Air enters an air conditioning system at 78 kPa, 28°C, and relative humidity 31% at a rate of 4.2 m3/min, where it is cooled until moisture in the air begins to condense. Calculate the calorie elimination rate.

Air enters an air conditioning system at 78 kPa, 28°C, and relative humidity 31% at a rate of 4.2 m3/min, where it is cooled until moisture in the air begins to condense. Calculate the calorie elimination rate.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter35: Comfort And Psychrometrics

Section: Chapter Questions

Problem 3RQ: Lower room temperatures can be offset in winter by A. lowering the relative humidity. B. being very...

See similar textbooks

Related questions

Q: Find the initial length of rod if strain value is 0.0003 and change in length value 0.3 mm

A: Given data : Change in length=∆L Strain=ε Required : Initial length of rod

Q: what is Cp of the air Properties and Compressor

Q: Determine the largest weight W that can be supported by two wires shown in Fig. P-109. The stress in…

Q: Q2/ In the mechanism shown in Fig. below the crank AOB rotates uniformly at 200 rev/min, in…

A: To determine: The velocity and acceleration of slider F.

Q: Shown below is the Time Temperature Transformation diagram for a eutectoid steel. Refer to this…

A: The time temperature transformation curve is given in which sample comes across the curve above the…

Q: A reciprocating pump running at 1 rps and discharges oil (p = 850 kg/m3) at a rate of 366.1 gpm. The…

A: Given:Pump speed, N=1 rpsDensity of oil, ρ=850 kg/m3Oil flow rate, Qact=366.1 gpmBore, D=250 mm=0.25…

Q: 38 The 25-kg slider in the position shown has an initial velocity vo 0.6 m/s on the inclined rail…

Q: Determine the average bearing stress at Cin member BC. The average bearing stress at C in member BC…

Q: 7. Blood is flowing through point P (Figure 2.5), which is connected to a catheter tip manometer…

Q: Blocks A and B have a mass of 7 kg and 10 kg, respectively. Using the coefficients of static…

Q: A-find the zero force members of the truss shown below. B- Using section method determine the force…

A: Given,

Q: Q3: A block brake with a torque of 250 N-m. Its drum rotates at 100 rpm. The length of the block (1)…

Q: 2.3. The wooden box beam shown in figure (3a) is fabricated from four boards fastened together with…

A: Solved below

Q: A thermocouple produces an emf in mV according to the temperature difference between the temperature…

A: Introduction;- The working of thermocouples is based on the principle Seebeck effect. Seebeck…

Q: ms Rigid bar ABCD shown in the figure is supported by a smooth pin at D and by vertical aluminum…

Q: AB, BC, CD, DE are each 2m long and the plane distance from A-D is 4m. Members are at right angles…

Q: Q6/ In the mechanism shown in Fig. below, the crank AB is 75 mm long and rotate uniformly clockwise…

A: Given: Lets consider the given, Length of the link, AB=75 mm Length of BD=BC=DC=DE=300 mm Scale 0.1…

Q: diameter of the riser (in cm)

A: Given, Dimension of a cylindrical side riser is= 25 cm×15cm×5cm Tabulated data is given as, Shape…

Q: What is the goal of the Multitasking machine?

A: A multitasking machine is used for the the different types of work to be performed with the help of…

Q: - Find the potential energy of a 2 kg rock held 3 meters above the ground.

A: Given: Mass of the block, m=2 kgHeight of the block from the datum, h=3 m

Q: Use the tables of moist-air properties to find the enthalpy and specific volume for air at 70°F…

A: Introduction:- Psychrometry is a branch of science that deals with moist air. moist air is the…

Q: 7. Determine the magnitude, direction, and sense of the resultant force for the coplanar concurrent…

Q: Water at 15°C flows through a 10 cm cast iron pipe at 12 L/s. Calculate the friction factor. a.…

A: Givenfluid-water at 15oCd=10cm=100mm=0.1mQ=12L/s =12×10-3 m3/s

Q: 8-137. The three stone blocks have weights of W, 600 16, Wa 150 lb, and We- 500 th Determine the…

Q: Define discrimination as it applies to measurements.

A: intro; discrimination should be used for measurement of small change in a system.

Q: age drop of 5 V and an electric current of 0.1 A. What is the velocity of the air?

Q: Cylinder B has a downward velocity in meters per second given by UB = 2/2 + 1³/6, where t is in sec-…

A: vB = velocity of B in downward direction in m/s = t22 + t36 m/s where, t is time. Assuming, aA =…

Q: B: The pump in Fig. Q3B increases the pressure in the water from 200 to 4000 kPa with a flow rate of…

Q: minimum damping coefficient such that there is no oscillation

Q: A body was at rest. A force of 15 N acted on it for 4 sec, and then that force stopped. The body…

A: Given:For 1st part body move from rest to certain velocity 'v' with the help offorce 15 N,initial…

Q: 1- You have been asked to decide which one can be used for the dental handpiece water supply; a…

Q: Identify the number of degrees of freedom of the following systems. Explain why. Specify…

A: Given: There are four mechanical system with different orientations of springs and masses. Degree of…

Q: 2/210 Cylinder B has a downward velocity in meters per second given by UB = 12/2+³/6, where t is in…

