A.3-22 Equilibrium Data for Ammonia-Water SystemPartial Pressure of NH3in Vapor, p (mm Hg)Mole FractionNH, in Liquid, x₁00.01260.01670.02080.02580.03090.04050.05030.07370.09600.1370.1750.2100.2410.29720°C (293 K)0121518.224.931.750.069.611416622729847030°C (303 K)011.515.319.324.429.640.151.079.7110179260352454719Mole Fraction NH, inVapor, y; P = 1 Atm20°C00.01580.01970.02390.03280.04160.06570.09150.1500.2180.2980.3920.61830°C00.01510.02010.02540.03210.03900.05270.06710.1050.1450.2350.3420.4630.5970.945 Absorption of Ammonia in a Tray Tower. A tray tower is to be used to remove99% of the ammonia from an entering air stream containing 6 mol % ammoniaat 293 K and 1.013 × 105 Pa. The entering pure water flow rate is 188 kgH₂O/h·m² and the inert air flow is 128 kg air/h- m². Calculate the number oftheoretical trays needed. Use equilibrium data from Appendix A.3. For thedilute end of the tower, plot an expanded diagram to step off the number oftrays more accurately.

To find: The number of theoretical trays needed. Given: The liquid flow rate, L = 188 kg H2O/h.m2.…

Absorption of Ammonia in a Tray Tower. A tray tower is to be used to remove 99% of the ammonia from an entering air stream containing 6 mol % ammonia at 293 K and 1.013 x 105 Pa. The entering pure water flow rate is 188 kg H₂O/h m² and the inert air flow is 128 kg air/h m². Calculate the number of theoretical trays needed. Use equilibrium data from Appendix A.3. For the dilute end of the tower, plot an expanded diagram to step off the number of trays more accurately.

Absorption of Ammonia in a Tray Tower. A tray tower is to be used to remove 99% of the ammonia from an entering air stream containing 6 mol % ammonia at 293 K and 1.013 x 105 Pa. The entering pure water flow rate is 188 kg H₂O/h m² and the inert air flow is 128 kg air/h m². Calculate the number of theoretical trays needed. Use equilibrium data from Appendix A.3. For the dilute end of the tower, plot an expanded diagram to step off the number of trays more accurately.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The viscosity values for the H2 and Freon-12 gas mixtures at 25 ° C and 1 atm pressure and the mole fractions of the mixture are given in the table below. For H2 and Freon-12, calculate the viscosity values of the mixture for 3 different compositions using pure viscosity values. H2 Mol Frac. 0,00 0,25 0,50 0,75 1,00 Viscosity (µ) x 106 (poise) 124,0 128,1 131,9 135,1 88,4
Explain the liquid-vapor equilibrium of pure substances: properties of the two-phase mixture.
The pressure and temperature of a mixture of equal masses of hydrogen are 120 kPa and 27 degree celcius. The gas constants of hydrogen and oxgen are 4.125 and 0.2598 kJ/kg-K respectively. Calculate the partial pressure of ocygen in Kpa.
Determine the lower heating value of methane if its higher heating value (HHV) is 23,880Btu/lbm
Calculate the entropy increase in the evaporation of one mole of water at 100 °C. Heat of vaporization of water at 100 °C = 2259.4 J g-1.
A total of 250 g of CO2 gas at 373 K is heated to 873 K at a pressure of 101.32 kPa. Calculate the amount of heat needed in: a. cal b. btu c. kJ
A river has a flowrate of 3 m3/s. A stream discharges into the river at a flowrate of 0.05 m3/s. A tracer is added to the stream for research purposes. Determine the minimum concentration of tracer in mg/L that must be achieved in the stream so that 1.0 mg/L of tracer can be measured after the river and stream mix (downstream)? What mass rate in kg/d of tracer must be added to the stream? (Assume complete-mix reactor).
A steam of gas at 70 degrees F, 14.3 psia and 50% saturated water vapor is passes through a drying tower where 90% of the water vapor is removed. Calculate the pounds of water removed per 1000 ft3 of entering gas. The vapor pressure of water at 70 degrees F is 0.74 in Hg.
A mixture of 15 lb -mol N2 and 30 lb-mol CH4 is being heated from 400 F to 800 F at 1 atm pressure. Calculate the total amount of heat needed in Btu. I need step by step and detailed explanations, thank u
Consider a gas mixture that consist of 5 kg of O2 , 8 kg of N2 and 12 kg of C2H6 . Determine :- 1- the mass and the mole fraction of each component. 2- the specific gas of the mixture
The equipment room housing the compressor and condenser of a refrigerant ammonia system has dimensions 5 by 4 by 3 m at 1 bar room pressure. Calculate the minimum mass of the refrigerant in kg which would have to escape into the space to cause a toxic concentration for a 1/2-h exposure.
Steam of 1.4MN/m2 and of dryness fraction 0.7 is throttled to 0.11MN/m2 determine the dryness fraction of the steam after throttling?