μ_0 = 4π×10^(−7) T.m/A A wire 60.0 cm long is held parallel to and 100 cm above a long wirecarrying 100 A and resting on the floor. The 60.0-cm wire is released andfalls, remaining parallel with the current-carrying wire as it falls. What isthe induced emf on the wire 0.400 s after the wire is released? Giveyour answer in µV. (g=10 m/s2 )Başlangıçta, 60.0 cm uzunluğunda bir tel, yerde duran çok uzun 100 Aakım taşıyan bir tele paralel 100 cm yüksekte durmaktadır. 60,0-cmuzunluğundaki tel serbest bırakılmış ve yerdeki akım taşıyan tele paralelkalacak şekilde g ivmesi ile serbest düşmektedir. Kısa tel serbestbırakıldıktan 0,400 s sonra üzerinde indüklenen emk uV cinsinden nedir?(g=10 m/s? )Yanıtınız

Given data, Length of the wire = 60 cm Current in the long wire = 100 A Initial separation between…

A wire 60.0 cm long is held parallel to and 100 cm above a long wire carrying 100 A and resting on the floor. The 60.0-cm wire is released and falls, remaining parallel with the current-carrying wire as it falls. What is the induced emf on the wire 0.400 s after the wire is released? Give your answer in uV. (g-10 m/s2)

A wire 60.0 cm long is held parallel to and 100 cm above a long wire carrying 100 A and resting on the floor. The 60.0-cm wire is released and falls, remaining parallel with the current-carrying wire as it falls. What is the induced emf on the wire 0.400 s after the wire is released? Give your answer in uV. (g-10 m/s2)

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter20: Induced Voltages And Inductance

Section: Chapter Questions

Problem 56AP

See similar textbooks

Similar questions

Check Your Understanding What Is the magnitude of the induced electric field in Example 13.8 at t=0 if r= 6.0cm, R= 2.0cm,n = 2000 turnspermeter, I0= 2.0A, and a = 200s-1?
A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially uniform magnetic field. During a 0.10-s time interval, the magnitude of the field Increases uniformly from 200 to 300 mT. (a) Determine the emf Induced in the ioop. (b) If the magnetic field is directed out of the page, what is the direction of the cun-ent induced in the loop?
A flat, square coil of 20 turns that has sides of length 15.0 cm is rotating in a magnetic field of strength 0.050 T. If tlie maximum emf produced in die coil is 30.0 mV, what is the angular velocity of the coil?
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
Design a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .
Two long, parallel wires cy equal currents in opposite directions. The radius of each wire is a, and the distance between the centers of the wires is d, Show that if the magnetic flux within the wires themselves can be ignored, the self-inductance of a length 1 of such a pair of wires is L 0 l in d1 a (Hint Calculate the magnetic flux through a rectangle of length 1 between the wires and then use L=N/I
A solenoid with 4 x 107turns/m has an iron core placed in it whose magnetic susceptibility is 4.0 x 103. (a) If a cent of 2.0 A flows through the solenoid, what is the magnetic field in the iron core? (b) What is the effective surface current formed by the aligned atomic current loops in the iron core? (c) What is the self-inductance of the filled solenoid?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
A thin conducting bar (60.0 cm long) aligned in the positive y direction is moving with velocity v=(1.25m/s)i in a region with a spatially uniform 0.400-T magnetic field directed at an angle of 36.0 above the xy plane. a. What is the magnitude of the emf induced along the length of the moving bar? b. Which end of the bar is positively charged?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
Check Your Understanding (a) What is the magnetic flux through one turn of a solenoid of self- inductance 8.0 × 10-5 H when a current of 3.0 A flows through it? Assume that the solenoid has 1000 turns and is wound from wire of diameter 1.0 mm. (b) What is the cross-sectional area of the solenoid?