The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is setto 20ms/cm, and the 'volts/cm' switch is set to 30 V/cm. Determine the(i) amplitude of waveform Q.(ii)peak to peak value of waveform P,(iii) frequency of waveform P and(iv) phase angle difference between P and Q in Degrees and (v) Rm.s value of waveform Q.P.

Answered: Image /qna-images/answer/c838c299-0652-41ca-bc37-14923f191d42.jpg

Answered: amplitude of waveform Q. Opeak to peak…

amplitude of waveform Q. Opeak to peak value of waveform P, ) frequency of waveform P and :) phase angle difference between P and Q in Degrees and (v) R.m.s value of waveform Q|

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: tones of different frequencies below 5 kHz will sound different with respect to their A…

A: Given: Two tones of different frequencies below 5 kHz will sound different with respect to their…

Q: 12. The frequency of a damped harmonic oscillator is three-quarters of the frequency of the same…

Q: d. If you measure a shedding frequency of 5,400 radians/sec in the wind tunnel, what shedding…

A: Write the given information. Refer to part (c) for the velocity of air in the tunnel.

Q: Question 7 A string of length L is displaced at its midpoint by a distance d and released at t = 0 .…

A: The first two normal and exciting modes are as follows: When a string of length L is plucked into…

Q: Figure 2 shows the waveform of a complex sound. The frequency of its potehitial matched pitch is 500…

A: frequency is the the number of cycles per second A cycle is the time interval in which the pattern…

Q: On the next page is a schematic diagram of an actual marine propulsion system consisting of an…

A: Given:- According to Holzer method: θj = θj-1 -ω2∑i=1j-1 Ji θ1Kj-1 The…

Q: It is observed from the magnitude plot of a compliance transfer function of a mass spring damper…

Q: In the harmonic analyses of the function with m coordinates (t,y,), we calculate: Y, sin(2t,) Both O…

Q: below. Determine (a) the natural frequencies, (b) the modes shapes (with drawings).

Q: * Vibration is a study of Oscillation Damping ratio Natural ferquency of the system Temperture Fluid…

A: The damping ratio, natural frequency of the system are the terminology of the vibration. To know…

Q: 23) Fig. 3 shows the displacement – distance graph of a string executing transverse vibrations.…

A: Displacement - Distance graph is a graph obtained by plotting the displacement values along Y axis…

Q: Given data : Work done=3600 J Displacement=2.1 m Determine Force applied

A: Work done = Applied Force X Displacement

Q: hany oscillations ndulum complet

A: Repetition is the correct answer It is also known as frequency

Q: Write the standard form of simple harmonic motion.

A: The standard form of the simple harmonic motion is, y=Asinωt+ϕ Where, y is the displacement of the…

Q: Determine the two natural frequencies and mode shapes of thể two-mass syst

A: Given: To determine: Natural frequency mode shape

Q: Question 5: By considering the expression x(z,t)=Ae*cos(bt+cz+d) what must the coefficients a, b, e…

A: When an external force is applied to the oscillating mass its amplitude of oscillation decreases.…

Q: - Suppose aplane wave oscillates inside aresontar Cavity with frequency (V). Show that the resonant…

A: Given: Let us determine the phase difference between the cavity frequency and the oscillator…

Q: 3. For the following functions determine the period, frequency in Hertz and circular frequency in…

Q: Given mass1=10kg Jo=20kg-m2 mass2=15kg, a is half of b. The rocker is 30 centimeters long. k1=10N/m,…

Q: 1. Let a 4S m/ sec?, V. = 5 m / sec, find V and S at the end of 4 sec.

Q: personal frequency equation for the following

Q: A simply supported beam is subjected to two vibrations along its length, emanating from two machines…

A: Given vibrations are of the form. X1 = 4 sin ( 100πt + 3π8)X2 = 4.5 sin ( 100πt - 2π3) Generally,…

Q: The tendency of higher frequency source harmonics of a complex sound to drop off in power relative…

A: Given: Higher frequency source

Q: parameters table based on the modified D-H representation. e T matrices.

Q: Problem 2.13 A particle in the harmonic oscillator potential starts out in the state ¥(x. 0) =…

Q: Write down the main characteristics of the phase angle vs frequency ratio graph for different values…

Q: Longitudinal dynamic stability issues are focused on the aircraft's time historical response to…

A: Soln:- The answer is true

Q: A particle moves with a simple harmonic motion through space. it takes 5ms to complete one cycle.…

A: Given data time required to complete a cycle (t) = 5 ms = 5*10-3 s = 0.005 s To determine…

Q: Given that VB = 750 feet per minute, length of Q2B is 2 inches rotating uniformly counterclockwise,…

Q: AMoving to another question wil save this response Question ks m Uving the Fgure above. Tahe ku g2.…

Q: 12. The frequency of a damped harmonic oscillator is three-quarters of the frequency of the same…

