Help me fast so that I will give Upvote a. Find the general flow pattern of the network shown in thefigure.2020A X2X5 C100 <X6b. Assuming that the flow must be in the directions indicated,find the minimum flows in the branches denoted by x2, X3,50>EX480X4, and x5.2060a. Choose the correct answer below and fill in the answer boxes to complete your choice.O A.В.D.X1 =X1 is freeX1 =X1 =X2 =X2 is freeX2 is freeX2 =X3 is freeX3 =X3 is freeX3 =X4 is freeX4 is freeXA =X4%3DX5 is freeX5 is freeX5 =X5 =X6 is freeX6X6 =%3DX6%3D

Point A: Take in = Take out⇒20 + x2 = 100 + x1⇒x1 - x2 = -80 Point B: Take in = Take out⇒x3 + x5 =…

a. Find the general flow pattern of the network shown in the figure. b. Assuming that the flow must be in the directions indicated, find the minimum flows in the branches denoted by x2, X3. 100 E X 290 X4, and xg. 50 80 20 a. Choose the correct answer below and fill in the answer boxes to complete your choice. OA. OB. Oc. OD. X1 = X2 = X1 = x, is free X2 is free X2 is free X3 is free X2 X3 = Xg is free X4 = X3 X4 is free X4 is free Xg = X4 X5 is free Xs is free Xe is free X5 X6 = Xg =

a. Find the general flow pattern of the network shown in the figure. b. Assuming that the flow must be in the directions indicated, find the minimum flows in the branches denoted by x2, X3. 100 E X 290 X4, and xg. 50 80 20 a. Choose the correct answer below and fill in the answer boxes to complete your choice. OA. OB. Oc. OD. X1 = X2 = X1 = x, is free X2 is free X2 is free X3 is free X2 X3 = Xg is free X4 = X3 X4 is free X4 is free Xg = X4 X5 is free Xs is free Xe is free X5 X6 = Xg =

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 9VE

See similar textbooks

Similar questions

1. A group of hikers (1≤N≤200) going to a remote mountainous area where there is no cellular service want to organize an emergency communication system for broadcasting important messages among themselves. The hikers equip themselves with walkie-talkies, one for each hiker. These walkie-talkies each have a limited transmission radius -- a walkie-talkie of transmission power W units can only transmit to other hikers less than or equal to W away. Due to the power difference of each walkie-talkie, hiker A might be able to transmit to hiker B even though hiker B may not transmit back to reach A. However, hikers can relay messages to one-another along a path consisting of several hops (multi-hop communication using intermediate hikers as relays). Therefore, it is not necessary for every hiker to be able to transmit directly to every other hiker. We can see the asymmetrical nature of the walkie-talkie transmission in this application. Hence, some hikers may be more effective in reaching…
Suppose we have a reservation system with 50 users, frame transmission time of 0.6 sec, v = 0.3. (a) What is the effective frame transmission time? (b) What is the efficiency/throughput if all stations are transmitting? (c) What is the efficiency/throughput if a minislot can reserve up to 7 frames?
Computer Science Which of the following statement is true for Path term in SDH Network? a. Points where add/drop signal occurs. b. Points between SDH network Originated and Terminated. c. Points where regeneration of signal occurs. d. Points where Multiplexing/Demultiplexing of signal occurs.
Suppose that you noticed that flying two 60 mile trips was too much for a pigeon and you had to let the pigeon rest for 2 hours before returning. How does the “Winston Channel” compare to DSL under this circumstance?
Match each application with the type of the channel. we to choose between ( Simplex,Half-duplex, duplex) Television broadcast answer 1 Telephone conversation where only a single party can talk at a moment. answer 2 Radio broadcast answer 3 Direct connection of two computers where both can transmit and receive at the same time answer 4 Computer-human communication answer 5
How would you write a system of linear equations based on the given scenario and directions? Scenario You are employed as a network engineer and have been asked to analyze a communication network to determine the current data rates and ensure that the links aren’t at risk of “reaching capacity.” In the following figure of the network, the sender is transmitting data at a total rate of 100+50 = 150 megabits per second (Mbps). The data is transmitted from the sender to the receiver over a network of five different routers. These routers are labeled A, B, C, D, and E. The connections and data rates between the routers are labeled as x1,x2, x3, x4, and x5 . Directions For this assignment, you will analyze the communication network and solve for the unknown data rates using a variety of techniques. The system can be modeled mathematically as a system of linear equations by writing an equation for each node/router in the network. Each of these equations can be written by noting that the sum…
Given a home wireless IEEE 802.11AC Wi-Fi channel with a bandwidth of 80 MHz, a) Apply the real time streaming transmission of a video that samples at 40 frames/second and each frame has a resolution of 800x600 pixels. Each pixel has its colour presented in 16 bits. Calculate the required transmission rate. b) If the Wi-Fi Channel is very noisy with an acceptable Signal-to-Noise Ratio of 10dB, does the video streaming in part (a) still possible without any distortion? (provide workings)
A large population ALOHA user manages to generate 50 request/sec, including both originals and retransmissions. Time is slotted in units of 40 ms:a. What is the chance of success at the first time?b. What is the probability of exactly k collisions and then a success?c. What is the expected number of transmissions attempts needed?
Computer A is sending a 100 kByte long file to Computer B via packet-switching over two consecutive 10 Mbps links of 1000 km length each.Assume that the signal propagation speed on both links is 2.5 x 108 m/s.Furthermore, assume that the maximum length of a packet is 1500 bytes and that Computer A fills each packet to the max, if possible. How "long" (in meters) is one bit on link 1?
Assume a simple network of two directly adjacent routers. At time T=0 seconds both sent updates (A -> B "can reach 10.0.0.0 with cost 1", B -> A "can reach 20.0.0.0 with cost 1"). At time T=10 second router B exploded and, as a sad consequence, it stopped sending or receiving any packets. Select all statements that are true: - If at T=15s A sends a packet to 20.0.0.1, A will immediately drop the packet - If at T=15s A sends a packet to 20.0.0.1, it will not reach the destination - If at T=125s A sends a packet to 20.0.0.1, A will immediately drop the packet - At time T=125s node A has no knowledge about the route to 20.0.0.0/24 - If at T=185s A sends a packet to 20.0.0.1, A will immediately drop the packet - At time T=185s node A has no knowledge about the route to 20.0.0.0/24 - If at T=305s A sends a packet to 20.0.0.1, A will immediately drop the packet - At time T=305s node A has no knowledge about the route to 20.0.0.0/24
It is necessary to specify the topology of a network in five different ways.Which of these two do you believe is more reliable, in your opinion?
We indicated that the goal of any communications is that the received information should “equal” the transmitted information. Give an example application where:The received information needs to be “exactly equal” to that transmitted. Discuss why that is?