Answered: AC power of 100 volts and 1 ampere…

AC power of 100 volts and 1 ampere enters a transformer with 2 coils and exits the transformer with 20 coils. What is the exiting voltage and current?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.11MCQ: For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the...

See similar textbooks

Related questions

Q: Calculate the (a) r.ms. value, (b) the form factor and (c) peak factor of a periodic voltage having…

A: periodic voltage having the following values for equal time intervals changing suddenly from one…

Q: Plot the graph between P vs Va in Dc series excitation motor

A: Armature voltage : Armature voltage is the voltage developed at the…

Q: A 240 Volt 60cycle source is connected to a coil of wire that has a resistance of 75Ω and an…

Q: Consider given choices. Solve the current flowing to silicon diode of the given circuit below.

Q: Consider the circuit below. At t= 0 the switch is opened. Find the inductor current, i(t), for t> 0.…

A: The solution is given below

Q: Assuming that the frequency of the voltage source is 10 Hz, |V1| = 5.49 and ZVc = 68.55°. 10N What…

Q: Calculate the line currents.

Q: A series circuit consisting of 20 ohm resistance and 20 mH inductance is connected across a 220…

A: The solution is given below

Q: The directivity of an antenna is given by: D(8,4) =sir 3 sin²(e). If the antenna has a total…

A: The directivity of an isotropic antenna varies between 0 to 1. The directivity of a idealized…

Q: For the following network, find the value of load resistance RỊ for maximum power to RL. R1 R3 6Ω…

Q: For The circuit shown below; find the currents of all Resistances using Kirchhoff's laws 28A 3 35 N…

A: In this question, We need to determine the current in the each resistance using the KCL and KVL.…

Q: (b) Figure Q1(b) shows an equivalent circuit of a feedback amplifier having the following values:…

A: Solution (b) - The equivalent circuit of a feedback amplifier is shown below,…

Q: Using a digital multimeter, what are the indicators if a diode is defective and is considered OPEN?…

Q: Why do we utilize periodic analogue signals and non-periodic digital signals for data transmission?

A: The analog signal is a continuous signal and digital signal has discrete stages.

Q: he Super Low Frequency band is from 30 to 300 Hz. For a DSBSC AM signal with a carrier equency of fc…

A: The solution is given below

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…

Q: 5) Solve the following equation for f(t), t>0, using Laplace transforms. 2rx) dx + 3/() + r) = 0,…

A: In this question, We need to determine the signal f(t) using the Laplace transform for time t>0.…

Q: An operational amplifier consisting of three cascaded stages has a võltage gain of 3500. The gain of…

A: Given data : Total voltage gain K =3500. The first stage gain k1=-5 The second stage gain…

Q: Clamper Circuit 3. Determine Vo and sketch output waveform. Sketch v, for each network of Fig. 181…

A: We need to find out output voltage for given circuit

Q: Implement the below logic function with an 8 :/ multiplexer. AzA2 A,Ã¸+ A3A, +A,A,A,A, + A, A,4,A,t…

A: A logic expression is given in the question. We need to implement the logic expression by a 8:1…

Q: Two 33 ohm resistors are connected in parallel followed by two more 33 ohm resistors connected in…

Q: AM mobile transmitter supplies 8 kW of carrier power to a 42 Ohms load. The carrier signal is…

A: In this question we will find peak voltage of the modulating signal for AM wave.

Q: What is the CMRR of the op-amp in dB if the open-loop differential voltage gain of 200,000 and a…

A: We need to find out comman mode rejection ratio for opamp

Q: Determine the output voltage of a Half-wave rectifier with an input peak-to-peak sinusoidal voltage…

A: The solution is given below

Q: Determine v, for each network of Fig. 179 for the input shown. 3 V +8 V I kQ 2.2 ka + Si -8V (a)…

Q: Q4 The analysis of the voltage, V for the circuit given in Figure Q4 can be expressed in the…

A: Given: The analysis of the voltage, V for the circuit given in the figure below can be expressed in…

Q: Figure 4(b) is the Miller equivalent circuit of the circuit in Figure 4(a). Derive a relationship…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A440V,22.5-hp,50Hz,3-phase,4-pole,star-connectedinductionmotorhasthefollowing impedances in ohms per…

Q: 3. Three non-inductive resistances, each of 100 Q, are connected in star to a three- phase, 440-V…

A: We convert the given delta connected inductive coil into star and analysis the 3 phase system on per…

Q: 13. Find the Thévenin equivalent circuit for the portions of the networks of Fig. 18.121 external to…

A: The solution is given below

Q: Ahmad was assigned by his lecturer to obtain the output equation, f(t) for the system given below:…

A: The solution is given below

Q: Skill-Assessment Exercise 2.8 PROBLEM: Find the transfer function, G(s) = X2(s)/F(s), for the…

A: In this question, We need to determine the transfer function X2/F(s) using the s domain.

Q: Find the time-domain function for the indicated output, either vo(t) or io(t). Your function should…

Q: 2. Consider the voltage divider circuit for biasing an n-channel E-MOSFET. Given the following…

A: We need to find out current and voltage for given circuit

Q: What is power released on the 10.0 V battery

A: In this solution the concept of Nodal analysis is discussed.

