An aluminum-alloy rod has a length of 12.831 cm at 14.00°C and a length of 12.840 cm at the boiling point of water. (a) What is the length of the rod at the freezing point of water? (b) What is the temperature if the length of the rod is 12.873 cm? (a) Number 12.8295 (b) Number i 434.195 Units Units cm °C

An aluminum-alloy rod has a length of 12.831 cm at 14.00°C and a length of 12.840 cm at the boiling point of water. (a) What is the length of the rod at the freezing point of water? (b) What is the temperature if the length of the rod is 12.873 cm? (a) Number 12.8295 (b) Number i 434.195 Units Units cm °C

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter19: Temperature

Section: Chapter Questions

Problem 19.11OQ: The average coefficient of linear expansion of copper is 17 106 (C)1. The Statue of Liberty is 93...

See similar textbooks

Similar questions

A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is completely filled with turpentine at 20.0C. The turpentine and the aluminum cylinder are then slowly warmed together to 80.0C. (a) How much turpentine overflows? (b) What is the volume of the turpentine remaining in the cylinder at 80.0C? (c) If the combination with this amount of turpentine is then cooled back to 20.0C, how far below the cylinders rim does the turpentines surface recede?
The rectangular plate shown in Figure P16.60 has an area Ai equal to w. If the temperature increases by T, each dimension increases according to Equation 16.4, where is the average coefficient of linear expansion. (a) Show that the increase in area is A = 2Ai T. (b) What approximation does this expression assume?
The average coefficient of linear expansion of copper is 17 106 (C)1. The Statue of Liberty is 93 in tall on a summer morning when the temperature is 25C. Assume the copper plates covering the statue are mounted edge to edge without expansion joints and do not buckle or bind on the framework supporting them as the day grows hot. What is the order of magnitude of the statues increase in height? (a) 0.1 mm (b) 1 mm (c) 1 cm (d) 10 cm (e) 1 m
A surveyor uses a steel measuring tape that is exactly 50.000 m long at a temperature of 20°C. The markings on the tape are calibrated for this temperature. When it is 35°C, the surveyor uses the tape to measure a distance. The value that she reads off the tape is 35.794 m. What is the actual distance? The coefficient of linear expansion of the glass is 1.20 x 10-5 K-1 A. 35.8 m B. 30.8 m C. 39.8 m D. 38.5 m
A spherical steel ball bearing has a diameter of 2.540 cm at 26.00°C. (Assume the coefficient of linear expansion of the steel is 1.10 10-5(°C-1), and the average volume expansion coefficient is 3.30 10-5(°C-1).) A) What is its diameter when its temperature is raised to 97.0°C? (Give your answer to four significant figures in cm.) B) What temperature change is required to increase its volume by 1.100%?
An aluminum wire is wrapped in rubber insulation. Both are subject to thermal expansion, with the following coefficients of linear expansion: alphaa=24· 10−6 1/C and alphar=8· 10−5 1/C . If the wire and insulation are the same length of 1.85m at a temperature of20.00°C, what is the difference in length (in MILLIMETERS) between the copper wire and the rubber insulation when heated up to a temperature of 189.00°C? Express a magnitude only (no negatives!). ______mm (MILLIMETERS!)
(k) A 250.-g sample of water at 369.0 K was added into 1.00 kg of water at 25.5°C in a coffee-cup calorimeter. Assuming no heat loss in the calorimeter, what is the final temperature of the total water in the calorimeter? A. 95.8°C C. 273.15 K D. 39.6°C E. None of the above. B. 298.7 K (1) A pistol cylinder contains 5.00 L nitrogen gas at STP. What is the density of this gas at 0.250 atm and 75%C
A U.S. penny has a diameter of 1.9000 cmcm at 20.0 ∘C∘C. The coin is made of a metal alloy (mostly zinc) for which the coefficient of linear expansion is 2.6×10−5K−12.6×10−5K−1. Part A What would its diameter be on a hot day in Death Valley ( 47 ∘C∘C )? Express your answer using five significant figures. Part B On a cold night in the mountains of Greenland (-50 ∘C∘C )? Express your answer using five significant figures.
A brass ring of diameter 10.00 cm at 22.3°C is heated and slipped over an aluminum rod of diameter 10.01 cm at 22.3°C. Assume the average coefficients of linear expansion are constant. (a) To what temperature must the combination be cooled to separate the two metals? ?°CIs that temperature attainable? Yes or No (b) What if the aluminum rod were 10.05 cm in diameter? ?°CIs that temperature attainable? Yes or No
Consider two cylindrical metal rods withequal cross section—one lead, the other aluminum—connected inseries. The temperature at the lead end of the rods is 22.5 °C; thetemperature at the aluminum end is 85.0 °C. (a) Given that the temperature at the lead-aluminum interface is 52.5 °C, and that the leadrod is 14.5 cm long, what condition can you use to find the length ofthe aluminum rod? (b) Find the length of the aluminum rod
Suppose you come across old scientific notes that describe a temperature scale called Z on which the boiling point of water is 65.00Z and the freezing point is –140Z. To what temperature on the Fahrenheit scale would a temperature of T= -98.00Z correspond? Assume that the Z scale is linear, that is, the size of a Z degree is the same everywhere on the Z scale.
At 18.75 °C a brass sleeve has an inside diameter of 2.21988 cmand a steel shaft has a diameter of 2.22258 cm. It is desired toshrink-fit the sleeve over the steel shaft. (a) To what temperaturemust the sleeve be heated in order for it to slip over the shaft?(b) Alternatively, to what temperature must the shaft be cooledbefore it is able to slip through the sleeve?