a. Given the circuit diagram, below; determine the current -n the 1-K₁² load resistor using Thevenin's theorem, and =check this load current when using Norton's theorem.

Q: By referring to Figure 1, determine, (a) Whether each diode is forward-biased or reverse-biased. (b)…

A: As per the guidelines we are supposed to answer only first three subparts. Please repost the…

Q: E R w switch Hint: from EL + ER = E(t) we get LI' + RI = E(t) In the circuit shown in the figure…

A: Given data, Inductance L=1 H Resistance R=30 Ω and Current I0=0 Diagram:-

Q: A string of Suspension Insulators consists of 8 units. If the Voltage across the string is 44 KV and…

A: Given data, Voltage across string V=44 KV. Voltage across unit nearest to line VL=16 KV. Number of…

Q: Consider this Dataln sequence: 1001100000 for a SISO right shift register. The initial state of each…

A:

Q: A 220 V, 15 kW, 850 rpm, shunt motor draws 62.2 A when operating at rated condition. The resistances…

A:

Q: Question #1 Find the transfer function G(s)=Vo(s)/V(s). v/(1) (+ 0000 2 H 292 www + Vo(1)- oooo 3 H…

A:

Q: GIven the difference equation:…

A: Given, Difference equation is…

Q: Given that the charge that has passed through a device up until time t is 4t² + 2t-3 Coulombs, find…

A:

Q: 177 + (2):A +

A:

Q: Draw a parallel realisation of the filter H(z) given below : 1-1- H (:)= +++]

A:

Q: 3) a) First put the numerator and denominator in exponential/polar form then find all

A: Given: F=-1-1i-2+12i-3+1i14

Q: 1. Label signals and draw a signal-flow graph of the block diagram shown below: 14 R(s) + 50 s+1 S 2…

A:

Q: In a power system with negligible resistance, the fault current at a point is 8.00 pu. The series…

A: Given- Fault current If=8 pu, Short circuit current Is=5 pu, To Find- The value of the series…

Q: 2. For the system shown in figure 2(a). Determine G(s) and H(s) of the block C(s) C(s) diagram shown…

A:

Q: Problem 4: The pMOSFET in the circuit has k',= 60 μ A/V²¹ L=0.8 μm, λ=0, V₁=-0.7 V If the desired…

A: Given here a PMOSFET circuit and asked to find the value of R and W.

Q: A 220V dc shunt generator has iron and friction losses of 1500W. The armature and shunt resistances…

A:

Q: If the total power is 450 kW in a power measurement of a 3- Phase delta connected load by 1-…

A: Given : Total power = 450 W Need to calculate wattmeter reading

Q: SOLUTIONS OF DIFFERENTIAL EQUATIONS Solve each of the following: 4.83. (d) y(t) + y'(t) = t + 1

A: d) Given, Differential equation is  y'''(t) + y'(t) = t+1 ----------->(1) There are no initial…

Q: ii) 2/30°+√√3e

A:

Q: rms 1. A balanced three-phase, star-connected voltage source has VRN =230 Z60° N V with RYB phase…

A:

Q: рвовсем #q IN THE CIRCUIT BELOW, ONLY THE VOLTAGE UX IS OF INTEREST. SIMPLIFY THE CIRCUIT USING…

A: The given problem is from circuits. We are using voltage division rule for the circuit to calculate…

Q: Find (t) from the below Transfer Function, F(s) 1 - (s + 1)(s − 2)(s + 3) F (s) =

A: Given data, The given Laplace transform function is FS=1S+1S-2S+3 The inverse Laplace transform of…

Q: 10. When there is 12 mA of current through a 1.2 k resistor, the voltage across the resistor is A.…

A: Given data, Current is given i=12 mA. Resistance is given R=1.2 kΩ.

Q: Envelope detector circuits are very simple to implement but one major drawback of its simple design…

A: It is right that one major drawback of envelope detector is its limited message frequency…

Q: Determine the complex exponential Fourier series representation for the signal below. x(t) = cos(3t)…

A: Given: xt=cos3t+sin5t     Required: Complex exponential Fourier series representation of xt.