Q: The image below shows a beam subject to two couples, F₁ = 7.5 N and F2 = 1.2 N. (Figure 4) The…

Q: As shown, a frictionless pulley hangs from a system of springs and a cable. The pulley is…

Q: 33. Specify a suitable steel tube from Table A15-14 to support one side of a platform as shown in…

A: Given: Let us consider the given data, The total load applied, P=55000 lb Length, L=18.5 ft Yield…

Q: Consider the arrangement shown in Fig. 1. For this setup the streams of air and water flow are…

Q: The Reynolds number is defined for a pipe as (velocity· diameter· density) / viscosity. What is the…

Q: A rocket is accelerating horizontally to the right at 10 g. The pressure gauge is connected by a 0.6…

A: Given data: ● The horizontal acceleration of the rocket to the right: ax = 10 g ...(g = 9.81 m/s2) ●…

Q: 2. Compute the horizontal and vertical components for the 50 N force shown below.

A: Given in the question:

Q: The cart shown has the following velocity as a function of time. a. What is the acceleration at 50…

A: From the given plot, v = 0 m/s at t = 0 s v = 8 m/s at t = 100 s v = 0 m/s at t = 200 s It is…

Q: The average temperature of the atmosphere in the world is approximated as a function of altitude by…

A: Given data: Tatm=288.15-6.5zz=33000 ft Need to determine the average temperature of the atmosphere.

Q: At a given instant, the position of a plane at A and a train at B are measured relative to a radar…

A: Given: Let us consider the given image,

Q: 1. The plane surface AB in the figure is rectangular in shape, 3 m wide, an d5 m long perpendicular…

A: We will answer the first question since the exact one was not specified. Please submit a new…

Q: The upper deck of a footballs stadium is supported by braces, each of which transfers a load P = 700…

Q: Determine the response of a system with a degree of freedom to an F impulse for the following data:…

A: Givenm=6kgc=9Ns/mk=34N/mF=5N

Q: у D 30° h

A: givenF=-40i+60j N

Q: The torsional system of Figure Q6 oscillates about the centre of the disc. A linear spring and a…

A: Given: Radius of the inner disc→r=0.15 m Radius of the outer disc→R=0.25 m Mass of the disc→m=5 Kg…

Q: The three-step pulley is subjected to the given couples. (a) Compute the value of the resultant…

Q: Vision about yourself as future mechanical engineer

A: Given question : Vision about yourself as future mechanical engineer The question indirectly…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Air enters an air conditioning system at 78 kPa, 28°C, and relative humidity 31% at a rate of 4.2 m3/min, where it is cooled until moisture in the air begins to condense. Calculate the calorie elimination rate.
Air enters a heating section at 95 kPa, 10°C, and 30 percent relative humidity at a rate of 6.2 m3/min, and it leaves at 25 C Use data from the tables. Determine the rate of heat transfer in the heating section The rate of heat transfer is [ kJ/min
As the Airstream is cooled and dehumidified, the relative humidity____ and the absolute humidity___ A. Increases , Increases B. Decreases, Decreases C. Increases, decreases D. Decreases, Increases
Water at a flow rate of 40 kg/s should be cooled from 40°C to 30°C in a humid cooling tower. Atmospheric air used in the cooling tower enters the cooling tower at 1 atmosphere pressure, 22°C dry bulb, 16°C wet bulb temperatures and 32°C temperature, 95% relative humidity. Calculate (a) the volumetric flow rate of the air at the entrance to the tower, (b) the mass flow rate of the conservation behaviors required for cooling, using the psychometric diagram.
Consider 2000 ft3 of an air–water vapor mixture at 14.7 lbf/in.2 , 90 F, 70% relative humidity. Calculate the humidity ratio, dew point, mass of air, and mass of vapor.
In an air-conditioning unit 3.5 m3/s of air at 27 °C dry-bulb temperature, 50 percent relative humidity, and standard atmospheric pressure enters the unit. The leaving condition of the air is 13 °C dry-bulb temperature and 90 percent relative humidity. calculate the enthalpy(H1 and H2).
2,000 m3 /h of return air at 25 °C and 40% relative humidity are mixed with 500 m3 /hof outside air at 3 7 °C and 60% relative humidity before entering a cooling coil. Themixed air is then cooled sensibly to 1 7 °C.Sketch the process on the psychrometric chart and find the followings:a- Humidity ratio of mixed air before entering the cooling coil.b- Enthalpy of mixed air before entering the cooling coil.c- Relative humidity and d~w point temperature of the supply air.d- Coil cooling capacity.
Example 2: Moist air at 35C db, and specific volume 0.89 m3/kg. Determine: - Enthalpy h, Specific humidity .
If the air temperature is 85°F, what is the water vapor pressure corresponding to a relative humidity of 55 percent and at 55°F with 25 percent relative humidity.
absolute humidity at atmospheric pressure at 27 °C is 0.015 kg water / kg dry air. Specify:a. water vapor partial pressure (kpa)b. relative humidity (%)c. dew point temperature (° C)
what is the relationship and formula of relative humidity and temperature?
If moist air has a saturation humidity ratio of 0.016872 kg v/kg da at a pressure of 1.2 bar, what is the dew point temperature at this state? Note: ta- twb = tap for saturated air. Express your answer in °C.