A wind generator is installed. It is determined that the capacity factor of the installation is 29% over the course of a 90-day period. In that period, it produced 1566 MWh. What is the size of the installation (MW)?
Q: A pump has a displacement volume of 5 in3. rotates at 1000 rpm and 1000 psi. If the volumetric…
A: Given data, Volume=5 in3. N=1000 rpm P=1000 psi ηvol=82%…
Q: 8-2V= 3m/s m= 3.3kg Find Kinetic energy.
A: Given data : Mass=m Velocity=V To find : Kinetic energy
Q: 13. A pump forces 1.2 m3/min of water horizontally from an open well to a closed tank where the…
A: (13) Given that, Volume flow rate, V˙=1.2 m3/min,Pressure of water, P1=0.9 MPa,Atmospheric pressure,…
Q: An engineer designing a light aircraft is trying to make an estimate of the diameter of the…
A: given; propeller efficiency(η)=84%…
Q: If the specific volume is 0.00055 m³/kg and volume is 0.9 liters. Find the (a) Density (b) Mass, (c)…
A: To Find : The density, mass, weight density and relative density. Given : The specific volume is…
Q: 15% HOW LONG THE RUNWAY must before a plane to reach a takeoff velocity of75 m/sec if it can…
A: soln : - initial velocity = u= 0 m/s Final velocity = v= 75 m/s Let S is the distance of…
Q: If a 0.9 kg object hanging from a spring stretches it by 0.20 m, then by how much will the spring be…
A: Given data :- m = 0.9kg x = 0.20 m Find :- x when m = 1.8kg
Q: Problem 4. A 10-kg block is raised vertically 3 meters. What is the change in potential energy?…
A: Given data, m= 10 kg h= 3 meters
Q: Convert between energy units. 231 cal to kJ
A: One calorie is defined as the amount of energy required to raise the temperature of unit gram water…
Q: A wind turbine produces 1.52 MW when the wind speed is a speed v. Assuming the same conditions for…
A:
Q: A small village draws 1.5 acre-foot of water per day from its reservoir. Convert this water usage…
A:
Q: Assume 4 kg/s of fluid are moving through an insulated pipe under these conditions: v1 = 6 m/s and…
A: Given Data m= 4 kg/s u1= 40 J/kg V1= 6 m/s
Q: 1. If wind speed doubles, the power output of the turbine will increase by a) 8 times
A:
Q: A petrol engine has a cylinder diameter and stroke of 120mm and 210 mm respectively The clearance…
A:
Q: A brand-new pick-up truck was driven and tested on a national highway. Due to a very light traffic,…
A:
Q: A jet flights with a speed of 291 m/s . If the jet's engine has a power of 1,462,823 W. what is the…
A:
Q: An ion-engine-propelled spacecraft has mass 1000 kg without propellant. Its propellant tank is…
A: The specific impulse of the spacecraft is
Q: The following table shows the kinetic energy and potential energy according to the speed of an…
A:
Q: A windmill operating at 50% efficiency sweeps out a disc with a 11 m radius. Calculate the ideal…
A:
Q: 3000lb car is traveling at 60mi/hr from point A to C. It makes a stop at point
A: Given Distance from A to B, x = 100 ft Velocity, v = 60 mi/hr Find…
Q: The Deligne Dam on the Cayley River is built so that the wall facing the water is shaped like the…
A:
Q: If the specific fuel consumption of a 300-hp tractor engine during plowing is 350 g of diesel/kW-hr,…
A: Given data Specific Fuel Consumption = 350 g/ KW-hr = 0.35 kg/kW-hr Power of tractor engine = 300…
Q: A 10 ft by 15 ft rectangular cistern (storage tank for rainwater) has its top 30 ft below ground…
A: Calculus is frequently used to determine the amount of labour required to empty a tank of the…
Q: A double-acting, four-cylinder, 12.5 cm x 12.5 cm four-stroke cycle engine rotates at 1,250 rpm.…
A: We have to calculate stroke volume which is given by Vs = 2As*(N/120)*k , where 2As is effective…
Q: rotational speed
A: N=1239 RPM
Q: Find the value of F 1m 50N 20 N 1.5 m 1.2 m 100 N 2.5 m LL
A: Given: To determine the value of F for which the system remains in equillibrium.
Q: Water flows over a waterfall 328 Ft in height. Take 2.204 lb of the water as the syste and assume…
A:
Q: Q5: Two forces, of 100 N each and making 120° with each other as shown in Fig (2), pull on an…
A: The value of resultant force is R=1002+1002+2100100cos120=100 N The angle of the force is…
Q: A 118-mm-diameter pipe
A:
Q: Question :- A chimney of 16 m high is used for discharging maximum exhaust gases. (i) Find the…
A: The solution for this question is given below
Q: Q1: If the power generated by a wind system at a height of 50 m is equal to 30 kw at a wind speed of…
A:
Q: Suppose that a person eats 2387 Calories per day. Convert this amount of energy into unit J.
A: The person takes energy per day is E=2387 cal. The unit conversion factor to convert Calories into…
Q: A cylindrical tank with a radius of 3ft is filled with water which has a weight density of 62.4…
A: Radius= 3 feetVolume=πr2h=3.14x9x6=169.56 ft3Weight density of water=62.4 lb/feet3Weight of…
Q: An engine has a shaft horsepower of 290 hp and its fuel weighs 185 lbs. Compute for the specific…
A:
Q: At a certain location, wind is blowing steadily at 7 m/s. Determine the power generation potential…
A: Given that: Velocity of wind = 7 m/s Diameter of blade of wind turbine = 80 m It is required to…
Q: Two electric pumps are being used to pump water to a cistern at the top of a 50 meter hill. A meter…
A: It is required to choose correct answer
Q: A pump lifts water at the rate of 6 m3/s to a height of 120 m and the friction loss in the pipe is…
A:
Q: A tow truck exerts a force of 450 lb. on a car, causing it to accelerate at 10ft/s^2. What is the…
A: External force applied = 450 lb accelerate at 10ft/s^2
Q: A fan with 22-in-diameter blades moves 1800 cfm (cubic feet per minute) of air at 70°F at sea level.…
A: Write the given information.
