A young engineer is designing a photo-voltaic system for his farm located near the mountains where the peak sun hours is 5 hours per day. The average electrical energy requirement for his farm is 7.2 KW-hr per day. If each solar panel he is planning to install has a rated power of 300 W and rated voltage of 24 volts and the system efficiency is 60%, a) Calculate the number of solar panels he needs to install. b) What is the daily capacity factor for this system? c) Is the capacity factor for this solar PV system low or high? Why? d) What is the total current and total voltage for the system if the PV panels are to be connected in series?

A young engineer is designing a photo-voltaic system for his farm located near the mountains where the peak sun hours is 5 hours per day. The average electrical energy requirement for his farm is 7.2 KW-hr per day. If each solar panel he is planning to install has a rated power of 300 W and rated voltage of 24 volts and the system efficiency is 60%, a) Calculate the number of solar panels he needs to install. b) What is the daily capacity factor for this system? c) Is the capacity factor for this solar PV system low or high? Why? d) What is the total current and total voltage for the system if the PV panels are to be connected in series?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Determine the size of PV modules, inverter, battery and solar charge controller of a PVsystems given the following load used for 8 hours per day:One 12 Watt LED bulbOne 60 Watt fanThree 200 Watt desktop computersUse reference: https://www.leonics.com/support/article2_12j/articles2_12j_en.php
a hydroelectric plant has a turbine and generator with an efficiency of 90%. if the dam has a head of 10 feet and the water flows at 300 feet cube per second, calculate the power generated. and explain the service drops in power systems?
Advanced Grounding Applications 13. Which article of the National Electrical Code provides the special requirements for electric signs and outline lighting systems regardless of the voltage? A. 250 B. 820 C. 600 D. 770. 14. The equipment grounding conductor of a PV solar system that bonds to the framework of the solar panels must be sized slightly larger than expected, since the A. panels are mounted outdoors and may be prone to corrosion over their lifespan.B. AC inverter system on a utility connected system can backfeed energy into the panels.C. panels may be contacted by metal ladders during service work or during repair of the roofing structure. D. lower output current levels may cause the overcurrent device to take longer to trip.
1. Compare the advantages and disadvantages of installing a PV system. 3. What are some advantages to using PV technology to build utility-scale power plants?
A room air conditioner has a coefficient of performance of 2.9 on a hot day and uses 850 W of electrical power. (a) How many joules of heat does the air conditioner remove from the room in one minute? (b) How many joules of heat does the air conditioner deliver to the hot outside air in one minute? (c) Explain why your answers to parts (a) and (b) are not the same.
A 100MW hydro-electric station is supplying full load for 10 hours in a day. The water is supplied from a reservoir of 1km2 surface area. Calculate the reduction in the water level of the reservoir in one day. Assume effective head of water as 200 m and efficiency of the the station is 80%.
Design a 25V solar PV panel system that can power a home that requires two 30-Watt lamps and four 15-Watt fans for 6 hours daily if the factors for the solar panel generation and the total energy losses respectively are2.92 and 1.3. Take the rating of the available solar PV cell as 5V, 5W
(b) A small standalone PV system has been designed for a house where the system could generate power of 1576 Whlday from four PV panels (Panel power generation factor is 4.3). 1) Estimate the power consumption demand of that house. 2) Estimate the total Watt-peak rating of the PV modules. 3)Justify the impact of the renewable energy transition on our environment and society.
Compare the renewabale technologies (biomass, geothermal, hydro, wind, solar) to existing non renewable energy systems and analysis the advantages and disadvantages.
- Loads, Service, and Overcurrent Protection 6.a. The general lighting load is based on a _______ per square foot basis.A. kilowattB. number of circuitsC. volt-ampereD. general illumination6.b. What's the primary disadvantage of using copper conductors?A. AvailabilityB. WeightC. CostD. Durability
A building in a location is equipped with a heat pump system that is used for space heating in winter and cooling in summer. The seasonal COPs of the heat pump in winter and summer are estimated to be 2.2 and 2.8, respectively. The design heating load of the house is calculated to be 750,000 kJ/h for an indoor temperature of 25°C. The unit cost of electricity is $0.09/kWh. The annual heating degree-days in this location is 2400°C-days and the 97.5% winter design temperature is −9°C. The cooling degree-days are 1100°C-days. Determine the annual electricity consumption and its cost for heating and cooling of this house. Assume the same overall heat loss coefficient for winter and summer.
Design a sustainable photovoltaic electrical energy system for a 20 bed off-the-gridcommunity hostel in Khaplu (in the foothills of Karakoram mountain range). Pleasenote that the property is set in an amazing location however it is completely off-the-grid without any grid electricity. The property needs a complete energy solution thatwould not only provide electrical heating 8 light but would also give the level of comfortexpected by the potential holidaymakers. With 20 bedrooms, 4 showers plusunderfioor electrical heating throughout this project is needed. Please design thesystem which ensures a reliable heating & electricity supply in such an exposedremote off grid cold environment.You may have to consider following stages for the sustainable energy design for thepropertya) Electrical design requirementsb) Installation of electrical system requirementsc) Overall cost breakdown