socket is 240 V. What is the maximum…

A: The rms voltage in European homes is,

Q: If you place an AC voltage signal of amplitude 8.5 V and with a frequency of 1300.0 Hz into the…

A: Calculate the period of the input voltage.

Q: In the circuit shown, if the voltage measured across the resistor is 2 Vrms and the voltage across…

Q: At what frequency will an 80.0 mF capacitor have a reactance of 0.250 Ω?

A: The capacitance of the capacitor, C=80.0 mF=80.0×10-3 F The capacitive reactance, XC=0.250 Ω

Q: A 15@mF capacitor carries 1.4 A rms. What’s its minimum safe voltage rating if the frequency is (a)…

Q: why does a capacitor block DC but pass AC?

A: The frequency of the direct current is zero.

Q: A place has electrical outlets which is supply alternating currents with V rms = 114V and I rms =…

Q: When a 4.0 - µF capacitor is connected to a generatorwhose rms output is 30. V, the current in the…

A: Capacitive reactance is given by

Q: Calculate the resistance for an electric kettle rated at an average power of 2400 W and at an rms…

A: Write the given values with the suitable variables. P=2400 WV=120 V Here, P is the average power and…

Q: The voltage in an AC ckt varies harmonically with time with a maximum of 180V. At what angle in its…

Q: Phasors add like vectors: VL(t) + Vc(t) E(t) VR(t) wt Suppose the amplitudes of the voltages are…

Q: In the circuit shown, if the voltage measured across the resistor is 3 Vrms and the voltage across…

A: Given: The voltage across the resistor VR=3Vrms The voltage across the capacitor VC=1 Vrms

Q: . A pair of power transmission lines each have a 0.95Ωresistance and carry 740 A over 9.0 km. If the…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: An AC voltage source produces an average power of 400mW in a circuit with a total resistance of 12.5…

Question

100%

Stuck and slightly confused on the calc based physics question attached.

output voltage (Vout) is measured across the resistor

(a) What will the output voltage become, as 0 -> 0?
(b) As ) -> 0?
(c) What will be Vout, if œ = 2000 rad/sec?
You may give your answers as maximum voltages or rms voltages, but be sure you
specify which.
Vout
3Ω
ɛ = 100sin(ot)
2 mH

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Can the instantaneous power output of an ac source ever be negative? Can the average power output be negative?
Check Your Understanding If a European ac voltage source is considered, what is the time difference between the zero crossings on an ac voltage-versus-time graph?
Check Your Understanding Repeat Example 15.1 for an ac source of amplitude 20 V and frequency 100 Hz.
For what value of the phase angle between the voltage output of an ac source and the current is the average power output of the source a maximum?
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
Check Your Understanding What happens to the resonant frequency of an RLC series circuit when the following quantities are increased by a factor of 4: (a) the capacitance, (b) the self-inductance, and (c) the resistance?
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
Check Your Understanding An ac voltmeter attached across the terminals of a 45-Hz ac generator reads 7.07 V Write an expression for the emf of the generator.
At what time is the voltage across the inductor of the RL circuit of Figure 14.12(b) a maximum?
The peak value of an alternating current in a 1900-WW device is 4.2 AA . What is the rms voltage across it?