Q: At resonance, the amplitude of vibration is (a) Very large (c) Zero (b) Small (d) Depend on…

A: Resonance is the phenomenon in which the excitation frequency of the structure matches the natural…

Q: From the graph shown below, determine the approximate values of tr, tr, tw and amplitude. t;: rise…

A: In a steady state response system, the rise time(tr) is defined as the time taken by response to…

Q: From the graph shown below, determine the approximate values of t, tr, ty and amplitude. t;: rise…

Q: An undamped oscillator has a natural frequency of a rad/s. Damping is added to the system to give a…

A: Natural Frequency: When a body is free and no forces are acting on the body, Even though it appears…

Q: A particle moves with a simple harmonic motion through space. it takes 3ms to complete two cycles.…

A: A system motion can be said to be simple harmonic motion when the system oscillates about its mean…

Q: (b) Vibrations of harmonic motion can be represented in a vectorial form. Analyze the values of…

A: Given: The amplitude, A = 2 m The angular velocity, w = 6 rad/s The time, t = 1 s

Q: 2 Figure Q2 illustrates a schematic model of seismograph system (a device to records earthquakes).…

A: Given Datam1=5S=51kg {S=1}m2=1T=15kg {T=5}k=2U00N/m=2400N/m {U=4} we have to derive this…

Q: When ... a seismic pickup system can be used to measure displacement, velocity, or acceleration…

A: Introduction: Seismic accelerometer is a device which is used to measure the displacement ,velocity…

Q: Figure Q2 illustrates a schematic model of seismograph system (a device to records earthquakes).…

A: Given: m1=50 kgk= 2800 N/mm2=11 kg

Q: The period of oscillation, T, equals:

A: Given: xt=0.3cosωtAt x=0, v=-1.256 m/sTo determine:The period of oscillation

Q: Given data : Work done=30 J Force-5 N Determine displacement

A: Given data : The value of work done W=30 J The value of force F=5 N To find : Displacement

Concept explainers

Forced undamped vibrations

In mechanical engineering, vibration is expressed as the term that occurs due to an object's backward and forward movement about a point of equilibrium. Generally, there are three types of vibrations which are,

Question

The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set
to 20ms/cm, and the 'volts/cm' switch is set to 30 V/cm. Determine the
(i) amplitude of waveform Q.
(ii)peak to peak value of waveform P,
(iii) frequency of waveform P and
(iv) phase angle difference between P and Q in Degrees and (v) Rm.s value of waveform Q.
P.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The response of a system is given by xt=0.003cos 30t +0.004sin 30t m. Determine (a) the amplitude of motion, (b) the period of motion, (c) the frequency in Hz, (d) the frequency in rad/s, (e) the frequency in rpm, (f) the phase angle, and (g) the response in the form of xt=Asin (ωt+φ)
Please answer: How many degrees of freedom are in the system Write out the equations of morion in matrix form & Find the natural frequencies Given: k = 10 N/m; r = 0.5 m; I1 = 1.25 kg*m2 ; I2 = 1.2 kg*m2; m = 1 kg
ABOCD are five points, in that order, in a straight line AD. AO=OD. A particle moving with SHM along the line takes one second to move from A to C. The frequency of the particle's motion is 0.3183 Hz. The velocity of the particle at 0 is 14m/s.1. Determine the amplitude of the motion 2. What is the displacement of C from O?3. Determine the lengh AB if the velocity of the particle at B is 9.8 m/s.
Find the natural frequencies for the system illustrated below.
A simple harmonic motion is defined by the expression a = - 25 s. Determine its period and frequency.
A device with a mass of 1000 kg is placed on top of the suspension, whereby the springs are compressed into a pile a distance of 4 mm. What is the system specific angle frequency (rad / s) to one decimal place?
If a mass of 6 kg oscillates on a spring having a mass 3 kg and stiffness 11200 N/m, then the natural frequency of the system in rad/sec will be
For the given maximum and minimum speed as 136 r.p.m and 112 r.p.m respectively .Then the coefficient of fluctuation of speed will be
A table has a vertical sinusoidal motion with a constant frequency. What is the largest amplitude that the table can have if an object on the table is to remain in contact?
solve please by lagrang method to find the eqation of motion and to find the frequencies and mode, please indetail. a : 255 mm b : 100 mm L : 400 mm M : 1.1 kg m : 0.995 kg k : 5 N/mm
The little brown bat is a common bat species in North America. It emits echolocation pulses at a frequency of 40 kHz, well above the range of human hearing. To allow observers to “hear” these bats, the bat detector as shown combines the bat’s sound wave at frequency f1 with a wave of frequency f2 from a tunable oscillator. The resulting beat frequency is isolated with a filter, then amplified and sent to a loudspeaker. To what frequency should the tunable oscillator be set to produce an audible beat frequency of 3 kHz?
Identify the expression for the natural frequency of the system shown in the figure.