AL-C-R circuit as shown in figure is connected with a source 120 V ms and 50 Hz frequency. 100 Q 50 uF 100 mH 120 V rms Draw a phasor diagram of voltages and current in the circuit. What is the phase angle between current and voltage? а. b.

AL-C-R circuit as shown in figure is connected with a source 120 V ms and 50 Hz frequency. 100 Q 50 uF 100 mH 120 V rms Draw a phasor diagram of voltages and current in the circuit. What is the phase angle between current and voltage? а. b.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 28P: An PLC series circuit with R=600 , L = 30 mH. and c=0.050F is driven by an ac source whose frequency...

See similar textbooks

Similar questions

A power plant generator produces 100 A at 15 kV (rms). A transformer is used to step up the transmission line voltage to 150 kV (rms). (a) What is rms current in the transmission line? (b) If the resistance per unit length of the line is 8.6108/m , what is the power loss per meter in the line? (c) What would the power loss per meter be If the line voltage were 15 kV (rms)?
(a) Does the phase angle in an RLC series circuit depend on frequency? (b) What is the phase angle for the circuit when the inductive reactance equals the capacitive reactance?
A resistor and capacitor are connected in series across an ac generator. The emf of the generator is given by V(t)=V0cost , where V0=120V , =120rad/s , R=400and C=400F.(a)What is the impedance of the circuit? (b) What is the amplitude of the current through the resistor? (C) Write an expression for the current through the resistor. (d) Write expressions representing the voltages across the resistor and across the capacitor.
An ac source of voltage amplitude 100 V and frequency 1.0 kHz drives an PLC series circuit with R=20, L = 4.0 mH, and C=50F . (a) Determine the rms current through the circuit, (b) What are the rms voltages across the three elements? (c) What is the phase angle between the emf and the current? (d) What is the power output of the source? (e) What is the power dissipated in the resistor?
(a) What is the resonant frequency of an RLC series circuit with R=20 , L=2.0mH , and C=4.0F (b) What is the impedance of the circuit at resonance ?
A 20 resistor, 50F capacitor, and 30-mH inductor are connected in series with an ac source of amplitude 10 V and frequency 125 Hz. (a) What is the impedance of the circuit? (b) What is the amplitude of the current in the circuit? (c) What is the phase constant of the current? Is it leading or lagging the source voltage? (d) Write voltage drops across the resistor, capacitor, and inductor and the source voltage as a function of time, (e) What is the power factor of the circuit? (f) How much energy is used by the resistor in 2.5 s?
In a damped oscillating circuit the energy is dissipated In the resistor. The Q-factor Is a measure of the persistence of the oscillator against the dissipative loss. (a) Prove that for a ligt1y danced circuit the energy, U, in the circuit decreases according to the following equation. du dt =2u,where= R 2L (b) Using the definition of the Q-factor as energy divided by the loss over the next cycle, prove that Q-factor of a lightly damped oscillator as defined in this problem is Q= U begin U onecycle = 1 R L C c (Hint: For (b), to obtain Q, divide E at the beginning of one cycle by the change E over the next cycle.)
(a) Sketch a graph of the phase angle for an RLC series circuit as a function of angular frequency from zero to a frequency much higher than the resonance frequency. (b) Identify the value of at the resonance angular frequency 0. (c) Prove that the slope of the graph of versus at the resonance point is 2Q/0.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
For an RLC series circuit, R=100 , L = 150 mH, and C=0.25F . (a) If an ac source of variable frequency is connected to the circuit, at what frequency is maximum power dissipated in the resistor? (b) What is the quality factor of the circuit?
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
An PLC series circuit with R=600 , L = 30 mH. and c=0.050F is driven by an ac source whose frequency and voltage amplitude are 500 Hz and 50 V, respectively, (a) What is the impedance of the circuit? (b) What is the amplitude of the current in the circuit? (c) What is the phase angle between the emf of the source and the current?