The three-phase in the figure is 50 Hz, phase-to-phase 380 V, the impedance of the inductive load is 22.98+J19.28 Ω. Power to make the coefficient 0.98; a-) the capacity of the capacitor to be connected to the circuit, b-)Find the value of the phase current after the capacitor is connected.

The three-phase in the figure is 50 Hz, phase-to-phase 380 V, the impedance of the inductive load is 22.98+J19.28 Ω. Power to make the coefficient 0.98; a-) the capacity of the capacitor to be connected to the circuit, b-)Find the value of the phase current after the capacitor is connected.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1P: Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to...

See similar textbooks

Related questions

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with…

Q: 2. A 60 Hz ídeal transformer ís rated at 4800/240 V. A load with impedance Z=12+ j9N is connected…

A: Turns ratio=primary voltagesecondary voltage power factor is the angel between voltage and current.

Q: Zjine 1:10 10:1 |Vc = 13.84 0° kV Z1oad T1 T2 A 13.8-kV, single-phase generator supplies power to a…

A: The transformer has a primary and a secondary side. It converts electrical power to electrical power…

Q: Q2: For the circuit shown below, determine the apparent power delivered by the source, power…

A: First we will calculate node voltage by nodal analysis. power loss =I2×R. power factor= cos(angle…

Q: In Industry, three Inductive loads, each of resistance R = 26 ohms and inductance L= 0.08 H are…

A: Given, a three inductive load delta connected system having, Resistance, R = 26 ohms Inductance, L =…

Q: 1. Three loads are connected in parallel to a 12040° Vrms source. Load 1 absorbs 60 kVAR at p.f =…

A: According to given question Load 1 : 60 kVAR at P.F.=0.85 lagging, cos∅=0.85⇒∅=cos-1(0.85)=31.788°…

Q: Problem 2 A fault current limiter as shown in the figure, has Li = 1 mH and a total impedance of j10…

A: Circuit is given as, Given data: L1=1 mHf=60 Hz

Q: A three-phase Δ-connected generator has an internal impedance of 9+j90 m Ω/ϕ. When the load is…

A: Now circuit diagram is,

Q: Consider a load that has an impedance given by Z = 130 – j70 N. The current flowing through this…

A: Ohm's Law According to ohm's law, the total current in the circuit is the ratio of voltage to total…

Q: In Industry, three Inductive loads, each of resistance R = 30 ohms and inductance L = 0.13 H are…

A: In the Star Connection, the 3 winding's similar endpoints are connected to a common point known as…

Q: The subtransient reactance of a generator is typically much larger than the steady-state reactance.…

A: 1 ) generally the subtrasient response of a generator is larger than the steady state reactance. So…

Q: Determine the impedance value per phase of an inductive load represented by R+jX in a circuit. The…

A: Given: Star connected balanced load. Q=5933.03 VARcosϕ=0.82 lagV=220∠0° V

Q: K J102 In the circuit shown, the load consumed (500VA) with (0.8) power factor. Compute the coupling…

Q: QI. A balanced three-phase Y-connected generator with positive sequence has an impedance of 0.4 +…

A: The generator is Y- connected.

Q: J52 Q.37: For the mutual coupled electric circuit shown in figure beside if Vs=2020° Volt, find the…

A: According to question: The current in the circuit is calculated as ∵I2Req=40⇒I2×10=40⇒I=2A The…

Q: he load impedance in the figure absorbs 2.5 kW and generates 5 kVAR The sinusoidal voltage source…

A: The power generated by voltage source:- Power absorbed by load :- 2.5 kWPower generated by source…

Q: Three Impedances each of (12 -j18)N are connected in mesh across a three-phase 420V ac supply.…

A: According to the given question, it is required to determine the below given parameters for the…

Q: (b) Figure QI(b) shows an AC circuit. Given the voltage, V, across the impedance Z, is 111.803 4 -…

Q: In Industry, three Inductive loads, each of resistance R = 20 ohms and inductance L= 0.1 H are…

Q: A three-phase system having an rms line voltage of 141.4V is connected to a delta balanced load with…

A: Given data, Line voltage VL=141.4 V Load impedance ZL=15∠300 Ω

Q: In Industry, three Inductive loads each of resistance R = 33 ohms and inductance L = 0.11 H are…

A: A star connected load has, Per phase resistance (Rph)= 33 ohm Per phase inductance (Lph)= 0.11 H…

