:- A:- When the polymerization of polystyrene with polybutadiene result crystalline melt temperature =98°C, Calculate the crystalline melt temperature for polystyrene and number of carbon atoms for polymer, if the mole fraction=3.6 and enthalpy=205 Kj/mole?

Q: Topic: Isothermal Reactor Design PROVIDE HANDWRITTEN SOLUTION PLEASE A rxn occurred in an isochoric…

A:

Q: The unit cell of chromium contains two atoms. Without using the crystal structure infor- mation,…

A: (a) Given, The chromium contains two atoms in a unit cell. Let r be the radius of the atoms and a be…

Q: Hexane (1) / ethanol (2) / methylcyclopentane (3)/ benzene (4) system Determine the following:…

A:

Q: An ore having 80% passing 10 mm is fed to a mill with a capacity of 12 t/h. The ground product has…

A: The amount of ore required is to be calculated.

Q: Question One, a. Calculate the alkalinity of a water sample if 3 L contains 0.35 M of HCO3 and 0.12…

A: Answer.   A Part. HCO3- molar mass = 61 g/mol  CO32- molar mass  = 60 g/mol  Molar mass (CaCO3) =…

Q: 1. The mass density of liquid argon at T = 143 K is Pm = 0.98 x 10³ kg/m³. Assume that the argon…

A: The distance of separation between two particles is calculated from the distance where the…

Q: In a packed bed reactor, where the flow is turbulent, a = 0.04 kg−1, PO = 10 atm, W = 20 kg, and the…

A: The y factor is equal to the ratio of pressure at the outlet and pressure at the inlet. This y…

Q: How much volume, in mL, will 3.5 moles of liquid hexane occupy at 482.9 K?

A:

Q: cycle time for maximum filtrate

A:

Q: 5. Construct the galvanic cell for the following reactions and write the expression for cell…

A: The galvanic cell is drawn in following format: Here, the oxidation part is mentioned in the left…

Q: exit velocity and what is the cross-sectional area at the nozzle exit f

A:

Q: There are nineteen thousand grams of fuel formed per two kilograms of fuel burned in the process of…

A: Write the reaction for the combustion of heptyne as follows: C7H12 + 10O2  → 7CO2 +6H2O Let x be the…

Q: Calculate the vapour pressure of a spherical water droplet 20 Å in radius at 25 °C. The vapour…

A:

Q: A plate column is used to absorb SO2 from a gas stream with air, using pure water at 20 o C. 6.48…

A: As per the given  data, the flow diagram of the scrubber is given as : To Find

Q: The absolute pressure is 2.50 bars. What is the gauge pressure in kPa? (write your answer up to 3…

A: Gauge pressure = 150 kpa For a detailed solution, please see the attached files.

Q: Based on the topic stated and the data obtained, the rxn AB follows the mechanism given below. Step…

A:

Q: We desire to produce two ethyl alcohol-water mixtures each containing 90% and 50% alcohol by mole…

A: Let feed rate(F) = 1000KMol And top product Flow rate are D1 And D2 with composition 90% and 50%…

Q: 5. One of the byproducts from making cheese is lactic acid, CH3CHOHCOOH. Rather than blending it…

A: The reaction is considered and the initial state and equilibrium state conditions are obtained. The…

Q: adsorption of sodium oleate

A:

Q: 22. Use Hess's law and standard enthalpies of formation to determine the AH for the reaction…

A: The standard enthalpy of reaction using Hess law and standard enthalpy of formation is to be…

Q: 2. Assume G =1800x,x, is valid for a binary mixture. The overall composition of the component (1) in…

A: Stability of given system is to be checked.

Q: 5. The second law of a) Heat flows from hot to cold Thermodynamics implies: (select all that…

A: Correct statements are to be identified.

