An aluminum-alloy rod has a length of 5.7751 cm at 11.00°C and a length of 5.8137 cm at the boiling point of water. (a) What is the length of the rod at the freezing point of water? (b) What is the temperature if the length of the rod is 5.8105 cm? (a) Number i ! Units cm (b) Number i ! Units °C > >

An aluminum-alloy rod has a length of 5.7751 cm at 11.00°C and a length of 5.8137 cm at the boiling point of water. (a) What is the length of the rod at the freezing point of water? (b) What is the temperature if the length of the rod is 5.8105 cm? (a) Number i ! Units cm (b) Number i ! Units °C > >

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter10: Thermal Physics

Section: Chapter Questions

Problem 21P: A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is...

See similar textbooks

Similar questions

A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is completely filled with turpentine at 20.0C. The turpentine and the aluminum cylinder are then slowly warmed together to 80.0C. (a) How much turpentine overflows? (b) What is the volume of the turpentine remaining in the cylinder at 80.0C? (c) If the combination with this amount of turpentine is then cooled back to 20.0C, how far below the cylinders rim does the turpentines surface recede?
A spherical steel ball bearing has a diameter of 2.540 cm at 30.00°C. (Assume the coefficient of linear expansion for steel is (11 ✕ 10−6 )(°C)−1. (a) What is its diameter when its temperature is raised to 102.0°C? (Give your answer to at least four significant figures.) cm (b) What temperature change is required to increase its volume by 1.100%?
At 18.75 °C a brass sleeve has an inside diameter of 2.21988 cmand a steel shaft has a diameter of 2.22258 cm. It is desired toshrink-fit the sleeve over the steel shaft. (a) To what temperaturemust the sleeve be heated in order for it to slip over the shaft?(b) Alternatively, to what temperature must the shaft be cooledbefore it is able to slip through the sleeve?
Approximately how long should it take 9.8 kgkg of ice at O•C•C to melt when it is placed in a carefully sealed Styrofoam ice chest of dimensions 25 cmcm ×x 35 cmcm ×× 55 cmcm whose walls are 1.2 cmcm thick? Assume that the conductivity of Styrofoam is double that of air and that the outside temperature is 29 •CoC.
A completely sealed container, in the shape of a cube with side panels of length = 0.69 m, is full of carbonic ice at temperature -103.1 °C and placed in a room where the ambient temperature is 36.7 °C. The thickness of each (identical) panel of the container is 5.4 cm. In 1.6 days (s), an amount of 3383899 J of heat is conducted through the panels. Find the thermal conductivity of the material which the panels are made of.
A tire is filled with air at 15 degree C to a gauge pressure of 230kPa. If the tire reaches a temperature of 38 degree C, what fraction of the original air must be removed if the original pressure of 230 kPa is to be maintained?
Suppose you come across old scientific notes that describe a temperature scale called Z on which the boiling point of water is 65.00Z and the freezing point is –140Z. To what temperature on the Fahrenheit scale would a temperature of T= -98.00Z correspond? Assume that the Z scale is linear, that is, the size of a Z degree is the same everywhere on the Z scale.
An aluminum wire is wrapped in rubber insulation. Both are subject to thermal expansion, with the following coefficients of linear expansion: alphaa=24· 10−6 1/C and alphar=8· 10−5 1/C . If the wire and insulation are the same length of 1.85m at a temperature of20.00°C, what is the difference in length (in MILLIMETERS) between the copper wire and the rubber insulation when heated up to a temperature of 189.00°C? Express a magnitude only (no negatives!). ______mm (MILLIMETERS!)
A walrus transfers energy by conduction through its blubber at the rate of 150 W when immersed in −1.00 °C water. The walrus’s internal core temperature is 37.0 °C , and it has a surface area of 2.00 m2 . What is the average thickness of its blubber, which has the conductivity of fatty tissues without blood?
A machinist wishes to insert a steel rod with a diameter of 5 mn into a hole with a diameter of 4.997 mm. B how much would the machinist, have to lower the temperature of the rod to make it fit the hole?
A bubble having a diameter of 92 cm is released from a depth of 4.5 m from the bottomof a swimming pool. The temperature of thewater at the surface is 22◦C, whereas it is 16◦Cat the point of release.What will the diameter of the bubble bewhen it reaches the surface? The accelerationof gravity is 9.8 m/s2and the density of wateris 1000 kg/m3.Answer in units of cm.
What is the change in length of a 3.00-cm-long column of mercury if its temperature changes from 39.0°C to 57.5°C, assuming it is unconstrained lengthwise? (Use 60 ✕ 10−6/°C as the coefficient of expansion of mercury. Be sure to include the correct sign with your answer.) mm