Q: A 270 kV, three phase transmission line vith a 430 km length. The series mpedance Z =(0.345+j0.794)…

A: Transmission line parameters are given Find the T and π model equivalent circuit parameters

Q: An impedance ZL = (11.5 + j10) ohms is connected in parallel with an impedance ZC = (8 – j20) ohms.…

Q: 14. Consider this power distribution system to a customer: Transmission line current Power company V…

A: The solution is given below

Q: The series capacitors reactive compensation methods are attractive for decreasing the power…

Q: i where z, = 6 - j28 N, = 20 - j15 SN, and Z = 150 2, z, = 24 + j60 N, z, = 6 + j8 2, z, v = 120/2…

Q: 11.18 A three-phase A-connected generator has an inter- nal impedance of 9 + j90 m2/¢. When the load…

A: Since we are allowed to solve only up to three sub parts of a question the below solution contains…

Q: Calculate the conductance, susceptance and admittance of an impedance that is equal to Z = (3.6 +…

Q: Q5: Three-phase, 50 Hz, 132 KV power system of equivalent impedance 10+j35 Q with load 110+j29 Q.…

Q: A three-phase Δ-connected generator has an internal impedance of 9+j90 m Ω/ϕ. When the load is…

Q: 2) An industrial plant is supplied from 400V 50Hz power system. The plant consists of (i) 2x50kW…

A: An industrial plant is supplied from 400V 50Hz power system. The plant consists of (i) 2x50kW pure…

Q: The balanced system below has a phase voltage of 120 V. It supplies a balanced load Z1 that has…

A: In this question we need to find a total reactive power and true power of the given three phase…

Q: An impedance ZL = (11.5 + j10) ohms is connected in parallel with an impedance ZC = (8 – j20) ohms.…

Q: Q.14: In the circuit shown, the load consumed (500VA) with (0.8) power factor. Compute the coupling…

Q: The following 3-phase loads are connected to a 3- phase 400 V, 50 Hz power supply: [10] Load 1:…

Q: A balanced three-phase Y-connected generator with positive sequence has an impedance of 0.2 +…

A: We will first find per phase current and then find per phase power loss in the line. After that we…

Q: 9. a) Find Zin for the following circuit at w = 100 rad/sec. 20 N 10 2 Zin 2 mF 0.1 H b) A balanced…

Q: In Industry, three Inductive loads each of resistance = 32 ohms and inductance L = 0.16 H are…

A: According to question: a) Phase impedance…

Q: The line-to-line voltage at the terminals of the three phase load in the circuit shown is VAR = V3…

Q: For the circuit shown in the following figure, a) Find and draw the Thévenin equivalent circuit at…

A: Given that Electrical network as follows

Q: Three Impedances each of (8 – j18)N are connected in mesh across a three-phase 415V ac supply.…

Q: Electrical Engineering For the three-phase circuit obtain a) Obtain the complex power supplied by…

A: In this question we need to find a complex power supply by source and power factor

Q: 11.18 A three-phase A-connected generator has an inter- nal impedance of 9 + j90 m2/4. When the load…

A: Since there are multiple sub-parts of the question, so it is requested to kindly specify which…

Q: In Industry, three Inductive loads, each of resistance R = 30 ohms and inductance L = 0.13 H are…

A: inductive reactance Xc = 2*pi*fL given frequency f = 50 Hz and inductance L = 0.13 H impedance of RL…

Q: For the circuit shown below, find Thevenin's equivalent circuit and determine the load impedance…

A: The maximum average power of the voltage is as follows: Impedance of inductor ZL=jωL=j400×0.2=j 80…

Q: A non-reactive resistance of 60 Ω is connected in series with a 36 µF capacitor in each phase of a…

Q: In Industry, three Inductive loads each of resistance R= 24 ohms and inductance L = 0.13 H are…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: A balanced 3 phase Y connected generator with negative sequence has an impedance of 0.3+j0.5 QVO and…

Q: i)Evaluate the total impedance, average power, reactive power, and power factor in the provided…

Question

The three-phase in the figure is 50 Hz, phase-to-phase 380 V, the impedance of the inductive load is 22.98+J19.28 Ω. Power
to make the coefficient 0.98;

a-) the capacity of the capacitor to be connected to the circuit,

b-)Find the value of the phase current after the capacitor is connected.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.