Adding more resistors to a parallel circuit will __________ the total resistance.     decrease     increase     not affect

Q: An open loop control system results in -2t a response of ¤¯¤¹(sin5t+cos5t) for a unit impulse input.…

A: Given- Open loop control system response, Ft=e-2tsin5t+cos5t. Unit impulse input.   To find- The DC…

Q: In the circuit below, R₂ = 300 kk = 1 mA/V², Vt = -1 V, VDD = 5 V, find R₁ such that ID = 2 mA. R₂…

A: We need to find out value of unknown resistor for given circuit.

Q: A certain transmission line working at a radio frequency has the following constant L=9μH/m,…

A: A certain transmission line working at a radio frequency has the following constant : L=9 μH/mC=16…

Q: To sketch the characteristic curve of the diode you need to vary voltages on diode and measure…

A: The diode conducts only during the forward bias and, it will not operate during the reverse bias.…

Q: The activation function in the example is assumed to be linear as f(x) = x. Repeat the example and…

A: We have to drawn update code functionthe given Activation Code function

Q: A three-phase star-connected alternator working at 1400 KVA, 50 Hz,2300 V, has an armature dc…

A:

Q: 8. Determine the inductance at terminals A-B in the network. Ao- Bo 1 mH 4 mH 2 mH 12 mH 3 mH 2 mH 4…

A: We need to determine equivalent inductance between terminals A and B. i.e Leq.

Q: A separately excited DC motor runs at 1000 rpm on no load when its armature terminals are connected…

A: Given data,Terminal voltage Vt=200 V Armature Resistance Ra=1 Ω Rotor speeds, At no-load, Nno…

Q: Consider the circuit from P2 in PS2, now connected to an external source as shown in figure 2. The…

A: Given that,  Supply voltage VAC=Cos(Ωt+ϕ), Inductor and Capacitor are parallelly connected and…

Q: Blank Use the Norton equiplent circuit to determine the power dissipated by 50.2. олог 25.12 wwwww…

A:

Q: The parallel plate capacitor in the figure below has a plate area A and plate separation d. The…

A:

Q: . Find the mesh currents.

A:

Q: 11.Calculate the unknown voltages, currents, and powers and properly label the schematic. E1 12 V +…

A:

Q: - 1- An LSI system with system function H(z) = 2 − 2z−¹ – 2z-² is used to filter a discrete-time -…

A:

Q: The power output of the half-wave rectifier is rated at 102.4 W with a load resistor of 40 ohms. The…

A: Given, P = 102.4 W R = 40 ohm

Q: In the system shown in the figure, r(t) = sin wt 16 s(s+4) r{t). *c(t) The steady-state response…

A:

Q: B3 A3 B Full Adder Cout A Cin Cout S S3 B₂ A₂ B A Cin Full Adder Cout S S₂ B1 B A₁ A Cin Full Adder…

A:

Q: .. R(T) = 5 √ {4+ + 10 cos [1017+ + Tan" (413)] +10 CO8 [LOTT (t+7) + Tan`¹ (413)] 0.2 5.√ [4+10 cas…

A: Given,  We need to explain the equation part.

Q: material at T = 300 K is 5.50 eV. The electrons in this material follow the Fermi-Dirac distribution…

A: The name Fermi is given on physicist Enrico Fermi. Fermi energy used to describe thermal property of…

Q: JF. Ст-

A:

Q: The following three impedances are connected in series across a 40V, 20 kHz supply: (i) a resistance…

A:

Q: 3V 5 V Figure 5 2V 4V

A: We need to find out the voltage for given circuit by using of KVL .

Q: You acquire a 20 Hz analog signal from sensor. Now you need to digitalize it to process it on an on-…

A: .                          SOLUTION  GIVEN             f = 20 Hz ( Analog Signal from Sensor) LET…

Q: 20Y(+ GSL S VA 42 IA 3.5. 4 222 toy Determine the values of VA and la using a) Kirchhoffs Law b)…

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: Minimize the following boolean function- F(A, B, C, D) = Σm(1, 3, 4, 6, 8, 9, 11, 13, 15) + Σd(0, 2,…

A: Given here a Boolean expression and asked to minimize it.

