Above figure shows a wire carying a current in the presence of a magnetic field. Themagnetic flux density is 0.25 T. directed ino the page. If the wire is 1.0 m long andcarries 0.5 A of current in the direction from the top of the page to the bottom of thepage, what is the magnitude and direction of the force induced on the wire?

Given Data: Magnetic flux density, B=0.25 T Flux density is directed into the paper. Length of the…

Above figure shows a wire carying a current in the presence of a magnetic field. The magnetic flux density is 0.25 T. directed ino the page. If the wire is 1.0 m long and carries 0.5 A of curent in the direction from the top of the page to the bottom of the page, what is the magnitude and drection o the force induced on the wire?

Above figure shows a wire carying a current in the presence of a magnetic field. The magnetic flux density is 0.25 T. directed ino the page. If the wire is 1.0 m long and carries 0.5 A of curent in the direction from the top of the page to the bottom of the page, what is the magnitude and drection o the force induced on the wire?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 33P: A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially...

See similar textbooks

Similar questions

If electric and magnetic field strengths vary sinusoidally in time at frequency 1.00 GHz, being zero at t=0, then E=E0sin2ft. (a) When are the field strengths next equal to zero? (b) 4Jhen do they reach their most negative value? (c) How much time is needed for them to complete one cycle?
The potential difference V(t) between parallel plates shown above is instantaneously increasing at a rate of 107V/s. What is the displacement current between the plates if the separation of the plates is 1.00 cm and they have an area of 0.200m2?
A strip of copper is placed in a uniform magnetic field of magnitude 2.5 T. The Hall electric field is measured to be 1.5103V/m (a) What is the drift speed of the conduction electrons? (b) Assuming that n =8.01028 elections per cubic meter and that the cross-sectional area of the strip is 5.0106m2 , calculate the current in the ship, (c) What is the Hall coefficient 1/nq?
An electron of kinetic energy 2000 eV passes between parallel plates that are 1.0 an apart and kept at a potential difference of 300 V. What is the strength of the uniform magnetic field B that will allow the electron to travel undeflected through the plates? Assume E and B are perpendicular.
The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
Is B constant in magnitude for points that lie on a magnetic field line?
A circular loop of radius R carries a current I. At what distance along the axis of the loop is the magnetic field one- half its value at the center of the loop?
Consider the axial magnetic field Bv=0IR2/2(y2+R2)3/2 of the circular current loop shown below. (a) Evaluate aaBydy Also show that limaaaBydy=0I (b) Can you deduce this limit without evaluating the integral? (Hint: See the accompanying figure.)
A proton precesses with a frequency p in the presence of a magnetic field. If the intensity of the magnetic field is doubled, what happens to the precessional frequency?
A nonconducting hard rubber circular disk of radius R is painted with a uniform surface charge density tr. It is rotated about its axis with angular speed . (a) Find the magnetic field produced at a point on the axis a distance h meters from the center of the disk, (b) Find the numerical value of magnitude of the magnetic field when =1C/m2 , R = 20 cm, h = 2 cm, and magnetic field of Earth, which is about 1/2 Gauss. =400rad/sec , and compare it with the magnitude of
A circular loop of wire of radius 10 cm is mounted on a vertical shaft and rotated at a frequency of 5 cycles per second in a region of uniform magnetic field of 2 Gauss perpendicular to the axis of rotation, (a) Find an expression for the time-dependent flux through the ring, (b) Determine the time-dependent current through the ring if it has a resistance of 10
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?