All clients computers ae configured to receive IP addresses from thr DHCP server. However, clients on subnet B cannot access clients on subnet A.What is the most likely cause of this problem? a.IPV6 is disabled b. The IP address for the DNS Server is not available in scope option c. The IP address is not available in DHCP scope d. Server option is disabled

All clients computers ae configured to receive IP addresses from thr DHCP server. However, clients on subnet B cannot access clients on subnet A.What is the most likely cause of this problem? a.IPV6 is disabled b. The IP address for the DNS Server is not available in scope option c. The IP address is not available in DHCP scope d. Server option is disabled

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter7: Setting Up A Local Network

Section: Chapter Questions

Problem 5TC

See similar textbooks

Similar questions

The command below illustrates the configuration of the static route. Router(config)# ip route network-address subnet-mask {ip-address | exit-intf [ip-address]} [distance] What is the function of the parameter distance in the given command? a. To assign bandwidth b. To assign matric value c. To assign AD value d. To assign protocol value
During the process of redistributing a route into EIGRP, which parameter has to be specified? Exit interface and next hop IP address are all factors that affect administrative distance.
When a fresh IP configuration is required, DHCP clients issue a DHCPREQUEST packet.Is this true or false?
You are troubleshooting an issue and you think that it is a problem with the DHCP server configuration. Client get an IP address, they can ping IP addresses on the same network and on the internet, but they cannot pull up webpages. What is a likely cause of misconfiguration on the DHCP server? a.) incorrect ntp server b.) incorrect dns server c.) incorrect gateway d.) incorrect subnet mask
When you run a scan on your computer, you see a session with a host at the IP address 208.85.40.44:443. What protocol is in use for this particular session?
A. Write all commands to configure the next-hop Static IPv6 Routes in router Ibri for adding the remote networks.
Please answer all thefollowing two questions from the choosing the answer option. Thanks a lot in advance. 10) _______________A passive IDS can send an alart, but it is the network administrator's job to interpret the degree of the threat and to respond acfcordingly. Answer: True or False 13) Which of the following ACL configuration command on your router is correct for taking actions such that Only 120.3.6.7 has the right to access. Any other incoming packets from any other source will be blocked and denied any service. (Assuming that you can use any ACL name and any ACL number within the correct range. And using Basic-ACL Category) a) Rule is Deny source IP Address 10.3.65.7 configure a rule with ID 10 b) Rule is deny Source IP address 20.3.67, Configure the second rule without specifying an ID. c) Rule is permit source IP Address 120.3.67, Configure a rule with ID 20. d) All of the above
In the context of DHCP what is the purpose of an IP helper address? a. The gateway for the computers in the segment b. Used to map private addresses in public ones for the purpose of accessing the outside c. Allows routers to forward DHCP requests to the segment where the server can be found d. It is a temporary IP address used by end-devices to issue requests to the DHCP server
When a service provided by a host on your network must always come from the same server, you might assign that host a static IP address. I need to manually assign an IP address; what's the best method to use? to what extent did it come to be this way?