7. Blood is flowing through point P (Figure 2.5), which is connected to a catheter tip manometer system. Blood enters the manometer and equilibrates the pressure of the various fluids within the system (as denoted in the figure). Calculate the pressure within the blood vessel. Blood density is 1050 kg/m³, atmospheric pressure is 760 mmHg Fluid 1, P₁ = 879 kg/m³

7. Blood is flowing through point P (Figure 2.5), which is connected to a catheter tip manometer system. Blood enters the manometer and equilibrates the pressure of the various fluids within the system (as denoted in the figure). Calculate the pressure within the blood vessel. Blood density is 1050 kg/m³, atmospheric pressure is 760 mmHg Fluid 1, P₁ = 879 kg/m³

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Given: diameter of pipe in point 1 = 3.9indiameter of pipe in point 2 = 2.5inspecific gravity of the liquid = 0.79h(ft) = 0.60ftpressure at point 1 = 14.6 psiapressure at point 2 = 49 psiapump and motor efficiency = 66%diameter of pipe in point 4 = 4.5indiameter of pipe in point 5 = 2.3 inZ3 = 35ft With the schematic diagram of a pump, tanks, and piping determine the following:1) The velocity of the liquid at point 2 (ft/s)2) Pump work used by the liquid (Wpump U) (hp)3) Electric motor power in out (kW)4) In figure 3, the shaded (pink) in the U tube is mercury; determine y. specific gravity of mercury 13.75) Mass flow rate
Using the data given in the schematic attached, find the difference of pressure PA and PB h1= 0.65m h2= 0.1m h3= 0.75m h4= 0.45m Density of fluid A is pA= 900kg/m3 Density of fluid B is pB= 1034kg/m3 Mercury density is pHg= 13600kg/m3 Oil density is poil= 700kg/m3 (In the given figure, the pipelines are parallel to each other and not necessarily at the same height.)
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. ( WITH FREE BODY DIAGRAM ) CHOIECES: A.2.56 B.-2.72 m C.12.74 m D.-4.67 m
Q7. Cavitation just starts to occur in the venturi meter shown in Figure 5 when gage A indicates a pressure of 100 kPa gage. If D = 30 cm and d= 10 cm, what is the water discharge in the system for this condition of incipient cavitation? The atmospheric pressure is 100 kPa gage, and the water temperature is 25°C. Neglect gravitational effects.
An incompressible fluid (water) flows steadily from an open tank. The elevation of point 1 is 10.0m, and the elevation of point 2 and 3 is 2.00m. The cross-sectional area at point 2 is 0.0680 m^2, at point 3 it is 0.0360 m^2. The area of the tank is very large compared to the cross-sectional area of the pipe. Assuming that Bernoulli’s equation applies, compute: The gauge pressure at point 2.
Gasoline specific mass: 0,82 g/cm3Diameter 1 = 150mmDiameter 2 = 100mmCalculate the volumetric flow rate through a pipe, considering the results in:a) Bourdon Tubeb) Differential Manometers
At one point in a pipeline the water's speed is 3.00m/s and the gauge pressure is 5.00•10^4 Pa. Find the gauge pressure at a second point in the line, 11.0m lower than the first, if the pipe diameter at the second point is twice that at the first. note: density of water is 1000 kg/m^3.
Find an expression for the velocity of water leaving the sprinkler. Find an expression for the gauge pressure at point A, a distance L1, upstream of the narrow pipes. Express the answer in terms of the flowrate, Q. The inner diameter of the first segment of the pipe is d1=10mm, the inner diameter of the second set of pipes is d2=1mm, with N=25. The flowrate through the sprinkler is Q=0.2 L/s. Flow in pipes typically becomes turbulent when the Reynolds number exceeds 2000. Comment on the accuracy of the assumption that the flow could be treated as laminar everywhere. May be assumed water has a density of 1000kg/m^3 and a viscosity of 1mPa s.
Water at 20 Degrees Celsius flows steadily with negligible viscous effects through the pipe shown. Both the pipe exit and top of the manometer are exposed to atmospheric pressure. The fluid in the vertical tube (manometer) is stationary so that the hydrostatic equation can be applied. Find: a) The gage pressure at point A (inlet of the pipe) b) The velocity at point A c) The diameter of the pipe outlet The density of water is 62.4 lbm/ft3 and 1 lbfs2/ft = 32.2 lbm.
Water flowing at 1.0 ft/s in a pipe passes into a constriction where area is one-tenth the normal pipe area. What is the decrease in water pressure in the constriction? The weight density of water is 62.4 lbs/ft^3. (Figure, Formula, Solution)
Include a free body diagram A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. A. 12.74 m B. -4.67 m C. 2.56 D. -2.72 m
When gage A indicates a pressure of 100 kPa gage, then cavitation just starts to occur in the venturi meter. If D = 40 cm and d = 10 cm, what is the water discharge in the system for this condition of incipient cavitation? The atmospheric pressure is 100 kPa gage, and the water temperature is 21°C. Neglect gravitational effects.