Q: merits and disadvantages in digital signal processing?

A: Given: FIR and IIR filters: merits and disadvantages in digital signal processing?

Q: The emf per turn of a single phase 10 kVA, 2200/220V, 50 Hz transformer is 10V. Calculate the net…

A:

Q: Q2: A 100-ohm resistor is connected to the secondary of an ideal transformer with a turns ratio of…

A: Given: Load resistor connected at secondary of transformer, RL=100 Ω. Turns ratio of transformer,…

Q: A three phase induction motor is wound for 4 poles and is supplied from 50Hz system. Calculate the…

A:

Q: 2. After having been in position A for a long time, the switch in the circuit was moved to position…

A:

Q: Will the envelope detector work just fine with its current specifications? Choose the best action/s…

A: Given:  Required: Envelope detector specifications.

Q: A 230 V D.C. shunt motor takes 32 A at full load. The back e.m.f. on full load, if the resistance of…

A:

Q: For a three phase, three wire system, the two Wattmeter read 4000 Watts and 2000 Watts respectively.…

A: Given data: Three-phase, three-wire system, The Wattmeter, W1=4000 watts The Wattmeter, W1=2000…

Q: Find the Fourier transform of the signal below. Show the details of your work. Write your answer on…

A: Fourier transform of 10rect(t -8 ):

Q: 4. Under equilibrium conditions, the Fermi level in a Si semiconductor is 0.35 eV above the…

A:

Q: Find the Fourier Sine transform of -ax e

A:

Q: 20 A current flows along the positive z-direction in the inner conductor of a long coaxial cable and…

A: NOTE: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts…

Q: 4. Find R & Pmax. 1082 + lsv + bs 3A 1052 nos 1 Re RL

A:

Q: Task 1: For the case of parameters m=1, b=2, and k-3 and the zero state as the initial condition,…

A:

Q: 4) Consider a Schottky junction diode between Au and n-Si, doped with 10% donors/cm³. The…

A: Given:- A = 1mm2 Work function ϕm=5.1 eV fB = 0.8 eV IVa=0.3V = ?

Q: дакл з 4.7кл - ISV +2V 3. акд В=190 1.2кл

A:

Q: What formula is used to calculate inductive current?

A:

Q: For a residential building the connected load is 12 kW and maximum demand is 9 kW. What is the…

A: Given: For a residential building, Connected load = 12 kW. Maximum demand = 9 kW.

Q: 4.48. Find the Laplace transforms of each of the following: (e) (est-e-3t)2 (f) (√t+1)(2-√t)/√t (g)…

A: It is given that: e) e3t-e-3t2f) t+12-ttg) 8sin23th) sin2tcos2ti) t23-1t232j) 5sin2t-5cosh2t

Q: 1. Three resistor of 10, 15 and "x" ohms, respectively are connected in parallel across a constant…

A:

Q: A third order FIR filter has a transfer function G(z) given by G(z) = 16(1 − z¯¹)(1 + ²z¯¹)(1+/z¯¹)…

A: Given: Third order FIR filter has a transfer function,  G(z)=16(1-32z-1)(1+34z-1)(1+52z-1) To find:…

Q: Using manual solutions, determine the autocorrelation of the output sequence of the input_x(n) = {0,…

A:

Q: 4. Determine the transfer function G(s) = T(t) 1 N-M/RAD 0000 1 N-M-S/RAD 1 KG-M² e(s) 1 N-M-S/RAD…

A:

Q: Armature resistance of a 230V shunt motor is 0.6 0 and no load current is 5A. When the rotor is…

A: Given: Armature current, Ia=60A Armature resistance, Ra=0.6Ω Terminal voltage, VT=230V Speed, N=1200…

Q: Question Find the gradient of the Scalar Field T = sin5 (ex³y z) + sec(л√ √y + 2)

A: Given

Current Division Method

The generalized current divider formula is given by the following relation below,