A)Calculate the force that support A exerts on the diving board. Ignore the weight of the board B)calculate de force that support B exerts on the diving board . Ignore weight of the board. C)calculate the support A exerts on the diving board. Take into account the board's mass of 36kg.assume the board's CG is at its center

Q: Can an object be in equilibrium when only one force acts on it? Explain.

A: Equilibrium of a body is a state where the net force acting on the body is zero. Force is a push or…

Q: 4.Two forces are acting on a body. For the body to remain in equilibrium, the forces have to be ____…

A: Given: Two forces are acting on a body. For the body to remain in equilibrium, the forces have to be

Q: Balance the load P1 on the moving pulley and P2 on the inclined plane as shown in the figure. Since…

A:

Q: 2. A carpenter holds a 6.00 m beam momentarily at rest with one end above rough floor/as shown in…

A: a)

Q: The leg and cast in the figure below weigh 258 N (w, ). Determine the weight w, and the angle a…

A: The free body diagram,

Q: Why does your laptop remain where it is when you place it on your desk? O t does not remain in place…

A:

Q: 77-kg man stands on his toes by exerting an upward force through the Achilles tendon, as in the…

A:

Q: A 180-kg horizontal beam is supported at the ends AA and BB. A 350-kg piano rests a quarter of the…

A:

Q: Answer this question asap , Don't use Artificial intelligence tool. This is important question

A: Please see the attached image for the solution.  If there are queries or if the image is not…

Q: 1. Forces with magnitudes of 126 N and 300 N act on a hook. The angle between the two forces is 45º.…

A:

Q: . Why are the forces exerted on the outside world by the limbs of our bodies usually much smaller…

A:

Q: 3) You stand at the end of a uniform diving board a distance d from support 2 (as shown in the…

A:

Q: 5)A 5kg block rests on a rough surface (s=0.5, µk=0.3 ). A 20 N force at an angle of 30° above the…

A: According to concepts of friction, when a block is at rest and a force is applied on it then the…

Q: If a ladder weighing 250N is placed against a smooth vertical wall having a coefficient of friction…

A: Given, Weight of ladder, W=mg=250 N Coefficient of friction between ladder and floor, μ=0.3

Q: naew b)Determine the forces in all the members of truss loaded and supported as shown in figure…

A:

Q: The mass of the right box is 50kg. The coefficient of static friction between between each box and…

A:

Q: part a) Determine the tension force that the horizontal cable exerts on the beam (which is analogous…

A:

Q: Consider the 57.0 kg mountain climber in the figure below. 31 15

A: Consider the free-body diagram of the climber as follows.

Q: 10N 60 8N

A:

Q: The Russell traction system shown below is used for a fractured femur. Identify the forces acting on…

A: As there are 3 different questions, we will answer the first one as per our policy. Kindly resubmit…

Q: 4m 5- The plate ABCD is supported by cables at B and C as shown. The 3m tension in cable BE is 800 N…

A: Given, The tension of cable toward B to E is, TBE=800N The tension of cable toward C to D is,…

Q: You injure your back at work lifting a 420-N radiator. To understand how it happened, you model your…

A:

Q: 2. What horizontal force P is required to hold the 100- lb weight W in the position shown? LLLLLU.…

A:

Q: Unless otherwise instructed Use g =10m/s2 Answer in SI unit to 2 decimal places Sam and Joe are…

A:

Q: Calculate the force the biceps muscle must exert to hold the forearm and its the Figure?

A: Given:- A figure is given as  Find:- a. Calculate the force that the biceps muscle must exert to…

Q: Q1) A weight "W" is suspended on the 120 kg cylinder on the inclined surface as shown in the figure.…

A: Mass of cylinder, mc=120 kgAngle of incliniation, θ=30°Inner radius, r1=20 cm=0.2 mOuter radius,…

Q: plank is supported by 120N forces at A and B, as shown. The support at A is then repositioned to C…

A: step1:A plank is supported by 120N each at A & B.The position of A is changed to C We need to…

Q: 4. A cable supports a 40 kip and 50 kip load, as shown above. The angle of cable T1, theta, is 51.34…

A: Mass of the smaller block is m=40 kip Mass of the larger block is M=50 kip Angle made by the cable 1…

Q: Ql: Determine the magnitudes of the forces C and T, which, along with the other three forces shown,…

A:

Q: 1. Six identical blocks weighing 100-N are placed on a leveled table as shown in the drawing below.…

A:

Q: Questions a) True or False: If the forces on an object are balanced, then the object must be…

A:

Q: Can a body be in equilibrium, if it is in motion? Explain.

A: Yes, Such an equilibrium situation is called dynamic equilibrium. So an object in equilibrium can…

Q: If the angle of slope is 0 degree with the horizontal, the normal force will be ---

A: To explain the correct answer is given below.

Q: Q3) Determine the force in members GH, GB and GC of the truss used to support the sign, and state if…

A:

Q: QI) Determine the magnitude and direction of F; so that If the resultant of the three forces act on…

A: Let the angle between F1 and F2 be φ and between x-axis and resultant force be α. The resultant…

Q: Here are the basic calculations to use for hanging the chandelier as per Edith's requirements:…

A:

Q: Q2) The truss, used to support a balcony, is subjected to the loading shown. Approximate each joint…

A:

Q: 1. Using the same force table that you used, a student was given two forces and asked to find a…

A: a)Force in x direction is f cosθ

Newton's First Law of Motion

If a very smooth ball is rolled down an inclined surface with zero friction, the ball will continue to roll indefinitely for an infinite time, in an attempt to reach to the same height on the opposite hill!