Hiw 2 fint the RAB in fig. 2 kn A. 9kn 9kn 3kn 사

Q: ind the current-voltage relationship of the assumed circuit shown assuming both diodes are Germanium…

A:

Q: Consider the circuit below, what is the current flowing at 16 kohms? 24 V Ge 8k2 V. 16kn O 0.58 mA O…

A:

Q: (b) (i) Proof that the speed of DC series motor in revolution per minute (rpm) is expressed by R. 30…

A: It is asked to prove the given equation of speed in rpm for a DC series motor. Also we need to…

Q: A wye-connected, 3-phase system has the following sequence components of current Zero sequence…

A: In this question,   We need to determine the flow the current in the neutral wire?  If all sequence…

Q: To place a text on the plot using a mouse, the command used is MATLAB a) gtext O b) text O c)…

A: To place a text on the plot using a mouse, the command used is ......

Q: A signal A contains 1 period of an infinite periodic signal X, while a signal B contains 4 periods…

A: The Discrete Fourier Transform is a mathematical representation of a signal to study the following…

Q: three-phase induction motor having a synchronous speed of 1000 revolution per minute draws 50 kW…

A:

Q: balance Y-connected load of ( 3 + j8 ) ohms per phase is supplied by a balanced three-phase, 60 Hz,…

A:

Q: Compose the mesh equations. 10 Q j10 O j10 O ll ll 10 V [11] [ 12] へ)15V -j10 O sine sine @mesh 1:…

A: In this question,   We need to determine the real and imaginary part of impedance

Q: :The transformer Iron losses is .Constant independent of the applied voltageO

A:

Q: Determine the Nyquist rate of a signal whose frequency spectrum is given by ¤(f) = r(f) – 2r(f –…

A: According to bartleby guidelines, we have to answer first question only.

Q: 38 +16 V Si Si ´ Si oVo 4.7 k2 -4 V Figure 3 Determine the voltage output Vo and the current I of…

A:

Q: then the cartesian equation

A:

Q: Rp C2 Vout C RL Vin RG Given: • VDD =18 V • RG =20 Mohms • RD = 462 ohms • RL = 19 kohms • pinch off…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: For the given circuit below, compute for the voltage across 8- ohm load, RL. Si Vs RL 18 V- 8 k2…

A:

Q: Question 4: What are the charge on and the potential difference across each capacitor in the figure…

A: We need to find out the voltage across capacitor and charge on capacitor

Q: 10. A 3-phase motor rated 50 hp, 220-volts, 75% power factor and 95% efficiency. What is the current…

A: In this question,   We need to choose the correct options What is current if voltage V= 210V     as…

Q: The overall usefulness of an antenna is defined by five fundamental parameters, which are: Tick all…

A: Antenna: Antenna is a structure that transmits the radio waves. Different size and shapes of antenna…

Q: R , Vor V 200VZ-10° , (assume positive sequence) %3D ry o=Z = 12 +j 4 a) Show all type of current…

A:

Q: Solve the voltage across germanium diode of the given circuit below. 32 V lo2 AGe Si Vo 6.8 kohms 4…

A: Here two anti parallel Si and Ge diode  Ge diode is reverse bia  and si diode is forward bias cut in…

Q: In power factor correction where a motor load is normally operating with 1000 inductive vars, a…

A: In this question,   We need to explain the why inductive VAR power is compensation by the capacitor?…

Q: Interpret the graph of the semiconductor diode. A. What is the relationship of the voltage and the…

A:

Q: . Question 05: Consider the following open loop transfer functions: i) Classify with respect to…

A: In this question,   We need to calculate tp, ts (2% criterion), tr and Mp and also find the steady…

Q: Question 4: What are the charge on and the potential difference across each capacitor in the figure…

A:

Q: Q1) Define briefly: 1. Optoelectronics. 2. Electroluminescence. 3. Internal quantum efficiency. 4.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 36 D1 D2 V Find the current-voltage relationship of the assumed circuit shown assuming both diodes…

A: Ad D1 will be forward biased and D2 will be reverse biased, only D1 will be conducting.  The forward…

Q: 505) A PID controller has a test input signal: Unit Step. Determine the controller output at t=2…

A: We need to find out output at given time instant for given controller

Q: A440V,22.5-hp,50Hz,3-phase,4-pole,star-connectedinductionmotorhasthefollowing impedances in ohms per…

A:

Q: +15V 3K 2K 1K

A:

Q: For The circuit shown below; find the currents of all Resistances using Kirchhoff's laws 10RI V=IxR…

A:

Q: A cellular radio transmitter has a power output of 3 W at 800 MHz. It uses an antenna with a gain of…

A: Given Transmitted output power Pt=3W Frequency f=800MHz Transmitter Antenna gain  Gt=3dBi Receiver…

Q: The characteristics of MEO orbit are: Tick all that apply. Large footprint each satellite cover…

A: The characteristics of MEO (Medium Earth Orbit) are Large foot print each satellite cover around 33%…

Q: Compose the mesh equations. 10 Q j10 O j10 2 ll ell 10 V [11] [12] :-10 2 sine sine

A:

Q: Determine the current, voltage and power dissipated by each of the 6 resisters in the following…

A:

Q: Increasing the frequency of the supply :will .Decrease the rotor speed at a certain load torqueO…

A:

Q: Adding resistance to the stator circuit of :the I.M. willI

A: If a resistance is added to rotor of a induction motor then the starting torque is increased  T is…

Q: 1.2.3 3. Use nodal analysis. please do complete kvl kcl solution solving thankyou

A:

Q: Given the discrete-time sequence a[n] = cos 3 Find two different continuous-time signals that would…

A:

Q: Find the Laplace Transform of the following. Answers must be in a simplified form and solutions must…

A:

Q: A 440 V, 22.5-hp, 50 Hz, 3-phase, 4-pole, star-connected induction motor has the following…

A:

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

A:

Q: 4. Use Norton's theorem to find Vo in the network. 2Ix 1220° v j22 Vo j42 320° A 1x le

A: In this question,   We need to determine the voltage Vo using the northern theorems analysis?

Q: Compose the mesh equations. 10 Q j10 Ω j10 Ω ... ell A) 10 v [1] sine ) i5 v j5 V sine -j10 O [12]…

A: In this question,   We need to determine the current I1 and I2 as shown the circuit?

Q: Q1) Define briefly: 1. Optoelectronics. 2. Electroluminescence. 3. Internal quantum efficiency. 4.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: On the structure below label the process names (ex. epitaxy of n-Si using SİH4; implantation of p+…

A: FABRICATION OF BJT p-type substrate oxide growth A slightly p-doped silicon wafer is used as a…

Q: A wye connected balanced load, supplied from a 3-phase balance supply with a line voltage of 416V at…

A: Given:W1=1980WW2=782Wf=50HzV=416V

Q: The Single phase fully controlled half- wave rectifier Resistive Inductive (RL) the value of ß…

A: for single phase fully controlled half wave rectifier resistive inductive load the value of beta…

Q: The efficiency of the I.M of the same :rating as transformer is

A: Effeciency of Induction motor compared to transformer:

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

A:

Q: Find the terminal voltage (in volts) on open circuit for a star-connected 6-Pole alternator having a…

A: In this question,   We need to Find the terminal voltage (in volts) on open circuit for a…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.