Q: The heat is propagating through a stainless steel wall with thermal diffusivity of 6x10^(-6)m2/s. If…

A: Given that- Heat is propagating through a stainless steel wall. Thickness of wall, l=52.00 mm=0.052…

Q: A certain catalyst undergoes sintering overtime, causing its catalytic activity to decrease…

A: The deactivation kinetic model is given as : -------------------(1) The deactivation constant  is…

Q: Q3) After a long time in service, a counterflow oil cooler is checked to ascertain if its…

A: To Find  The heat reduced due to fouling

Q: A liquid mixture containing three components F, G and H is in equilibrium with a vapour phase in a…

A:

Q: Tail gas from a sulfur recovery plant has the following composition on a volume basis, SO2 (2.0%),…

A:

Q: Please explain, thank you so much

A: EGL refers to the energy grade line, and HGL refers to the hydraulic grade line. For a steady-state…

Q: A certain reaction proceeds in a constant - volume and isothermal CSTR: 2.15 -TA = KC₂² If the…

A: Given that -rA =kCA2.15n = 2.15damkohler no. = 5

Q: A fuel used in an engine has its chemical composition expressed as CsH1s. Find the chemically…

A: Given that, Fuel = C8H18 The mass of fuel mf = 1 kg = 1000 g The molecular weight of fuel Mf = 114…

Q: In a Nal(Tl) detector with the energy calibration equation E(x) = 1.0322x - 16.61, a measurement was…

A: Given that- for NaI (Tl) detector with the energy caliberation equation as- E(x)=1.0322x-16.61 After…

Q: The octane number of gasoline is the % by volume of iso-octane in an iso-octane (C8H18) and…

A: Calorific value of gasoline = 5361.96 KJ/mol

Q: Consider the following proportional feedback controller, where the dynamics of the actuator and the…

A: In the given block diagram, the value of the gain (b) is kc = 4, and that of the time constant (c)…

Q: Calculate the maximum rate of evaporation in kgs-1 per m2 of surface for water at 20°C into a…

A: The diffusion phenomenon is not considered as there is a perfect vacuum. The water vapor transfer…

Q: Programs A and B are analyzed and found to have worst-case runningtimes no greater than 150Nlog2N…

A: Given: Program A and B are analyzed and found to worst case running times no. Greater than 150Nlog2N…

Q: b) Compute the final volume and number of moles of propane gas for the given data in Table Q1 (b).…

A: Final volume and number of moles of propane gas is to be calculated.

Q: (i) The amount of CO₂ being removed from the gas stream. (ii) The composition of gas leaving the…

A: Answer.

Q: Given the following reaction with a feed rate of 15.0 kg/s each of H₂ and O2: 2H2(g) + O2(g) → 2H₂0…

A: Given data: Mass flow rate of H2 = 15 kg/s Mass flow rate of O2 = 15 kg/s Fractional conversion =…

Q: g-0. flowing through nozzle ects the mer ube gage. Determine the value of h if the pressure at A is…

A: Given data: Specific gravity of Oil;SG=0.750PA=20 psi=137895 Pad=2.75 inches=0.069 m

Q: I need the answer as soon as possible

A:

Q: b) Consider a refrigerant-134a power plant that operates on a simple ideal Rankine cycle. The boiler…

A:

Q: Mercury at 0°C is flowing over a flat plate at a velocity of 0.1 m/s. Using EES (or other) software,…

A: Temperature of mercury = 00C Velocity = 0.1 m/s

Q: 3. Hot water with a temperature of 330 K is flowing through a pipe. Heat loss per unit pipe length…

A:

Q: A wet cooling tower is to cool 25 kg/s of cooling water from 40 to 30°C, at a location in which the…

A: The dry air flow rate is constant throughout the tower. The mass flow rate of liquid decreases. This…

Q: b) Say we have a biomass digester that produces 500 Mt CH4 per year [metric tons of methane per…

A: Given that  Amount of CO2 produce = 500Mt per year                                            =…

Q: Q3: Air at 15°C and 1.05 bar occupies 0.02 m³. The air is heated at constant volume until the…

A:

Q: Discuss factors influencing the glass transition (Tg) temperature in polymers.

A: Introduction Glass transition, is the gradual and reversible  transition in amorphous materials…

Q: non ideal mixture of acetone(1) and chloroform(2)

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which…

Q: 2) Three materials are connected as the following figure. The heat conductivity coefficient of…

A:

Q: A certain catalyst undergoes sintering overtime, causing its catalytic activity to decrease…

A: