I REPEAT. TYPEWRITTEN ONLY ANSWERSDO NOT ANSWER IF YOU ALREADY ANSWERED THIS.DO THIS TYPEWRITTEN ONLY. I'LL UPVOTEDOWNVOTE IF HANDWRITTEN THANK YOU. An aluminum pipe with a length of 60 m at a temperature of 10°C rests freely on theground. An adjacent steel pipe at the same temperature is 5 mm longer than the aluminum pipe.No. 1.(a) At what temperature (degrees Celsius) will the aluminum pipe be 15 mm longer than the steelpipe? (Assume that the coefficients of thermal expansion of aluminum and steel areaa=23x10-6/°C and as=12x10-6/°c, respectively.)(b) What is the axial stress developed in the aluminum pipe with 30 mm diameter when thetemperature was increased?5 mmAluminunSteelFigure No. 1

Answer:- The length of the ALUMINUM pipe after the change in temperature can be expressed as by the…

An aluminum pipe with a length of 60 m at a temperature of 10°C rests freely on the ground. An adjacent steel pipe at the same temperature is 5 mm longer than the aluminum pipe. (a) At what temperature (degrees Celsius) will the aluminum pipe be 15 mm longer than the steel pipe? (Assume that the coefficients of thermal expansion of aluminum and steel are No. 1. aa=23x10-6/°C and as=12x10-6/°C, respectively.)

An aluminum pipe with a length of 60 m at a temperature of 10°C rests freely on the ground. An adjacent steel pipe at the same temperature is 5 mm longer than the aluminum pipe. (a) At what temperature (degrees Celsius) will the aluminum pipe be 15 mm longer than the steel pipe? (Assume that the coefficients of thermal expansion of aluminum and steel are No. 1. aa=23x10-6/°C and as=12x10-6/°C, respectively.)

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter8: Direct Use Of Solar Energy

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

An aluminum pipe has a length of 60 m at a temperature of 10° C. An adjacent steel pipe at the same temperature is 5 mm longer than the aluminum pipe. At what temperature (degrees Celsius) will the aluminum pipe be 15 mm longer than the steel pipe? (Assume that the coefficients of thermal expansion of aluminum and steel are aAL=23x 10^-6°C and as=12x10^-6° C respectively)
A slab of concrete used in highway construction is set in place when the ambient temperature is 20.0C. If its length at that time is 20.478m, calculate the minimum gap required between concrete slabs if buckling is to be prevented. Assume the maximum temperature that will be reached is 55C. Use a = for the coefficient of thermal expansion of concrete
A steel bridge span is normally 300m long. What is the difference in length, in cm between January (-35 degree C) and August (40 degree C)? Assume coefficient of thermal expansion for steel as 11.7* 10^-6/degree.
A line measured with a 50-m long steel tape was determined to be 645.22 meter when the average temperature during taping was 15.750C. If the tape is of standard length at 200C and the coefficient of thermal expansion of steel is 0.0000116/10C, the correct length of the measured line is
A long steel I-beam used in bridge construction has a length of 15.0 m. The beam may be exposed to temperatures as low as −22°C in the winter and as high as 33°C in the summer. What is the difference in length of the beam between these two temperature extremes? (Give the absolute value of the difference. Enter your answer in mm.)
A steel tape with a coefficient of thermal expansion of 0.0000116/°C is known to be 50 m long at 20°C. The tape was used to measure a line that is 642.90 m long when the temperature was 35ºC. a) Calculate the temperature correction per tape length. b) Calculate the correction for the measured line. c) Calculate the correct length of the measured line.
A steel tape with a coefficient of linear expansion of 0.0000116/oC is know to be 50m long at 20oC. The tape was used to measure a line which was found to be 532.28 meters long when the temperature was 35oC. Determine the following:a) Temperature correction per tape length.b) Temperature correction for the measured line.c) Correct length of the line.
Derive the relation for adiabatic compressibility for ideal gas.
A steel tape with a coefficient of linear expansion of 0.0000116/1°C is known to be 75-m long at 35°C. The tape was used to measure a line which was found to be 532.28 meters long when the temperature was 48°C. Determine the following: a) Temperature correction per tape length b) Temperature correction for the measured line c) Correct length of the line
A steel tape with a coefficient of linear expansion of 0.0000116 per degree centigrade is known to be 50 m. Long at 20℃. The tape was used to measure a line which was found to be 532.28 meters long when the temperature was 35℃. Determine the following: Temperature correction per tape length. Temperature correction Corrected length of the line.
Consider a soap bubble 2mm in diameter and a droplet of water also 2mm in diameter that are falling in air. If the value of the surface tension for the film of the soap bubble is assumed to be the same as that of water, which has a greater pressure?
The length of a steel tape is increased by 0.0030 m at a temperature of 32°C. At what temperature will it be decreased by 0.0030m? The length of the tape is 50 m.