An AC circuit with R, Land C in parallel, has the following branch currents. Resistive branch - 12 A Inductive branch - 11 A Capacitive branch - 6 A The phase angle between the supply voltage and the supply current will be approximately:

An AC circuit with R, Land C in parallel, has the following branch currents. Resistive branch - 12 A Inductive branch - 11 A Capacitive branch - 6 A The phase angle between the supply voltage and the supply current will be approximately:

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.23P: A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the...

See similar textbooks

Related questions

Q: Transform

Q: 6. Three inductive loads each of resistance 750 and inductance 318.4mH are connected in delta to a…

A: Given, Resistance per phase (Rph)= 75 ohm Inductance per phase (Lph)=318.4 mH Line voltage (VL)= 415…

Q: In a balanced star connected 3-phase circuit, of impedance (8+j6) ohm is connected to a 230V,50HZ…

A: Active Power(P): The power which is deployed and absorbed by the electric circuit to do some useful…

Q: 13. A 40 Q resistor and a 10 mH coil are in parallel across an 80 V, 500 Hz ac line. Find the (a)…

Q: In a star connected system, the three phase currents are mutually displaced by 120 degree. Select…

A: In star connected systems each phase is differ by 120 degrees apart. Ex: Phase A current : Ia= Ia at…

Q: 5. An inductive reactance of 8 2 is connected in parallel with a capacitive reactance of 18 02; this…

A: given a electrical circuit in word and asked to find R for power factor = 0.5

Q: If a balanced 3 phase supply is provided to an inductive load, the phase current leads the phase…

A: Choose the correct option If a 3 phase supply iw provided to an inductive load, the phase current…

Q: Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal…

A: To determine the current in each branch

Q: 1. What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines…

Q: 2n jsn v joa

A: Given, We have a circuit with energy storage elements . We have to find V2 by using nodal analysis.…

Q: A. A single-phase AC circuit has got a supply voltage of 230 V at a phase angle of 15°, and has an…

Q: 20 0 a -MW- 0.25H 100 0 230Vms 60 Hz b ind the following: ) Power factor of the load to the right of…

Q: Three Impedances each of (8 - j18) are connected in mesh across a three-phase 410V ac supply.…

A: In this question we need to find a line current , phase current , real power and reactive power of…

Q: An AC series circuit has R=300 ohms, L=0.90H, and C=2.0microfarad with a generator of 50V andw= 1000…

Q: 41. Ideal inductors and capacitors are in phase with each other. True False "By the convention…

Q: A single phase lagging power factor load takes 300 W and 5 A at 120 V. Find the reactance of a pure…

Q: In a star connected system, the three phase currents are mutually displaced by 120 degree. Select…

A: STAR-CONNECTION: The diagram below depicts a three-phase, wye or star connected system with balanced…

Q: 13. A 40 Q resistor and a 10 mH coil are in parallel across an 80 V, 500 Hz ac line. Find the (a)…

Q: A symmetrical three-phase, three-wire 440 V supply is connected to a star-connected load as shown.…

A: Using star delta convertion we will find delta equivalent of star connected load.

Q: Impedances Z2 and Z3 in parallel are in series with impedance Z1 across a 100 V, 50 Hz ac supply. Z1…

A: Given Z1=6.25+j1.25Z2=5+j10Z3=5-jXc

Q: 1. How do you change the phase sequence of the three-phase source?

A: In this question we will write about changing the phase sequences ....

Q: In polyphase generation of power simultaneous multiple voltages are generated with a phase angle of…

Q: A resistor in series with a 138microfarad capacitor, is connected to a 60HZ source. If the voltage…

A: From given capacitor value and voltage across the capacitor capacitor calculate current through…

Q: In Industry, three Inductive loads each of resistance R = 29 ohms and inductanceL = 0.06 H are…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: An industrial facility consumes 25 MW (three-phase) at 0.80 power factor lagging. The voltage at the…

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you…

Q: 50. In AC circuit, Ohm's law proves that the phasor current though an element is equal to the ratio…

Q: An impedance (6+j8) is connected across 200V, 50Hz mains in parallel with another circuit having an…

A: given an impedance of 6+j8 ohms is connected across 200 V , 50Hz mains in parallel with another…

Q: Q.4 For the bridge network shown in Figure, determine the currents in each of the resistors by…

A: To find the currents through each resistor in the given network by using Kirchhoff's law

Q: The instantaneous values ofthe voltage across a two element series circum and the current flowing…

Q: Q1: A three branch parallel circuit has a current locus as given in Figure shown below. Determine…

A: Given:-w=500rad/sec

Q: The three-phase in the figure is 50 Hz, phase-to-phase 380 V, the impedance of the inductive load is…

A: It is given that; F=50Hz VL=380V Z=22.98+J19.28 Ω ϕ2=0.98

Q: Q: Prove that the capacitance of 3-ph overhead line (with the effect of ground) is given by: 2πε Cn…

A: Solution- Effect of earth on capacitance- The method of images is used to determine the capacitance.…

Q: 2. A series AC circuit consisting of R = 750 N and C = 3 µF are connected across a voltage source V…

Q: Q: Prove that the capacitance of 3-ph overhead line (with the effect of ground) is given by: 2πε Cn…

A: Capacitance- Capacitance is dependent on the ratio of Q and V and independent of the individual…

Q: 4.3. Consider 3 ac loads connected across a 240V ac source where: L1 absorbs 10kW at 0.8pf laggin L2…

Q: A 30-0 resistor, a 15-02 inductive reactance, and a 12-02 capacitive reactance are connected in…