Q: Q) Find the force on the bottom of the tank, take the bottom dimeter =6 m. Air 9m 5m water Liquid…
A: Given Data The depth of water is: h1=9 m The depth of liquid is: h2=10 m The density of water is:…
Q: Convert between energy units. 4.99x10^3 kJ to kWh
A: Kilojoule (kJ) is the standard unit of energy. It is also the unit of work. The different type of…
Q: 5. Flow occurs over a spillway (Figure). Determine the horizontal force on the spillway per foot of…
A:
Q: Q1: what is the required force to move a car (1300 kg) from rest to 80 m (with a 20 m/sec)? *
A: Given: maas of the car, m=1300 kg Distance travel, d=80 m initial velocity, u=0 m/s final velocity.…
Q: mass NO CLOSED | SY STEM m = constant energy YES
A: In thermodynamic, system is that portion of space where our interest lies, where we want to…
Q: Determine how much work it takes to empty a hemispherical pond with a depth of meters. The outlet…
A: given data density = 1000 kg/m3 g = 9.81 m/s2 depth of hemisphere = 5 m total height of discharge…
Q: A Jet plane having a wing area of 20 m2 and weighing 25 kN flies at 950 km/hr speed. The engine…
A:
Q: Determine the displacement Work done=1021 J Force=103 N
A:
Q: Q1: If the power generated by a wind system at a height of 50 m is equal to 30 kw at a wind speed of…
A:
Q: C- If the annual energy generated in the generators of the hydro station is 2.86×10°KW/h with an…
A: According to the problem, the annual energy generated is 2.86×108 kW/h. E=2.86×108 kWh Here, E is…
Q: A ship having a horizontal sectional area of 7,065 m^2 at the waterline has draft of 12.35 m in salt…
A: Given: Horizontal cross-section areal=7065 m2 Draft:12.35m SGsea=1.03 To find:- The weight of the…
A wind generator is installed. It is determined that the capacity factor of the installation is 29% over the course of a 90-day period. In that period, it produced 1566 MWh. What is the size of the installation (MW)?
Step by step
Solved in 2 steps with 2 images
- A ship displaces 7500cu.m of seawater with RD 1.025. what is its new displacement if its floating atthe same draft in water with RD 1.015?A water pump motor has a horsepower rating of 11.3 HP. If it is to pump water from a well at the rate of 1 ft³/s, what is the minimum depth the well may have? The correct answer is 100 ft.Note: Use three decimal places and no need to input the unit. At a certain location, wind is blowing steadily at 7 m/s. Determine the power generation potential of a wind turbine with 80-m-diameter blades at that location. Also determine the actual electric power generation assuming an overall efficiency of 30 percent. Take the air density to be 1.25 kg/m3.( in kW)
- A ship with vertical sides near the water line, weighs 40 MN and draws 6.7 m in salt water (specific gravity = 1.026). Discharge of 2 MN of water ballast decreases the draft to 6.4 m. What would be the draft d of the ship in fresh water?A submarine is traveling at a depth of ‘95’ kilometers in the ocean, where the gagepressure is 840 Kg(f)/cm2 . The density and bulk modulus of elasticity of water at the top surface of the ocean are 1025 kg/m3 and 24000 kg(f)/cm2 respectively. Find the following:(i) What will be the density of water at the depth of 2.0 kilometers?(ii) What will be specific volume and change of volume at that depth?(iii) What is the pressure at the top surface of the submarine? How much will bechanged in pressure if submarine change direction from North to East?The average flow for the Mississippi River is approximately 1,500 cfs. It is assumed that one-fourth of this flow would be available to develop power at a dam shown below. a). what would be the annual energy in kilowatt-hours that would be produced with an overall average of 88% efficiency? b), What would the pressure P in psi?
- Given the sketch shown below, the diameter of the plunger Dp = 8 cm. The Ram diameter is Dr = 48 cm. The efficiency is 100%, the stroke of the plunger is 18 cm. The ram has to raise a load F2 = 2kN. Find: A) the force f1 exerted on the plunger. B) the number of strokes needed to raise the load given above by a distance of 10 cm. C) the volume of oil pumped if the load moves by 20 cm ( using plunger force in a ) D) what will be the new diameter of the ram piston if the new load force is 16 times the force exerted in the plunger the diameter of the plunger is kept to 8 cm.A brand-new pick-up truck was driven and tested on a national highway. Due to a very light traffic, 8hp is highly required to drive the said vehicle with a mass of 1800kg at a speed rate of 60kph. Consider the friction and air resistance. a) How much power is needed in order to drive the truck at a same rate up a 10% grade (a hill rising 10m vertically in 100m horizontally)? (in hp)b) Meanwhile, how much power is required for the truck still at a same rate down a 1% grade? (in hp)An engineer designing a light aircraft is trying to make an estimate of the diameter of the propeller needed. The design speed of the aircraft is 69m/s into still air and at this speed experience allows the engineer to assume a propeller efficiency of 88%. Other analysis shows that a thrust of 10906N must be supplied by the propeller to maintain this speed. Assuming a constant air density of 1.19 kg/m3 , determine the diameter of the ideal propeller in m to 1 decimal place.