According to first law of thermodynamics work done by a system is equal to heat transferred by the system total internal energy of a system during a process remains constant O total energy of a system remains constant O The sign of heat transfer to a system is and work done on a system is Positive, negative O Positive, Positive O negative, Positive O

According to first law of thermodynamics work done by a system is equal to heat transferred by the system total internal energy of a system during a process remains constant O total energy of a system remains constant O The sign of heat transfer to a system is and work done on a system is Positive, negative O Positive, Positive O negative, Positive O

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.19P: 1.19 A cryogenic fluid is stored in a 0.3-m-diameter spherical container is still air. If the...

See similar textbooks

Similar questions

2.34 Show that the temperature distribution in a sphere of radius . made of a homogeneous material in which energy is released at a uniform rate per unit volume , is
Show that the rate of heat conduction per unit length through a long, hollow cylinder of inner radius ri and outer radius ro, made of a material whose thermal conductivity varies linearly with temperature, is given by qkL=TiTo(rori)/kmA where Ti = temperature at the inner surface To = temperature at the outer surface A=2(rori)/ln(ro/ri)km=ko[1+k(Ti+To)/2]L=lenthofcyclinder
The tip of a soldering iron consists of a 0.6-cm- diameter copper rod, 7.6 cm long. If the tip must be 204C, what are the required minimum temperature of the base and the heat flow, in watts, into the base? Assume that h=22.7W/m2KandTair=21C.
What are the important modes of heat transfer for a person sitting quietly in a room? What if the person is sitting near a roaring fireplace?
A pipe carrying superheated steam in a basement at 10C has a surface temperature of 150C. Heat loss from the pipe occurs by radiation (=0.6) and natural convection (hc=25W/m2K). Determine the percentage of the total heat loss by these two mechanisms.
1.19 A cryogenic fluid is stored in a 0.3-m-diameter spherical container is still air. If the convection heat transfer coefficient between the outer surface of the container and the air is 6.8 , the temperature of the air is 27°C, and the temperature of the surface of the sphere is –183°C, determine the rate of heat transfer by convection.
2.2 A small dam, which is idealized by a large slab 1.2 m thick, is to be completely poured in a short Period of time. The hydration of the concrete results in the equivalent of a distributed source of constant strength of 100 W/m3. If both dam surfaces are at 16°C, determine the maximum temperature to which the concrete will be subjected, assuming steady-state conditions. The thermal conductivity of the wet concrete can be taken as 0.84 W/m K.
A steel cube is to be heated from 120°C to an average temperature of 180°C in 45 minutes. One side of the cube is 50 cm in length. Taking the average density and specific heat of steel in this temperature range to be ρ = 7,950 kg/m 3 and c p = 0.49 kJ/kg·°C, respectively, determine a) the total amount of heat transfer to the steel cube, b) the average rate of heat transfer to the cube, C) the average heat flux.
You are asked to assess the validity of a power-generating device. The device supposedly operates steadily by receiving 256 kW via heat transfer at 4.5 °C, receiving 370 kW via heat transfer at 115 °C, and rejecting 200 kW via heat transfer at -180 °C. The device generates electrical power in response to these various heat transfers. a. determine its electrical power output, in kW. b. Is the device feasible? Does it violate 1st and/or 2nd law of thermodynamics?
Q1.1 : The inner and outer surfaces of a 5-m x 6-m brick wallof thickness 30 cm and thermal conductivity 0.69 W/m · °C aremaintained at temperatures of 20°C and 5°C, respectively.Determine the rate of heat transfer through the wall, in W
: A spherical container ( k= 30 W/moC ) with inner radius r1 = 2 m and outer radius ro=2.1 m is is filled with ice water T= 0 oC subjected to the convection on the outer surface T∞2 = 25 oC , h∞2= 18 W/m2 oC .For steady one-dimensional heat transfercalculate a) The mathematical formulation b) the variation of temperature, and c) therate of heat transfer are to be determined fo
A food product containing 85% moisture content is being frozen. Estimate the specific heat of the product at -4 ° C when 62% of the water is frozen. The specific heat of the dry product is 2.5 kJ / (kg ° C). It is assumed that the specific heat of water at -10 ° C is the same as the specific heat of water at 0 ° C, and that the specific heat of ice follows the function Cp es = 0.0062 Tbeku + 2.0649. Cp of frozen product = Answer kJ / kg ° C.