A wooden block weighing 9 N is at rest on top of a wooden desk. The coefficient of static friction between the block and the desk is 0.57. Find the minimum horizontal force required to move the block if the following occurs. (a) The block is being pressed into the surface with a 2 N force. (b) The block is partially supported by a vertical string under a tension of 4 N

A wooden block weighing 9 N is at rest on top of a wooden desk. The coefficient of static friction between the block and the desk is 0.57. Find the minimum horizontal force required to move the block if the following occurs. (a) The block is being pressed into the surface with a 2 N force. (b) The block is partially supported by a vertical string under a tension of 4 N

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter4: The Laws Of Motion

Section: Chapter Questions

Problem 23P: A bag of cement weighing 325 N hangs in equilibrium from three wires as suggested in Figure P4.23....

See similar textbooks

Similar questions

A 3.7 kg book is pressed against a wall with a force P at an angle of 35 degrees above the horizontal. The coefﬁcient of static friction between the book and the wall is 0.75. (a)What is the minimum value of the force P that can hold the book to the wall (without it sliding down)? (b)If the force is applied at an angle of 35 degrees below the horizontal, what is the minimum value of the force P that can hold the book to the wall?
A 16 kg block of steel is at rest on a horizontal table. The coefficient of static friction between block and table is 0.54. (a) What is the magnitude of the horizontal force that will put the block on the verge of moving? 84.7 N (b) What is the magnitude of a force acting upward 60° from the horizontal that will put the block on the verge of moving? X N (c) If the force acts down at 60° from the horizontal, how large can its magnitude be without causing the block to move? N
A 26.8 kg box sits on a ramp at an angle of 13° above the horizontal. If the coefficient of static friction between the box on the ramp is 0.215, what minimum applied force is required to keep the box at rest?
Logs weighing 1.3 kg and 2.2 kg lie on a flat surface and are connected by a rope that breaks at a force of 20 N. The coefficient of friction between the lighter log and the base is 0.50, and between the heavier log and the base 0.30. With what maximum force can we pull the lighter log so that the string does not break?
A 50.7 kg box is resting on a horizontal floor. A force of 317.1 N directed at an angle of 34.1° below the horizontal is applied to the box. The coefficient of static friction between the box and the surface is 0.5, and the coefficient of kinetic friction is 0.2. The force of friction on the box is:
A box of banana weighing 40.0 N rests on a horizontal surface. The coefficient of static friction between the box and the surface is 0.40, and the coefficient of kinetic friction is 0.20. (a) If no horizontal force is applied to the box and the box is at rest, how large is the friction force exerted on the box? (b) What is the magnitude of the friction force if a monkey applies a horizontal force of 6.0 N to the box and the box is initially at rest? (c) What minimum horizontal force must the monkey apply to start the box in motion? (d) What minimum horizontal force must the monkey apply to keep the box moving at constant velocity once it has been started? (e) if the monkey applies a horizontal force of 18.0 N, what is the magnitude of the friction force and what is the box's acceleration?
An initially stationary box of sand is to be pulled across a floor by means of a cable in which the tension should not exceed 849 N. The coefficient of static friction between the box and the floor is 0.450. (a) What should be the angle between the cable and the horizontal in order to pull the greatest possible amount of sand, and (b) what is the weight of the sand and box in that situation?
A small box is held in place against a rough wall by someone pushing on it with a force directed upward at an angle of 260 above the horizontal. The coefficient of static and kinetic friction between the box and the wall are 0.40 and 0.30, respectively. The box slides down unless the applied force has a magnitude of 13 N. What is the mass of the box?
A box of bananas weighing 40.0 N rests on a horizontal surface. The coefficient of static friction between the box and the surface is 0.40, and the coefficient of kinetic friction is 0.20. (a) If no horizontal force is applied to the box and the box is at rest, how large is the friction force exerted on it? (b) What is the magnitude of the friction force if a monkey applies a horizontal force of 6.0 N to the box and the box is initially at rest? (c) What minimum horizontal force must the monkey apply to start the box in motion? (d) What minimum horizontal force must the monkey apply to keep the box moving at constant velocity once it has been started? (e) If the monkey applies a horizontal force of 18.0 N, what is the magnitude of the friction force and what is the box’s acceleration?
A block weighing 67.5 N rests on a plane inclined at 25.0° to the horizontal. A force F is applied to the object at 40.0° to the horizontal, pushing it upward on the plane. The coefficients of static and kinetic friction between the block and the plane are, respectively, 0.380 and 0.156. (a) What is the minimum value of F that will prevent the block from slipping down the plane? (b) What is the minimum value of F that will start the block moving up the plane? (c) What value of F will move the block up the plane with constant velocity?
A 4.00 kg block rests between the floor and a 3.00 kg block. The 3.00 kg block is tied to the wall by a horizontal rope. If the coefficient of static friction is 0.800 between each pair of surfaces in contact, what horizontal force F must be applied to the 4.00 kg block to make it move?
Two sheets of plywood A and B lie on the bed of the truck. They have the same weight W, and the coefficient of static friction between the two sheets of wood and between sheet B and the truck bed is µg. (a) If you apply a horizontal force to sheet A and apply no force sheet B to move? What force is necessary to cause sheet A to start to sheet B, can you slide sheet A off the truck without causing moving? (b) If you prevent sheet A from moving by exerting a horizontal force on it, what horizontal force on sheet B is necessary to start it moving? ܥܪ ܩ A B L