Q: • Using series- parallel concept. Find the following. given circuit a a) I, I, I, I J b) Total…

A: Here we have to find the currents I1 , I2 , I3 , IT and total resistance  RT  and voltage  V  power…

Q: e 100 sin 377t =

A: We need to find out time period for given signal .

Q: A four-story office building has a required load of 60000voltamperes and single-phase 240volt feeder…

A:

Q: If Vs=147V, R1=49kΩ, R2=60kΩ, R3=24kΩ, L=181mH, determine the inductor current, iL (in mA) at…

A: Given, supply voltage, Vs=147 V Values of resistors, R1=49 KΩR2=60 KΩR3=24 KΩ The value of the…

Q: Formulate the Routhian array for each number and indicate the number of RHP. Q(s) = s³+10s²+31s+1030

A:

Q: Solve for the steady state error for input 5u(t). The function u(t) is the unit step

A: Given,

Q: If the current i(t) = 1.5t A flows through a 2-Hinductor, find the energy stored at t = 2 sec

A: Energy stored in inductor= 1/2×L×i(t)2 Where L = inductor i(t) = current flowing through inductor.…

Q: replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage…

A:

Q: Determine the current across R1 if Vi=5V.

A: The required parameter can be calculated by replacing the diode with a short circuit and then we…

Q: Briefly outline two (2) steps to consider during electrical load estimation in design works

A: In the draught design (early design) stage, electrical load estimation is crucial since it aids in:…

Q: 50 V + 6Ω M 3 i 2 Ω Σ8Ω 4Ω Ds 5Α

A:

Q: Using Figure 4, if a voltage source (Vs) of 10V is placed between the terminals where we determined…

A: Given, The figure of the circuit will be, Supply voltage, Vs=10 V

Q: 2. A generator has reactance of 0.25 p.u. based on 18 kV 500 MVA. The generator is connected to a…

A: In this question,  We need to determine the value of the Reactance of the generator.  We know  P…

Q: A short shunt compound DC generator delivers a load current of 30 A at 220 V and has armature,…

A:

Q: + V₁ R1 R2 ww U AF S a. For the figure on the left, find the frequency in Hz in which the transfer…

A:

Q: 1. Using KCL, KVL, and Ohm's law solve for and give the power absorbed in each and every element in…

A: We need to find out the current, voltage and power for given circuit .

Q: Find the transfer function, G(s) = Vo(s)/Vi(s) of the operational amplifier below. v(t) 4μF 600 ΚΩ…

A: We  need to find out the transfer function for given amplifier circuit.

Q: 14. Use mesh analysis to obtain is, iz, and is. 12 V | Α Vo ΖΩ 4Ω 3A 13 +1 8 Ω 210

A:

Q: 1₁ a. Find the value of V. Answer: Answer: b. Find the current (down) through R₁. Answer: c. Find…

A:

Q: 3. ва (1 lon М 5.1 20V +-) Зл ob

A:

Q: • Use Nodal analysis to find current flowing through all the branches in the following Circuit V₁ =…

A: In this question we need to find a branch current of the given circuit by using nodal analysis.

Q: For the network,determine the voltages VI and V2 and the current I. RSS 100 R₂ 29 + 18V RS60V, R3602…

A:

Q: Given two frequencies, 10 Hz and 320 Hz, calculate the number of octaves between them.

A:

Q: A boost converter is operated from a source voltage of 100V with a duty ratio of 0.4. The load…

A:

Q: Determine whether the following systems have the properties linearity, time invariance, BIBO…

A: Given, System is  y[n] = e-x[n] We need to check whether the system is  linear, time invariant,…

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.