Q: 3. Identify what type amplifier the circuit is, and solve for the output voltage if the input…

A: This is the Summing operational Amplifier circuit that is used to combine the voltages at inverting…

Q: Find the laplace transcom of the following. 1 A- 3t t.1

Q: 4. Determine the currents in the unbalanced bridge circuit below. Also, determine the potential…

Q: 2) Fill in the blanks with a letter corresponding to the pole placement plot below; arrows indicate…

Q: Q/ Name a Schottky diode that operates at small frequencies

A: The Schottky diode is a type of metal– semiconductor junction diode. Schottky diodes are also known…

Q: If the insulation resistance of a cable of length 10 km is 1 M2, its insulation resistance for 50 km…

A: Given L1 = 1km R1 = 1Mohm L2 = 50km R2 =?

Q: 05- An earth station is receiving a signal from a space research satellite on a frequency of 11GHZ.…

A: We need to find out average power density and received power and effective area of antenna

Q: Refer to Figure 8. Find Thevenin equivalent circuit with two different methods.

Q: Vp Vr = 0.7 V - Ideal diode- Ip Draw the Volt-ampere characteristic curve of the device and explain.…

A: A voltage -ampere characteristics of are voltage to the current curve drawn with the variation of…

Q: 779 @ ۳:۳۲ م O Z 4.5G+ Iı. تم الأس س الكهربائية الكورس الثاني_ا. . . Thus, the frequency domain…

Q: Using the drain characteristic of Fig. a. What is the value of ra for VGS = -1 v? b. What is the…

A: The drain characteristics are plotted between VDS and ID of the FET or MOSFET.

Q: i = 100 sin 314t 2n

Q: 13.29 In the circuit of Fig. 13.98, find the value of the coupling coefficient k that will make the…

A: The coupled circuit is a series combination of inductors connected together with the same mutual…

Q: Find the rms and average value of the wave form shown below. a. Vaverage b. Vrms

Q: How2 find the RAB in fig.

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

AC power of 100 volts and 1 ampere enters a transformer with 2 coils and exits the transformer with 20 coils. What is the exiting voltage and current?

a.) 1000v/0.1amp

b.) 0.1v/1000amp

c.)1000v/1amp

d.) 2v/20amp

e.) No change

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
What are the advantages of correctly specifying a transformer most Suita ble for its application?
What is the purpose of a transformer? Draw the symbols for a transformer.
In the distribution transformer;In the transformer used for the distribution of electricity to the houses, 3.3 kilovolts enters and 400 volts come out. When we make the phase-neutral calculation, that is, when we divide it by √3, we get 230 volts and 220 volts coming to the sockets. Where does the remaining 10 volts go? (Can you explain with figure) is this about 30 degree phase shift?
A 100 kva, 2300/230 volts 60 Hz 2-winding transformer is used as an autotransformer having a single winding to step up the voltage of a 2300 volts line by 10%. If the transformer has 3.3% impedance as 2-winding transformer. find the % impedance as autotransformer? ..
Is it appropriate to step down and rectify the 220V AC signal via a transformer? 220 voltsrectify it and then reduce its value to the desired DC level with a voltage divider circuit?suitable.?
Calculate the number of turns needed in the secondary winding of a transformer to transform a primary voltage of 300 volts down to a secondary voltage of 180 volts, if the primary winding has 1150 turns of wire. ANS. Nsecondary= 690 turns
When the transformer is supplied at 400 V, 50-hz the hysteresis loss is found to be 300 W and eddy current loss is found to be 250 W. Determine the hysteresis loss when the transformer is supplied at 800 V, 100-hz.
A voltage transformer has 1500 turns of wire on its primary coil and 500 turns of wire on its secondary coil. What will be the turn ratio (TR) of the transformer? If 240 volts is applied to the primary winding of the same transformer in problem no. 1, what will be the resulting secondary no-load voltage? Calculate the voltage output by the secondary winding of a transformer if the primary voltage is 35 volts, the secondary winding has 4500 turns, and the primary winding has 355 turns. Calculate the voltage output by the secondary winding of a transformer if the primary voltage is 230 volts, the secondary winding has 290 turns, and the primary winding has 1120 turns.
A 400/100 V, 5 kVA single-phase two winding transformer is to be used as an auto-transformer to supply 400 volts from a 500 V voltage source. When tested as a two-winding transformer at rated load and 0.8 pf lagging, its efficiency was found to be 95%. (a) Determine the transformed kVA and conducted kVA. (b) Find its efficiency as an auto-transformer at rated load and at 0.8 pf lagging.
The primary winding of a transformer connected to 2,200 volts circuit consists of two coils which may be connected in series or in parallel. When they are in series, with secondary circuit open the primary current is 0.32 amp and the power input is 150 watts. Calculate the no load current and power factor when the primary coils are connected in parallel on a 1,000- volt circuit of the same frequency.
Explain the operation in detail with diagram for transformer used for welding Please don’t handwringing