Q: Prob.3. Two similar alternator operating in parallel have following dan Alternator 1 - Capacity 700…

Q: 5. Box A consumes 1 kW at power factor 0.8 lagging. Box B consumes 1 KVAR at power factor 0.6…

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: In a star connected system, the three phase currents are mutually displaced by 180 degree. Select…

A: Three phase Star connected system

Q: Figure below shows a simple single-phase AC power system with three loads. The voltage source is V =…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: In Industry, three Inductive loads each of resistance R = 28 ohms and inductance L = 0.07 H are…

A: As per the honor code I will do only first three parts of the question. Kindly repost the other…

Q: Figure below shows a simple single-phase AC power system with three loads. The voltage source is V =…

A: Kirchoff's voltage law is an important method to solve big and complex circuits. According to KCL,…

Q: The resistor, inductor and capacitor are connected in the parallel in each phase of star connected…

A: R=100 ohmL=1 HC=100Ff=50 HzVL=400 V

Q: 3 times greater than the power dissipated in sta In 3-phase system, the power dissipated in delta…

A: In this question , we will find relation between power in star and delta connection..

Q: Electrical load that draws current whose impedance varies throughout the cycle of the input ac…

A: Correct option is TRUE we know that Non linear loads draws non linear current whose impedance is…

Q: 1Ω 2 mH A 16 Ω ll 100/0° V 2 mH B 133 µF 100/120° V b ell N 100/-120° V 1Ω 2 mH C 27 mH A…

A: In the 3 phase unbalanced load supplied by The balance load. Find the current Iab And IbB We are…

Q: In three phase power measurement, current coil is connected in series and potential coil is…

A: We know that Electrical power is measured with a wattmeter. A wattmeter consists of a current coil…

Q: In a A-connected source, the phase voltage is Ve = 102 V. What is between the lines in V? Your…

A: Given data, Delta connected source with Phase voltage, Vθ=120 V

Q: (b) An inductive load consisting of resistor, R and inductor, L in series feeding from a 240230°…

Concept explainers

Wheatstone Bridge Method

A Wheatstone bridge is a circuit used to measure unknown resistance by measuring the ratios of the two branches of the circuit such that each branch has two resistance and out of four resistance one is unknown. The two branches are joined in between with the help of galvanometer which is used to determine the direction of the current. The main advantage of this circuit is that it can provide the most accurate measurement (different from a simple voltage separator).

Question

Show solutions.

An AC circuit with R, Land C in parallel, has
the following branch currents.
Resistive branch - 12 A
Inductive branch - 11 A
Capacitive branch - 6 A
The phase angle between the supply voltage
and the supply current will be
approximately:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following series resistances and reactances: R1 = 10 ohm, R2 = 15, R3 = 5 ohms, XL1 = 20 ohms, XL2 = 25 ohms, XC = 40 ohms. Find the following: a.) EQUIVALENT REACTANCE b.) TOTAL IMPEDANCE c.) VOLTAGE DROP ACROSS THE CAPACITOR d.) TOTAL INDUCTANCE IN MILLIHENRY e.) TOTAL CURRENT f.) REACTIVE POWER g.) REAL POWER DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES
An AC circuit has the following loads; Resistance = 300 ohms, Inductance = 1.5 H, Capacitance = 10 microfarad, and these are connected to a 480-volt 60-hz power source. Determine the apparent power, power factor & power factor angle when connected in a) series; b) parallel; and draw the phasor diagram of voltage and power when connected in series and current and power in parallel connection.
A three-phase steel-treatment electric oven has aphase resistance of 10Ω and is connected atthree-phase 380-V AC. Computea. The current flowing through the resistors in wyeand delta connections.b. The power of the oven in wye and deltaconnections.
TOPIC: Ohm's Law, Power and Generating Direct CurrentDirect Current Circuit AnalysisInductor, Capacitor, Generating Alternating Current Please Answer with complete solutions: V1 V2 V3
A machine shop is fed by a 250 kVA 480 V three-phase electrical service. On one of thebranches leading away from the service, the shop runs several manufacturing machines,giving the branch a load profile of 175 kW with a 0.85 lagging PF.Determine the minimum allowed gauge of the branch conductors. Branch conductors arealuminum, THW, contained within a raceway with an ambient temperature of 40 ºC
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
an R-L circuit takes a current of 7amp that lags behind the 231-volt source by 35elec deg. calculate the power factor, power, impedance, resistance, and inductive reactance of the circuit.
Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω are connected in parallel. If the average value of 198 V sinusoidal AC voltage is applied to this system, find the line current, impedance and phase angle of the circuit. (Take the frequency as 60 Hz.)
A 60Hz sourcewith an effective voltage of 240 volts supplies 4500 volt-amp to a load with a p.f. of 0.75 lagging. Determine the parallel capacitance required to improve the power factor to: a) 0.9 lagging and b) 0.9 leading. What per cent reduction in line current resulted in part (a)?
Given the circuit shown below, if Zx = 100<0degrees determine the current in each branch using NODAL METHOD
In general, a three-phase induction motor isdesigned for wye connection operation. However, forshort-time operation, a delta connection can be used atthe nominal wye voltage. Find the ratio between thepower delivered to the same motor in the wye anddelta connections.
41. Ideal inductors and capacitors are in phase with each other. True False "By the convention we are using in this course, if the reactance (X) is positive, it is inductive in nature." True False In series-connected ac circuit, the total current though the circuit is always equal to the phasor sum of the individual current though each element." True False "In a R-L series circuit, R=10 ohms and X=10 ohms, the applied voltage is in phase to the circuit total current (assumed applied voltage is the reference)." True False