An air bubble is allowed to rise through a long cylindrical column of a viscous liquid and travels at a steady speed (Z + 2.1) cm/s. If the density of liquid is (Z + 1.5) gm/cm³, and viscosity of liquid is (Z + 15.6) poise, find the diameter of air bubble. Consider g = 9.81 m/s2 and neglect air density.

An air bubble is allowed to rise through a long cylindrical column of a viscous liquid and travels at a steady speed (Z + 2.1) cm/s. If the density of liquid is (Z + 1.5) gm/cm³, and viscosity of liquid is (Z + 15.6) poise, find the diameter of air bubble. Consider g = 9.81 m/s2 and neglect air density.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 44PQ: Water enters a smooth, horizontal tube with a speed of 2.0 m/s and emerges out of the tube with a...

See similar textbooks

Similar questions

A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
When physicians diagnose arterial blockages, they quote reduction flow rate. If the flow rate an artery has been reduced to 10.0% of its normal value by a blood clot and be average pressure difference has increased by 20.0%, by what factor has the clot reduced the radius of the artery?
Using the equation of the previous problem, find the viscosity of motor oil in which a steel ball of radius 0.8 mm falls a terminal speed of 4.32 cm/s. The densities of the ball and the oil are 7.86 and 0.88 g/mL, respectively.
Water enters a smooth, horizontal tube with a speed of 2.0 m/s and emerges out of the tube with a speed of 8.0 m/s. Each end of the tube has a different cross-sectional radius. Find the ratio of the entrance radius to the exit radius.
In an immersion measurement of a woman's density, she is found to have a mass of 62.0 kg in air an apparent mass of 0.0850 kg completely submerged with lungs empty. (a) What of water does she displace? (b) What is her volume? (c) Calculate her density. (d) If her lung capacity is 1.7S L, is she able to that without treading water with her lungs filled air?
Show that the Reynolds number NRis unitless by substituting units for all the quantities in its definition and cancelling.
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
A spherical particle falling at a terminal speed in a liquid must have the gravitational force balanced by the drag force the buoyant force. The buoyant force is equal to the weight of the displaced fluid, while drag force assumed to be given by Stokes Law, Fs=6rv . Show that the terminal speed is given by v=2R2g9(s1) , where R is be radius of sphere, s is its ad 1 is of be fluid, and the coefficient of viscosity.
The inside diameters of the larger portions of the horizontal pipe depicted in Figure P9.45 are 2.50 era. Water flows to the right at a rate of 1.80 104 m3/s. Determine the inside diameter of the constriction. Figure P9.45
Mercury is poured into a U-tube as shown in Figure P15.17a. The left arm of the tube has cross-sectional area A1 of 10.0 cm2, and the right arm has a cross-sectional area A2 of 5.00 cm2. One hundred grams of water are then poured into the right arm as shown in Figure P15.17b. (a) Determine the length of the water column in the right arm of the U-tube. (b) Given that the density of mercury is 13.6 g/cm3, what distance h does the mercury rise in the left arm?
Logs sometimes float vertically a lake because one end has become water-logged and denser than the other. What is the average density of a uniform-diameter log that floats with 20.0% of its length above water?